a.) If the percent grade is 7.25 % and the horizontal length of grade is 1625 feet, what is the change in elevation? b.) Given a manhole with the outlet invert elevation of 2605. A run of 48 inch pipe connects to the next manhole at an invert elevation of 2610. What is the distance between manholes if the correct pipe grade is 3%?

a.) If the percent grade is 7.25 % and the horizontal length of grade is 1625 feet, what is the change in elevation? b.) Given a manhole with the outlet invert elevation of 2605. A run of 48 inch pipe connects to the next manhole at an invert elevation of 2610. What is the distance between manholes if the correct pipe grade is 3%?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A trapezoidal channel having side slope (1:1) it is required to discharge 1.478 m3/sec of water per each square meter of channel area, bed slope (1 to 1000). If this channel is unlined and the value of C=44 and when this channel is lined with concrete the value C=60. The cost per cubic meter of excavation is four times the cost per square meter of lining. The channel is to be the most efficient one find whether the lined channel or the unlined channel will be cheaper what will be the dimensions of the economical channel
This wood flume has a slope of 0.0015. What will be the discharge of water in it for a depth of 1 m2 Try to use all the open channel formulas and make the necessary, assumptions for the roughness coefficients.
HIGHWAY ENGINEERING A grade of -4.1% grade intersects a grade of +2.8% at Station 11 + 588.00 of elevations 20.80 meters. These two center grade lines are to be connected by a 250-meter vertical parabolic curve. Complete solution please so I can understand step by step. A. At what station is the cross-drainage pipes be situated? B. If the overall outside dimensions of the reinforced concrete pipe to be installed is 90 cm, and the top of the culvert is 30 cm below the subgrade, what will be the invert elevation at the center? C. A descending grade of 6% and an ascending grade of 2% intersect at Sta 12 + 200 km whose elevation is at 14.375 m. The two grades are to be connected by a parabolic curve, 160 m long. Find the elevation of the first quarter point on the curve. D. A highway engineer must stake a symmetrical vertical curve where an entering grade of +0.80% meets an existing grade of -0.40% at station 10 + 100 which has an elevation of 140.36 m. If the maximum allowable change in…
Provide solutions and sketches. On a railroad, a -8% grade meets a +0.40% grade at station 2 + 700m whose elevation is 30.00m above datum. The maximum allowable change in grade per section having a length of 20m is 0.15. It is desired to place a culvert pipe to drain the flood waters during heavy downpour. a. At what station will the culvert pipe will be installed?b. At what elevation must the invert of the pipe be laid if the pipe has a diameter of 0.90m and the backfill is 0.30m deep?
If the overall outside answer of the reinforced concrete pipe to be installed is 95 cm, and the top of the culvert is 30 cm below the subgrade, what will be the invert elevation at the center?
On a railroad a -8% grade meets a +4% grade at station 2+700 whose elevation of 30.00 m. The maximum allowable change in grade per station having a length of 20 m. is 0.15. It is desired to place a culvert to drain the flood waters during heavy downpour. At what elevation must the invert of the culvert be set if the pipe has a diameter of 0.9m. and the backfill is 0.30 m. high? Neglect the thickness of the pipe. with illustration
Answer with complete diagram/fbd 1. Determine the depth in m of the economical trapezoidal brick lined channel having a discharge of 1.2 cum/sec with a slope of 0.008. n= 0.015. 2. Determine area in sqm of the economical trapezoidal brick lined channel having a discharge of 1.2 cum/sec with a slope of 0.008. n= 0.015.
A rectangular channel of best hydraulic cross-section, n = 0.016, is laid on a slope of 0.0064 and carries 98 m³/ s. For critical conditions, what with is required?
A trapezoidal canal has one side vertical and the other sloping 1:1. The discharge is known to be 20 m³/s at a mean velocity of 1.2 m/s. If the slope is to be minimum as possible, and n=0.015, (a) At what depth is it flowing in m? (b)What is the value of this minimum slope? Please answer this immediately. Thank you!
A circular finished concrete culvert is to carry a discharge of 50 cfs on a slope of 0.0010. It is to flow not more than half full. The culvert pipes are available from the manufacturer with diameters that are multiples of 1 ft. Determine the smallest suitable culvert diameter. [Answer in units of ft]
box the final answer asap On a railroad a -0.8% grade meters at 0.4% grade station 2+700 whose elevation of 300 m. The maximum allowable change in grade per station having a length of 20m. is 0.12. a. Compute the length of cuve. b. Compute the stationing where a culvert be located. c. At what elevation must tge invert of the culvert be set if the pipe has a diameter of 0.9m. and the backfill is 0.3m depth. Neglect thickness of pipe.
An earth canal(smoothest) is in good condition with side slope of 1 ½ horizontal to 1 vertical carries 600cfs at a velocity of 2.5ft/sec. if the bottom width is twice the depth, determine the grade of the channel.