Answered: AC Power Analysis 14.15 Determine the…

AC Power Analysis 14.15 Determine the maximum power transferred to Z, in the circuit shown in Figure 14-31. 6 0 j80 Ix +. ZL 220° A rms 2 Ix FIGURE 14-31: Circuit schematic for problem 14.15.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter14: Power Distribution

Section: Chapter Questions

Problem 14.16P

See similar textbooks

Related questions

Q: R1 R2 D Y1 Y2 D B1 B2 Figure 2 a) Derive the expression of capacitance and inductance per phase per…

A: We need to drive the expression of capacitance and inductance per phase metre of above given line…

Q: A single phase circuit with a given load 3 ohm resistance and inductive reactance of 4 ohms as…

A: The question is about active power, reactive power and apparent power, power factor.

Q: Determine the load currents at 2 0, 14 N, 4 N and 100 Q using Superposition theorem. 2ng 15A 59

Q: Problem 3.1: Determine the rms value of voltage induced in an 80-turn coil on a 30 cm × 25 cm…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: Q) A 50 0 lossiess transmission line is terminated by a load of impedance Zi. The VSWR on the line…

A: We come to know that there exist a minimum at the load end hence reflection coefficient must be…

Q: Q4/ /A/ A 3-phase, Shp, 208V, 4-pole, 60H IMbjected to no load test at 60HZ and short circuit at…

Q: Gauss-Elimination Method [Q1] Using Nodal or Loop Analysis, determine the currents I1, I2, and Iz…

A: Since there are multiple questions present and you have not specified which question to answer,…

Q: three conductors of a three-phase line are arranged at the corners of a triangle of sides 1.3m, 3 m,…

A: In this question we will find capacitance per phase...

Q: 18. The reflection coefficient for the I transmission line shown in figure at P is Transmission line…

A: In the question, What is value of reflection coefficient of the given transmission line.

Q: 1. Solve for the loop currents 1,12 & 13. (a) what are the loop current equations. (b) use Cramer's…

A: Please refer the attached images for the complete answer..

Q: Q2/The Double circuit 3-phase overhead transmission line has spacing as shown in the figure below.…

A: In this power system, Find the value of inductance L in per km We know inductance L= 2×10-7…

Q: 5) Choose the correct answer with the explain: a) The maximum power transferred to the load is…

A: As per the guidelines of Bartley we supposed to answer first three subpart only.

Q: A three phase system with one conductor per phase as shown in the figure. The conductors are…

Q: 14.13 Find the value of the impedance Z, for maximum power transfer in the circuit shown in Figure…

A: ZTh is the equivalent impedance when all independent sources are turned off. i.e for current source,…

Q: A star connected 3 phase wound field synchronous generator (Xs=4 N) operates with a 15 kV Excitation…

Q: By using Gauss-Siedal method, the voltage of the bus 2 after two iteration is Your answer By using…

A: Given,The data of a system are,Ybus=j0.25-0.2-0.05-0.20.225-0.025-0.05-0.0250.075…

Q: Expression for a voltage reflection co-efficient in terms of load impedance and characteristics…

A: The voltage reflection coefficient of a transmission line depends on two parameters: 1. The load…

Q: A three-phase transposed line is composed of three conductor bundle. The conductors have a diameter…

A: Given A three phase transposed line with its parameters.we need to determine Geometrical mean…

Q: Compare between load curve and duration load curve.

A: The explanation is as follows.

Q: eq V 12 10-"(0-5 + 2 log, Deq{r") -7 -- Inductance/phase/m %3D Inductance per conductor per metre =…

Q: mcq single-phase unidirectional AC chopper is fully controller chopper Semi controller chopper…

A: Half wave controlled rectifier are unidirectional AC coplper.

Q: Derive the magnetic flux density equation for five-phase induction, by using the same method to…

A: Five phases induction motor consisting of 5 phases each phase is separated by 72o (i.e. 360/5)

Q: What is the value of the equivelent impedance?

A: first find the equivalent value of the parallel branch and then find the equivalent impedance by…

Q: Induction motors and power factor correction capacitor banks are examples of nonlinear loads. True…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: Only three iteration using Gauss-Seidel Method in part 2. Please show complete process. Consider the…

A: 1) Base power Sb=100MVA Base voltage at A Vb,A=132×13.2132…

Q: 1. Solve for the loop currents I1,12 & 13. (a) what are the loop current equations (b) use Cramer's…

A: given here a circuit and asked to write the loop current equation. and by using crammers rule and…

Q: In the system shown below, the generator is ideal (Xs = 0) and the magnitude of the load bus…

Q: 14.20 A load consists of a resistance connected in parallel with a capacitive reactance is taking 20…

Q: The phase angle between magnetizing component current and core loss component current is 90° Select…

Q: Can you explain the theory behind why the inductor in phase R and phase B become in series when…

A: As, the given circuit is Currently the inductors are in star connection and they are supplied with…

Q: HowiAlossless TL with charneteristic impedance of z. is terminated in Zr=3Zo use crank dingram to…

A: A lossless transmission line with a characteristic impedance of Zo is terminated in ZL=3Zo . We need…

Q: O What is the advantage of using graded index fiber over step index? Explain with diagram.

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: hich Luenberger gain matrix would place observer poles at [-8,-16] for the system

A: It is given that: -8.-16x=1042x+51u˙y=10x

Q: 14.2 Derive expressions for the voltage in time domain and the instantaneous power for the cirn…

A: In this question, Find the Voltage in the time domain, And instantaneous power p(t) =v(t) I(t)…

Q: pasic requirement psed one wind; ave winding o: ar (h) or (o)

A: The DC motor convert an electrical energy into mechanical energy. The following Dc motor are used in…

Q: system that has all zeros and poles in the left half of s-plane represents minimum phase systems ?…

A: In this question we will write about minimum phase system...

Q: hat is the relationship between phase and line voltages and currents in a wye onnection? hat is the…

A: Solve the problem

Q: A lossless TL with characteristic impedance of to is terminated in Zv=3Z0. use crank diagram to…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 11. A single 3 phase line operated at 50HZ is arranged as shown in figure. The conductor diameter is…

A: Given circuit is - Given diameter of conductor is -

Q: Darrieus turbine does not requires guy wires to support. Select one: True O False

A: According to the question we have to discuss about Darrieus Turbine.

Q: In a 3-phase, 4-wire system, two phases have currents of 10 A and 6 A in lagging power factors of…

Q: A 3¢, with VL-L of 34.5 kV, grounded-Way feeder has 556.5 kcmil ACSR with 30-strands AL conductor,…

A: for star connection , phase current = line current . apparent power = 3 ×VL×IL

Q: 3. A coaxial cable with a = 3 mm and b=6 mm has perfect conductors (no ohmic losses) and the region…

A: Zo = 60 / √(€r). × ln [ a/b] a= Inner Diameter Coaxial Cable b = outer Diameter Coaxial Cable…

Q: A 20 MVA, 3-phase, star-connected, 50-Hz, salient-pole has X,= 1 p.u.; X,=0.65 p.u. and R, =0.01…

Q: The terminal voltage of a 3-φ generator is 19053 V, line-to-line. The load draws a current of 1515…

Q: Expression for a voltage reflection co-efficient in terms of load impedance and characteristics…

Q: ) To match a load of ZL = 30 (2), to a transmission line with characteristic (f) ( impedance Zo = 75…

A: According to the question, to match a load line, we need to find the distance of the quarter-wave…

Q: 14.24 Determine the complex power supplied by the voltage source in the čiPcult shoWh if the voltage…

Concept explainers

DC Generator

An electromechanical machine which converts input mechanical energy to respective output electric energy is called a generator.

Question

How do I solve in steps? And what are the main equations I should be using? The answer is supposed to be Pmax = 0.3077W

AC Power Analysis
14.15 Determine the maximum power transferred to Z, in the circuit shown in Figure 14-31.
j8N
Ix
ZL
2L0° Arms
2 Ix
FIGURE 14-31: Circuit schematic for problem 14.15.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

On the single-phase distributor shown on figure 1 above the terminal voltage ?? = 248 + ?16?. Compute:a. Voltages ?? ??? ??b. Draw a phasor diagram
How can I compute and get the values of branch currents (Iab, Iac, Ibc, Ibd, Icd and Ica) and the algebraic sum of the potential difference for electrical loops (abca, abdca, acda, abcda and acbda) by using Kirchhoff's voltage and current law (KVL and KCL) equations?
Consider the circuit shown in Figure P14.64. Find the secondary voltage V2rms the secondary current I2rms and the power delivered to the load if the turns ratio is N1/N2 = 10. Repeat for N1/N2=1 and for N1/N2=0.1 .
An ideal transformer with N1 ¼ 2000 and N2 ¼ 500 is connected with an impedanceZ22 across winding 2, called secondary. If V1 ¼ 1000 0 V and I1 ¼ 5 -30 A,determine V2, I2, Z2, and the impedance Z02, which is the value of Z2 referred to theprimary side of the transformer.
In a transformer test, data from short circuit and open circuit tests of a 75-kVA, 4600-230V, 60Hztransformer are:Open circuit test data is referred tolow voltage sideShort circuit test data is referred tohigh voltage sideVOC = 230V VSC = 160.08VIOC = 13.04A ISC = 16.3APOC = 521W PSC = 1200WDetermine (a) the magnetizing reactance and core loss resistance (b) the per unit equivalentimpedance
Using the mesh analysis equation for loop 2 what are the steps for conversion for the division of imaginary numbers with phasors?
a. What is Vs?b. Solve for thew load impedence Z_L.c. What is the value of the load impedance when referred to the high-voltage side of the transformer?
A polyphase system is generated by______? a.Both a and c b.Having two or more generator windings separated by equal electrical angle c.Having generator windings at equal distances d.None of these
Which termination would result to a phase change of 180 degrees at the load if Zo = 100 ohm? a. 50 ohm b. short circuit c. 75 ohm d. all of these What is the purpose of impedance matching? a. maximum return loss b. maximum SWR c. maximum load power d. maximum reflection A short piece of transmission line that may be open or shorted and used for impedance matching purposes. a. converter b. decoder c. stub d. transformer
True or false? An ideal transformer has no real or reactive power loss.
a shunt generator supplies a load of 5,500w at 110v through a pair of feeder conductors having a resistance of 0.02 ohm each. the armature, shunt field resistances are 0.15 ohm and 50 ohms respectively, find the emf generated.
Draw the phasor diagrams for the following 3-phase components: 1-Transformer: exact equivalent circuit of lagging load with V1 reference. 2- Alternator: leading pf, normal excitation, and maximum power. 3- Compensator: lagging pf, leading pf, and normal excitation.