Partition A. Determine the reactions for typical interior joist in the floor framing system that support the partition wall as shown in the figure. a 24 in. B. Draw the moment and shear diagram L=16 ft. • Assume partition is 8 ft. high • Joists are 24 inch. on centers Weight is 40 lb./ft? L/3 2L/3

Partition A. Determine the reactions for typical interior joist in the floor framing system that support the partition wall as shown in the figure. a 24 in. B. Draw the moment and shear diagram L=16 ft. • Assume partition is 8 ft. high • Joists are 24 inch. on centers Weight is 40 lb./ft? L/3 2L/3

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Determine the tension at AC. A. 55.23 kN B. 52.53 kN C. 32.55 kN D. 25.35 kN
The shown in the figure is to be analyzed using cantilever method. Which of the following: 1. most nearly gives the axial force in member DE? A. 22.50 kN B. 37.50 kN C. 30.00 kN D. 7.50 kN 2. most nearly gives the moment at A? A. 150 kNm B. 30 kNm C. 120 kNm D. 90 kNm 3. most nearly gives the shear on member BE? A. 20.00 kN B. 10.00 kN C. 7.50 kN D. Other:_____
Determine the magnitude of the pin force at C given θ = 18° and P = 57 lbs.
Determine the vertical and horizontal displace-ments at A of the pin-connected structure in Figure P9.31.Given: E = 200 GPa and A = 500 mm2for all members.
(a) in terms of L (length) and w (kN/m) , find the restraining moment at each wall. (b) compute end moments and shear reactions at supports if L=8m and w= 20 kN/m
Compute moment (kN-m) at support D.
The wall crane supports a load of 700 Determine the horizontal and vertical components of reaction at the pins at A and D. Also, what is the force in the cable at the winch W?
9.Calculate the shear at right end of span BC in kN.0
From the given truss , compute the force in member CE. a.187.5 N (C) b.62.5 N (C) c.62.5 N (T) d.37.5 N (C
A steel bar having cross-sectional areaA=1200mm2 is compressed by an axial loadP=53 kN.Determine the average normal and shear stressesacting on aninclined sectionaa cut through the bar at angleα=250.(Point K is a fixed support) A=5, B=3, C=8
In the beam shown, taking W1 = 3 kN/m, P1 = 7 kN, P2 = 4 kN, and W2 = 7 kN/m.c) Determine the shear at "C" d) Determine the shear at "F"
Using portal method, Calculate for the shear force in kN at member FC a = 12.6 kN, b = 27.2 kN, c = 3.5 m, d = 5.0 m, e = 5.4 m