a) You are provided with a stock solution of 0.1M imidazole. Make the appropriate dilution with water to make (50mL of 0.01M imidazole in a clean conical flask. Calculate the AMOUNT of imidazole in mmol in the flask. (Note: The same conical flask can be used for all titration experiments. Just rinse with deionised water before reusing.)

a) You are provided with a stock solution of 0.1M imidazole. Make the appropriate dilution with water to make (50mL of 0.01M imidazole in a clean conical flask. Calculate the AMOUNT of imidazole in mmol in the flask. (Note: The same conical flask can be used for all titration experiments. Just rinse with deionised water before reusing.)

Macroscale and Microscale Organic Experiments

7th Edition

ISBN:9781305577190

Author:Kenneth L. Williamson, Katherine M. Masters

Publisher:Kenneth L. Williamson, Katherine M. Masters

Chapter7: Extraction

Section: Chapter Questions

Problem 1Q

See similar textbooks

Similar questions

Compute for the needed values for slution preparation: 1. Prepare the following solution quantitatively using boiled distilled water per group:250.0 mL 0.0500 M standard HCl solution from 1.0 M HCl 2. a. 500.0 mL 0.1000 M stock EDTA solutionb. 100.0 mL 0.0500 M stock Ca2+ solution
FeCl3 and MgCl2 solution was prepared by dissolving FeCl3 (AR) and MgCl2 (AR) in distilled water. Secondly, under rapid stirring, NaHCO3 powder was slowly added to the above solution to the desired basicity (B = 1) which had been proved to be the optimal B for turbidity removal. Thirdly, Na2HPO4 (AR) was added to the PFMC solution as a stabilizer ([Na2HPO4]/([Fe] + [Mg]) = 0.08). i. The the chemical equation of the Synthesis. ii How much weight need to put NaHCO3 above solution the desired basicity (B=1) iii. How much weight need to put Na2HPO4 on PFMC solution refering ([Na2HPO4]/([Fe] + [Mg]) = 0.08).
https://www.youtube.com/watch?v=jDgSohKVLio Compare the results obtained when soap solution was added to the permanent hard water treated with sodium carbonate with that obtained when it was added to the untreated permanent hard water. Compare the amount of bubbles and precipitate formed.
Please determine how to make a working standard Solution of about 0.010mg/mL. Caffeine will be the active. Diluent will be water.
Note: Part A is already sovled. The ppm values of ions are presented on a table
PLEASE USE ANOTHER SOLUTION. WRITE ALL THE PROCESS. What is the minimum distribution constant that permits removal of 99% of a solute from 50.0 mL of water with five 10.0-mL extractions with toluene?
One of the components of nutmeg is an organic compound, Trimiristin, A. To extract this compound from nutmeg why we need to choose as a solvent, ether, and not acetone?B. Is it possible to choose water as an exhaustive solvent of Trimiristin?
a) When considering the overall dialysis procedure, why is it important to exchange old/used dialysis buffer (or “dialysate” solution) with a fresh dialysis buffer solution at least once throughout the process? NOTE: Your TAs will do this for your group’s samples over the next week. b) This week’s lab utilizes a dialysis buffer with the following composition: 10 mM Tris-HCl, 10 mM MgSO4, and a pH of 7.4. Let’s presume an ERROR occurred with the creation of this buffer during the pH titration and you unknowingly titrated to a final pH of 5.0. What effects, if any, could you expect to observe on your final, dialyzed sample?
A sample is known to contain about 20% soda ash. What sample size should be taken for analysis, if it is to be dissolved into a 50 mL volumetric flask, with 10 mL aliquots analyzed, if it is desired that the analysis consume a total of 40 mL 0.10 M HCl with 10 mL of 0.10 M NaOH used in the back-titration, after boiling.
How much 1.0 M sodium bicarbonate solution (in mL) is needed to stoichiometrically react with 25 mL of 4.5% (w/v) acetic acid? Molecular weight of sodium bicarbonate = 84.007 gmol, molecular weight of acetic acid = 60.052 g/mol please provide explanation
The separation and purification processes given below and the method used against them are given. Which or which of these pairings are correct? I. Brewing of tea - ExtractionII. Purification of water impurities - ChromatographyIII. Separating olive pomace from olive oil while producing olive oil-DecantationIV.Petroleum fractions obtaining - Ordinary distillationV. Obtaining essential oils and using them in perfume making - Water-steam distillationA. I, II, III, IVB. I, II, III, IV, VC. I, IV, VD. I, II, III, VE. I, II, V
A student was careful to make and stir all of her standard solutions immediately before measuring their turbidity for her calibration curve. However, she let her tap water solutions sit for 10 minutes prior to measuring their turbidity. If she measured the top portion of the solution, would her experimental sulfate ion concentration be higher or lower than it should be?