58 Sun, Nov 27 DAABC ADEC. 21 and 22 have the same measure. Find DCand DE. (Hint: Let DC = x and AC = x + 9. Use the figure shownto the right.)DC is unit(s) long.(Round to the nearest tenth as needed.)XD9A30(227E18AB5G. 38%

Please see the below picture for detailed solution.

Answered: AABC ADEC. 21 and 22 have the same…

Mathematics For Machine Technology

8th Edition

ISBN:9781337798310

Author:Peterson, John.

Publisher:Peterson, John.

Chapter73: Achievement Review—section Seven

Section: Chapter Questions

Problem 38AR: Solve the following applied right triangle exercises. Compute linear values to 3 decimal places,...

See similar textbooks

Similar questions

The length, L, of the point on any standard 82° included angle drill can be calculated using the formula L = 0.575 , where represents the diameter of the drill. Determine the lengths of the following drill points with the given diameters. Round to 3 decimal places for inches and 1 decimal place for millimeters. a. 12 b. 14 c. 38 d. 10 mm e. 25 mm f. 45 mm
Solve the following applied right triangle exercises. Compute linear values to 3 decimal places, customary unit angles to the nearer minute, and metric angles to the nearer hundredth degree. Determine y. All dimensions are in millimeters.
Solve the following applied right triangle exercises. Compute linear values to 3 decimal places, customary unit angles to the nearer minute, and metric angles to the nearer hundredth degree. All dimensions are in millimeters. a. Determine A. a. Determine distance x.
Solve the following applied right triangle exercises. Compute linear values to 3 decimal places, customary unit angles to the nearer minute, and metric angles to the nearer hundredth degree. Determine check dimension y. All dimensions are in inches.
Solve the following applied right triangle exercises. Compute linear values to 3 decimal places, customary unit angles to the nearer minute, and metric angles to the nearer hundredth degree. Determine x. All dimensions are in inches.
Refer to the Decimal-Inch Spur Gears Table under the heading "Gearing-Diametral Pitch System" earlier in this unit.The formula in terms of the unknown is not given. Choose the formula that consists of the given parts, rearrange in terms of the unknown, and solve.
Solve the following applied right triangle exercises. Compute linear values to 3 decimal places, customary unit angles to the nearer minute, and metric angles to the nearer hundredth degree. Determine dimension d. All dimensions are in inches.
Solve the following applied right triangle exercises. Compute linear values to 3 decimal places, customary unit angles to the nearer minute, and metric angles to the nearer hundredth degree. All dimensions are in inches. a. Determine dimension c. b. Determine dimension d.

Recommended textbooks for you

Mathematics For Machine Technology

Advanced Math

ISBN:

9781337798310

Author:

Peterson, John.

Publisher:

Cengage Learning,

Algebra & Trigonometry with Analytic Geometry

Algebra

ISBN:

9781133382119

Author:

Swokowski

Publisher:

Cengage

Mathematics For Machine Technology

Advanced Math

ISBN:

9781337798310

Author:

Peterson, John.

Publisher:

Cengage Learning,

Algebra & Trigonometry with Analytic Geometry

Algebra

ISBN:

9781133382119

Author:

Swokowski

Publisher:

Cengage

SEE MORE TEXTBOOKS

AABC ADEC. 21 and 22 have the same measure. Find DC and DE. (Hint: Let DC = x and AC = x +9. Use the figure shown to the right.) 2 DC is unit(s) long. (Round to the nearest tenth as needed.) *** D 9 A 30 2 2 E 18 B