A transmission line connecting Ibra and Sur carries 33kV and 3000A. The substation concerned is installed with a setup of PT and a small range Voltmeter of (0-300V) to measure the voltage. Then, the actual voltage drawn carried by the line when ammeter reads a voltage of 230V is calculated as, a. 25300 V b. 27500 V C. 15500 V d. 16500 V

A transmission line connecting Ibra and Sur carries 33kV and 3000A. The substation concerned is installed with a setup of PT and a small range Voltmeter of (0-300V) to measure the voltage. Then, the actual voltage drawn carried by the line when ammeter reads a voltage of 230V is calculated as, a. 25300 V b. 27500 V C. 15500 V d. 16500 V

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.26P: A small manufacturing plant is located 2 km down a transmission line, which has a series reactance...

See similar textbooks

Similar questions

A dc transmission facility is modeled by the approximate series circuit shown below. If the load voltage is known to be Vload= 458.3 kilovolt (kV) what is the power loss in the line in megawatt (MW)?
Estimate the distance over which a load of 15000 kW at 0·85 p.f. can be delivered by a 3-phase transmission line having conductors of steel-cored aluminum each of resistance 0·905 Ω/phase per kilometer. The voltage at the receiving end is to be 132 kV and the loss in transmission is to be 7·5% of the load.
a 12500kva load is supplied at a power facter of 0.8 lagging by a 3 phase transmissiom line whose voltage is to be maintained at 33kv at both ends. Determine the capacity of the synchronous condenser to be installed given that the line resistance and reactance per phase are 5 ohms and 13 ohms respectively
A transmission line of 50 ohm characteristic impedance is terminated with a load of 200 ohm resistance. What will be the value of the minimum impedance measured on the line?
A high-voltage direct-current (dc) transmission line between Celilo,Oregon, and Sylmar, California, is operating at 800 kV and carrying1800 A, as shown. Calculate the power (in megawatts) at the Oregonend of the line and state the direction of power flow.
a short three phase transmission line connected to 33kv 50 hertz generating station at starting and is required to supply a load of 10 MW at pointed start lagging power factor at 30 KV addresses in that is the minimum transmission efficiency is to be determined96% estimate the per face value of resistance and inductance of a line
1/In the Transmission Line Simulator, the Transmission Line is connected in Nominal-Pi Circuit. Select one: True False
A short 3 phase transmission line, connected to a 33kV, 50 Hz generating station at the sending end is required to supply a load of 10Megawatts at 0.8 power factor lagging, 30kV at the receiving end. If the minimum transmission line efficiency is to be limited to 96%, estimate the per phase values of resistance and inductance of the line.
A short 3-phase transmission line connected to a 33kV, 50 Hz generatingstation at the sending end is required to supply a load of 10 MW at 0·8lagging power factor at 30 kV at the receiving end. If the minimumtransmission efficiency is to be limited to 96%, estimate the per phasevalue of resistance and inductance of the line.
In the power system whose single line diagram is shown below, the line cross section is 95 mm2, the intrinsic conductivity coefficient is 34m/ohm.mm2 and the inductive reactance of the line is given as 0.4 ohm/km. According to these values; a) Calculate the active, reactive and visible components of the currents passing through each line segment.b) Find the location and value of the largest voltage drop.
A short 3-phase transmission line connected to a 33kV, 50 Hz generating station at the sending end is required to supply a load of 10 MW at 0.8 lagging power factor at 30 kV at the receiving end. If the minimum transmission efficiency is to be limited to 96%, estimate the per phase value of resistance and inductance of the line.
The annual load duration curve of a power supply system may be considered as straight line from 40 MW to 8 MW. The load factor of the system is ?