QUESTION 7An 120 V AC circuit has 100 Q of resistance, 75 Q of inductive reactance (X ), and 25 Q of capacitive reactance (XC). Answer the following:A. The total impedance (Z) of this circuit isohms. (Round your answer to one decimal place.)B. The total current flow in this circuit is -26.6amps. (Round your answer to one decimal place.)C. The power factor in this circuit is 0.89. (Round your answer to two decimal places.)degree lagging(leading or lagging) phase angle. (Round degrees to one decimal plaD. This circuit has a 26.6Click Save and Submit to save and submit. Click Save All Answers to save all answers.Type here to searchPrF7F6DIIF3F5F4F2&

Answered: A. The total impedance (Z) of this…

Engineering

Electrical Engineering

A. The total impedance (Z) of this circuit is ohms. (Round your answer to one decimal place.)

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.61P

See similar textbooks

Related questions

Q: Complete the sentence The power factor must be close to will be reduced To insure that losses in the…

A: Power factor is the ratio of Real power(kW) to apparent power(kVA). It can also be defined as the…

Q: A clothes dryer rated at 6kW is connected to a 120/240 V, single-phase, three-wire, individual…

Q: T or F, modify the wrong part if False, please underline twice your answer if True or False. At…

A: FALSE The given statement is false Efficiency is defined as the ratio of output to input output =…

Q: Which of the following statement is wrong for the outdoor substations? O For voltages below 33 KV O…

A: The voltage ratings of outdoor substations usually lies between 55KV to 765KV .

Q: circuit breaker

A: Circuit Breaker A circuit breaker is basically an electrical switch that opens when there is an…

Q: Pressure Coil of wattmeter should be connected in series with the Line Select one: O True False

A: According to the question we have to discuss about the pressure coil of wattmeter.

Q: The stator winding insulation resistance of a 100 hp, 460 V motor was measured at 10 MΩ when sitting…

A: Given Motor of 100 hp,460 vStator winding insulation resistance at 20° C is R20°C=10 MΩ

Q: A- Discuss the following arguments: 1- Smart meters play an important role in smart grids.

A: 1-Smart meters play an important role in smart grids because it- It will help to reduce theft…

Q: substation is supplying 200 kVA and 150 kvar. Calculate the corresponding power and power factor.

Q: The resistor of 6-ohms and unknown impedance coil in series draws 12A from a 120 volts, 60hz line.…

Q: 1/The Nominal System Voltage is stepped-up at the Generating Station in preparation for the Power to…

A: In this answer let us try to understand whether the given statement is true or false.

Q: The no-load current of a 75KW, 4000V, 3-phase, 900rpm, 60HZ indı

Q: A manufacturing company has privately contracted your company to rewire the mechanical workshop in…

A: Primary voltage VP is 400 V, f= 60 Hz start connected three phase supply from the utility.…

Q: A transmission line connecting Ibra and Sur carries 33kV and 3000A. The substation concerned is…

A: The transformer has a primary and a secondary side. It converts electrical power to electrical power…

Q: You have been privately contacted to rewire a site. During a visit, you observed that the building…

A: Given:The building receives a 400 V, 60 HzThe three-phase equipments require a 230V three-phase…

Q: Which of the following cannot be used as a base load power plant? O a. Nuclear O b. Wind O c.…

A: A power plant who is responsible for base load power, needs to be able to run continuously and…

Q: Explain the following items i) Steps used to draw the equivalent impedance diagram of the network

A: Dear student as per our guidelines we are supposed to solve only one question.kindly repost other…

Q: an overhead transmission line has a span of 220 meters the conductor waiting 0.604 kg/m.What will be…

A: Given: Span, L=220 m Weight of conductor, w=0.604 kg/m Tension, T=2879 kg

Q: When an impedance coil is connected to a 114 volt 60 cps source, the current is 3 A. If the current…

A: Let inductance =L resistance=R hence impedance of coil=R+jωL

Q: Draw (132 KV) Overhead Transmission Tower with all engineering details.

A: Overhead Transmission Tower The power system consists of three main parts. Generation, Transmission,…

Q: Draw a 66KV Overhead Transmission Tower with all engineering details.

Q: Choose the correct answer: Transmission lines transmit power at the level of generation voltage.…

A: For same power transfer, High voltage transmission has less transmission losses than low voltage…

Q: 3) A resistor, in series with a 138µf capacitor is connected to a 60cycle source. If the voltage…

Q: CITE SOME OF THE REQUIREMENTS TO FEED THIS GENERATED ELECTRICITY TO THE TRANSMISSION LINES.

A: The answer as given below steps:

Q: Determine the nodal voltages for the networks in Figure? ane 1₁ = 3A 40° 000 501 40 20 1₂ = 5A230

Q: 2. Next your mentor asks you to characterize a microstrip transmission line. It is fabricated on…

A: A microstrip transmission line is fabricated on 1.57 mm thick FR-4 material (εr=4.6). We need to…

Q: • AIn a 3 units suspension insulator, the voltage across the top and middle units are 30% and 32 %…

Q: 1. With an elegant diagram, discuss the three-phase power measurement using the three-watt meter…

A: This is a very simple question based on measurement subject .In this we will understand how the…

Q: b. Find the current I, e. Draw the power triangle. d. Find the type of elements and their impedance…

Q: 39. The impedance of a transmission line is 30 ohm. What is the per unit impedance of 115 kv and 100…

A: It is given that: Actual Impedance=Zactual=30 ΩActual Voltage=V=115 KV=115×103 VBase Power=Sb=100…

Q: a) For the AC circuit shown in Figure 4a, find the expression for the instantaneous power supplied…

A: Since you have posted the multiple questions so we are supposed to answer 1st only.

Q: The capacitance per kilometre of a 3-phase belted cable is 0.18 µF between two cores with the third…

Q: Supposed a three-phase transmission

Q: Referring to the Figure 1 below, given the value of frequency, f =50 Hz Determine: - i) The phasor…

Q: An equipment has a per unit impedance of 0.8 on a base of 50 MVA, 66KV. The actual value of…

A: Given an equipment has, Per unit impedance, Zpu=0.8 pu Base MVA, Sbase=50 MVA Base voltage, Vbase=66…

Q: A 5.4-kva, 240-volt electric clothes dryer will contribute ______ amperes to the neutral load, when…

Q: Question 3: ) Identify the type of circuit shown and justify your answer. i) Establish the line…

A: The solution can be achieved as follows.

Q: A bank of three 42:1 single phase transformer connected in wye-delta is used to step down the HV…

Q: A 300-watt, 220-volt lamp and a inductance of 100 mH are connected in parallel. If a 220-volt, 60 Hz…

A: Given that; Voltage Supply=220voltsfrequency f=60 Hzinductance L=100 mHFor lamp P=300 wattV=220…

Q: raw (400KV) Overhead Transmission Towers with all engineering details.

A: (400KV) Overhead Transmission Towers

Q: A dc transmission facility is modeled by the approximate series circuit shown below. If the load…

A: By ohms law Current in resistor R = Voltage across resistorResistance. Power loss in resistor R = (…

Q: The percent values of the voltage, current, impedance, and volt-amperes for a given power system are…

Q: Explain why draw a typical equivalent 3phase system. we have impedance in the transmission lines…

A: The three phase load which can be balanced or unbalanced if the three loads impedances Z1,Z2 and Z3…

Q: What are the factors which governs the performance of transmission line? Subject Power Transmission…

A: The main performance metrics of transmission lines are -

Q: A manufacturing company has privately contracted your company to rewire the mechanical workshop in…

A: Given:The building receives a 400 V, 60 HzThe three-phase equipments require a 230V three-phase…

Q: A transmission line connecting Ibra and Sur carries 33kV and 300OA. The substation concerned is…

A: What is the rating of the number of turns of primary and secondary side winding of PT.

Q: A single-phase 60 miles 69kV transmission line consist of two 000-AWG solid copper conductors spaced…

A: According to question: Circuit diagram: The capacitance of the line is calculated as…

Q: Remaining Time: 28 minutes, 24 seconds. A Questiqa Completion Status: 10 L> A Moving to another…

Q: 2.A coil takes 30 A at 0.84 lagging power factor when connected to a 250 V, 60 Hz supply. Determine…

A: The solution is given below

Q: If R=10 ohms and L=0.05 henry are connected in series and energized by a 25 cycle sinusoidal…

A: Impedance = R +j(2×pi×frequency×inductance). Current in impedance Z = (voltage across impedance)…

Question

Expert Solution

Step 1

Given AC circuit data

V = 120 V

R = 100 Ohms

$X_{L}$ = 75 Ohms

$X_{C}$ = 25 Ohms

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Please show you detailed solution Number 10 A voltage of 250 volts at 50 Hz is impressed on a circuit having a 60-ohm resistor, 35-?F capacitor, and a 0.25-henry inductor in series. Determine power factor. A. 0.979 C. 0.924 B. 0.862 D. 0.707
For figure (1)draw and calculate the voltages waveform across each half of secondary winding and across load when 100sin2π60t applied across the primary, then find PIV.
If T = 0.6Z – 60° and A = 48cm find the position of the first voltage minimum on the line. Select one: O a. The first voltage minimum is at 2cm from the load. O b. The first voltage minimum is at 72cm from the load. O c. The first voltage minimum is at 8cm from the load. O d. The first voltage minimum is at –4cm from the load. O e. The first voltage minimum is at 20cm from the load. O f. The first voltage minimum is at 32cm from the load. O g. The first voltage minimum is at 44cm from the load. O h. The first voltage minimum is at 24cm from the load.
An inductor and resistor are connected in parallel to a 120-V, 60-Hz line. The resistor has a resistance of 50 ohms, and the inductor has an inductance of 0.2 H. How many degrees out of phase are the current and voltage?
Question 1.) Fill in the blanks with proper wording a.) For a purely resistive circuit, the voltage and current phasors are b.) For a purely inductive circuit, the voltage and current phasors are c.) For a purely capacitive circuit, the voltage and current phasors are
Determine the currents IA to ID, branch currents I1 to I6 and their direction.
What's the rise time for this system with its closed-loop poles as shown? 14 -6 -4 12 -j6 Select one: a. 0.607 sec b. 3.14 sec C. 1.80 sec d. 0.254 seC e. 0.554 sec
What will be the value of the twiddle factor: W42
a. individal current b. voltage source
Q3) In the Anderson Bridge for the measurement of inductance, drive the equations of balance for the unknown impedance L1 and R1. 111 R3 R1, L1, Head Phones A ww E
conclusion and observation in Kirchhoff's Current Law and Kirchhoff's Voltage Law
If a circuit has a resistance of 3002 and a series inductance of 5002, what is the relationship between the applied circuit voltage and the circuit current? The applied voltage lags the circuit current. The phase shift between the circuit voltage and current changes with time. The applied voltage is in phase with the circuit current. The applied voltage leads the circuit cur Previous Page Next Page Page 2 of 10