An inductor and resistor are connected in parallel to a 120-V, 60-Hz line. The resistor has a resistance of 50 ohms, and the inductor has an inductance of 0.2 H. How many degrees out of phase are the current and voltage?

An inductor and resistor are connected in parallel to a 120-V, 60-Hz line. The resistor has a resistance of 50 ohms, and the inductor has an inductance of 0.2 H. How many degrees out of phase are the current and voltage?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter24: Resistive-inductive-capacitive Parallel Circuits

Section: Chapter Questions

Problem 1PP: The circuit in Figure 24-2 is connected to a 120-V, 60-Hz line. The resistor has a resistance of 36...

See similar textbooks

Related questions

Q: Exercise 2: Resistances connected in Series-Parallel across a Sinusoidal AC Supply Calculate the…

A: In the circuit, pure Resistances connected in Series-Parallel across a Sinusoidal AC Supply We are…

Q: resistor of 20Ω, an inductor of 0.012H, and a capacitor of 90 μF are connected in series with a…

A: In this question we will find phase between v and I in series RLC circuit..

Q: If the Vt = 230240°, determine the equivalent impedance submission bin "Solution" after the exam. In…

Q: Discuss Fully the various methods available for transforming 3-phase voltages to higher or lower…

A: Different methods available for transforming 3-phase voltages to higher or lower 3-phase voltages at…

Q: 3. Perfect resistor of resistance R=42, a perfect capacitor of reactance Xc=992 and a perfect coil…

Q: Q20. The section bus-bars A and B as shown in Figure B5 are linked by a bus-bar reactors each rated…

A: The performance of a power system depends mainly on the performance of transmission lines in the…

Q: 2. What are the differences between MATLAB functions (i) round and floor? (ii) mod and rem (iii)…

A: (i) Round Floor The function of round is used to rounds the number up rely on 2nd argument…

Q: explain the operating principle of single phase 2S-2P PMSM based on 3D design illustration.

A: According to the question, explain the operating principle of single-phase 2S-2P PMSM based on 3D…

Q: For the circuit below, determine the circulating current and the voltages across each component.…

A: In this question, determine the circulating current and the voltages across each component. Draw a…

Q: 3. Find the characteristic frequencies of the coupled electric circuits of the figure below.…

A: The circuit diagram is shown below,

Q: series RC circuit with R=4k ohms and C= 0.40 mF is connected to an AC voltage source e(t)= 100…

A: In this question we will find overall power factor and voltage drop across impedance...

Q: An AC system with the frequency of 60hz is composed of 2 relays with 20 ohms resistance and 0.16…

Q: 1) Referring to the circuit as in Figure 1, transform the circuit in phasor domain representation.…

A: In this question, We need to represent the circuit in the phasor domain and 2. determine the value…

Q: Q2. The single-line diagram of a simple three-bi is shown in Figure-2. Each generator is repres-…

A: the single line diagram of a simple three bus power system is shown. Each generator represent by an…

Q: The waveforms below represent one full cycle of the applied voltage vs and the supply current is.…

A: We can tell phase nature of waveforms by observing their peak positions with respect to time.

Q: Q6.Using Kirchhoff's current law, find the values of the unknown currents in Figure .below

A: There are two Kirchhoff's law, known as Kirchhoff's voltage law (KVL) and Kirchhoff's current law…

Q: 15 A of current is taken by a non-inductive load at 125 V. In order that the same current shall be…

Q: What is the difference between load and delta?

A: Delta is a type of connection in which we connect the load or source on delta .

Q: An AC voltage of 230 v is applied to a circuit consisting of a resistance of 10 ohms in series with…

Q: A resistor and capacitor are connected in parallel to a 277-V, 60-Hz power source. The resistor has…

Q: Manufacturers usually specify the impedances of machines and transformers in O Percent O Per-unit O…

A: Need to Find correct option

Q: Each phase of a wye-connected load consists of a 50-Ω resistance in parallel with a 100-μF…

A: Given data: The frequency of operation is 60 Hz The value of resistance is: 50 Ω The value of…

Q: 11. What is the name of this circuit given below? (LSB). A (MSB)

A: As per BARTLEBY GUIDELINES, I answered one question (Q-11) and repost other question separately.…

Q: When connected in series with a pure resistor R with resistance r and inductance L, three pairs of…

Q: If a 50 ohm quarter-wave impedance converter is used to match a 60 ohm transmission line to an…

Q: what will be the total and unit for impedance if the given is 8mA and 9mV?

A: Electrical impedance is the amount of opposition that a circuit presents to current or voltage…

Q: 2. Refer to the Figure 2. a) Determine the total impedance of the circuit in polar form. b)…

A: Given

Q: Reactive Power Compensation Regulation, capacitive reactive power should not exceed what percent of…

A: Reactive Power Compensation Since the major load in power systems is an inductive load that…

Q: The inductance effect is predominant in underground cables than overhead lines. Select one: True…

A: In this question we have to define inductance effect in cable...

Q: A two-wire DC splitter of 1Km length and resistance of each conductor (m/00030.0) and feeds the…

Q: find the following : a) the peak voltage Vp b) the Peak to bottom Vpp c) the Time period d)…

Q: system will not have comparison element . a. Open loop b. Dynamic С. Closed loop d. Static

A: Given .................system will not have comparison element.

Q: Construct a graph to represent the recurring nature of partial discharge pulse sequences under…

A: In general principle, Partial Discharge happens in zones of the protection or on the outside of the…

Q: load is connected across a 25,000 Volts, 60 Hz source and draws a current of 90 A rms. If the power…

Q: Question - Compare the effect of varying resistance, capacitance and inductance in a pararllel and…

A: In this question Compare the effect of varying resistance, capacitance and inductance in a…

Q: Figure 3P.2 shows two capacitor banks, C, and C2, in a substatior C is enercized, but C, is…

A: The circuit diagram with two capacitor banks C1 and C2 is shown below, Where the capacitor C1 is…

Q: When it is connected in series with a pure resistor R with resistance r and inductance L, the…

A: Given Pure resistor R is connected in series with resistance r and inductance LSinusoidal voltage…

Q: The cosine angle between the voltage and current in an AC circuit is known as power factor. With aid…

A: The cosine angle between the voltage and current in an AC circuit is known as power factor. With aid…

Q: 60 hz voltage of 220 volts from a convenience outlet is impressed on a capacitance of 800 pF.…

A: Given capacitor of capacitance 800 pF is connected across 220 volts rms source. capacitive reactance…

Q: A. In a series circuit, if the AC voltage is measured across the AC voltage source, will there be…

Q: For the ac network of Figure Q5, calculate the following; i. The total impedance; ii. The inductance…

Q: Is there a difference between the phase windings resistances, if so, what does it mean? Please…

A: Insulation Resistance: For the electrical protection part, a protection opposition (IR) instrument…

Q: With the help of mathematical expression and wave forms prove the following. a. V and I are in the…

Q: Generate a conclusion on this following statements: Determine and analyze the voltage regulation…

A: GIVEN: resistive load inductive load capacitive load DETERMINE: the…

Q: An impedance coil, in series with a resistor takes a current of 3A when connected to a 120V AC…

Q: he picture shows three LC circuits, two of them with capacitors of capacitance C and the three with…

Q: coil and capacitor are in parallel, with jBL = j0.05 and jBC = j0.03. What is the admittance vector,…

Q: An inductor with an inductance of 3.6H is connected to a 480 Volts 60-Hz line. How much current will…

A: As per Bartleby guidelines we are allowed to solve only one question please ask the rest again. I…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Given

VIEW

Solving the parallel circuit

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
What is the power factor of the circuit in Question 6?
You are an electrician working in an industrial plant. A 30-hp three-phase induction motor has a current draw of 36 amperes at full load. The motor is connected to a 480-volt line. A three-phase wattmeter indicates a true power of 22 kW. Determine the power factor of the motor and the amount of capacitance needed to correct the power factor to 95. Also determine the minimum voltage rating of the capacitors. The capacitors are to be connected in wye.
A pure capacitive circuit is connected to a 480-volt, 60-Hz power source. An ammeter indicates a current flow of 24 amperes. The circuit current must be reduced to 16 amperes by connecting a second capacitor in series with the first. What is the value of the existing capacitor? What value capacitor should be connected in series with the original capacitor to limit the circuit current to 16 amperes?
The circuit in Figure 24-2 is connected to a 120-V, 60-Hz line. The resistor has a resistance of 36 , the inductor has an inductive reactance of 40 , and the capacitor has a capacitive reactance of 50 . ET120VITZVAPFERIRR36PELILXL40VARsLLECICXC50VARsCC
What is the minimum AC voltage rating of each capacitor in Question 11?