Activity 3: Quantitative Problem Direction: Solve as directed. Write your answers on a separate sheet of paper. You may also consult your Physics teacher. Find the unknown values of voltage and current in each resistor as shown in the given circuit diagram. 12 +20V 602 tr 492 W 1Ω www H 1Ω www 202

Activity 3: Quantitative Problem Direction: Solve as directed. Write your answers on a separate sheet of paper. You may also consult your Physics teacher. Find the unknown values of voltage and current in each resistor as shown in the given circuit diagram. 12 +20V 602 tr 492 W 1Ω www H 1Ω www 202

Inquiry into Physics

8th Edition

ISBN:9781337515863

Author:Ostdiek

Publisher:Ostdiek

Chapter7: Electricity

Section: Chapter Questions

Problem 13P

See similar textbooks

Similar questions

Consider a simple circuit consisting of a battery, a closed switch, and a resistor. The voltage across the battery is 1.72 V, and the current through the resistor is 3.93 A. If the resistor is a cylindrical resistor of length 0.06 m made of a material with resistivity of 5.6x10-6 ohm-meters, what is the cross-sectional area of the resistor element? Your answer should be in m2.
Please help: Pacemakers designed for long-term use commonly employ a lithium-iodide battery capable of supplying 0.42 A•h of charge (A) How many coulombs of charge can such a battery supply? Express your answer using two significant figures (B) If the average current produced by the pacemaker is 5.6 micro Amps, what is the expected lifetime of the device? Express answer using two significant figures
The heating element of a simple heater consists of a 2.0-m-long, 0.60-mm-diameter nichrome wire. When plugged into a 120 V outlet, the heater draws 8.0 A of current when hot.a. What is the wire’s resistance when it is hot?b. Use your answer to part a to calculate the resistivity of nichrome in this situation. Why is it not the same as the value of ρ given for nichrome in the given table?
Answer the following 1. A voltage of 120V generates an IR drop across two resistors connected in series. If the voltage drop across R1 is 30V, what is the voltage drop across R2, in Volts? a) 80 b) 40 c) 100 d) 90 2. Three resistors R1, R2 and R3 of 20, 40 and 60 ohms are connected in parallel through the 120 V power line. What is the total current in the power line? a) 10A b) 12A c) 11A d) 15A 3. Resistors in a circuit are generally used to: a) increase the flow of the current b) decrease the flow of current c) avoid overvoltage d) decrease the power in the circuit
Consider a wire made of copper with conductivity 6.0x10^7 omega^-1m^-1, which has a circular cross-section of radius 0.29 mm. In a particular circuit, this wire Carrie’s a current of 6.5 A. Part (a) what is the electrical field, involves per meter, inside the wire? Part (b) if we replace this wire with the gold one of the same size, with 4.1x10^7omega^-1m^-1, conductivity what will the electrical field in the wire be?
Q1: Upton Chuck is riding the Giant Drop at Great America. If Upton free falls for 2.60 seconds, what will be his final velocity and how far will he fall? Q2: A wire of length 3 m and area of cross-section 1.7 × 10-6 m2 has a resistance 3 × 10-2 ohm.a. What is the formula for resistivity of the wire and what is the unit of it?b. Calculate the resistivity of the wire.Q3: A point charge of −2 μC is located at the center of a cube with sides L=5 cm. What is the net electric flux through the surface?
Part A:If there is an annealed copper wire with resistivity 0.172 nano ohm meters and a diameter of 2mm placed in an electric field of 16,000N/C, then how much current will go through the wire? Part BIf this wire (the same as in part A) has an electron density of 8.5x10^28 m^-3 then what is the drift velocity of the electrons in this wire? The charge of each electron is, as usual, 1.602x10^-19C.
5 part A: If u(C) = 0.2C. What in the uncertainty of a 500 mF capacitor in mF? 5 Part B: If C = 500 mF and R = 8000 W , and V = 5 V. What is the voltage across the resistor in an RC circuit if it started out fully charged and the time since we started charging 6 seconds ago?
The heater element of a particular 120-V toaster is a 8.9-m length of nichrome wire, whose diameter is 0.86 mm. The resistivity of nichrome at the operating temperature of the toaster is 1.3 × 10-6Ω m. What is the resistance of the toaster? If the toaster is operated at a voltage of 120 V, how much power does it draw? Clearly state the formulae you’re using and what your letters/symbols mean.
The following graph represents the charge-discharge profile of a Li-ion battery in the 1st and 50th cycles, cycled at a rate of 0.1 C (1C = 274 mA h g-1 ) in the voltage range of 3.0 to 4.6 V. The battery is made up of LiCoO2 cathode and Li anode. Answer the following questions. a. What is the value of charge-discharge current density in this case? How long does it take for this battery to discharge from 4.6 V to 3.0 V in 50th cycle? b. Calculate Coulombic efficiency at 1st and 50th cycles. Why are these values different? c. How would this graph look like if LiCoO2 and Li were replaced by MnO2 and graphite electrodes respectively Make a rough sketch. d. Mention any two practical disadvantages of this battery?
Pure copper has a resistivity of 1.68 × 10−8 Ωm. Some accurate cubes of copper are prepared,and electrical measurements are made, for which current is passed across a pair of oppositefaces.a) Comparing a 2.5 cm cube and a 5 cm cube, which will have the higher conductance? Explain your answer.b) Given eight 1 cm cubes, how can they be stacked to get the highest and the lowest resistance between opposite faces of the stack? Calculate the resistance of each stack.
The graph below shows the current that flows through a device called a diode at different voltages. Instead of the numbers presented on this graph, consider a diode for which current varies with voltage according to the equation I = V11.9. Hint: Plot this equation on your calculator. a. What is the resistance of the diode when a potential difference of 0.59 volts is placed across it? Include units in your answer. b. What is the resistance of the diode when 0.72 volts is placed across it? Include units in your answer.