Activity A B C D E F G H 1 J K L M N Draw a network for this project. Preceding Activity None A A B D D D B C, E F, I, J K H, G M Duration (weeks) 5 2 6 12 10 5 5 9 1 2 3 9 7 9

Q: A flat plate of 0.15 m² is pulled at 20 cm/s relative to another plate. fixed at a distance of 0.02…

A: Given- Area A=0.15 m2, Velocity V=20 cm/s, Distance=0.02 cm, It is needed to find the power required…

Q: Calculate the shape factor and fully plastic moment Mp of the section shown in above figure . Assume…

A:

Q: The deflection angles of two intermediate points A and B of a highway curve are given below. The…

A: Given  Chord distance (CAB) = 20 m  Length of curve = 120 m

Q: If the F/M ratio of a 0.4380 m3/s activated sludge plant is 0.2 mg/mg.d, the influent BOD5 after…

A: Given data Q=0.4380 m3/sF/M=0.2 mg/mg.d=0.2d-1influent BOD5, S0=150mg/LML VSS, X=2200mg/L To find :…

Q: The weight of a body as measured while completely immersed in water was found to be 250 N and in a…

A: Weight of body in water = 250 N Weight of body in salt water = 245 N

Q: Estimate the fallout level if the specifications are 16 ± 5. Estimate ?? and interpret this ratio.

A: The fallout level is estimated to be 11-21.

Q: The rainfall figures for successive 30-minute intervals are 35, 40, 120, 85, 45, 45 and 30 mm/hr. If…

A: Given,Rainfall data for sucessive 30 intervals=35,40,120,85,45,45 and 30 mm/hrϕ index=35 mm/hrTo…

Q: A girder and floor beam constrcution subjected to concentrated loads is shown in Figure . Draw the…

A:

Q: 6. Draw the shear and bending moment diagrams of the beam loaded as shown in the figures below.…

A:

Q: 2. Determine the force in each member of the truss shown in Figure 2. Use method of Joints. State…

A:

Q: If the radius of a circular curve is 252.27 meters and one full station is 50 meters, what is its…

A:

Q: 1. Determine the force in each member of the truss shown In Figure 1. Use method of Joints. State…

A: Given Data  Find the forces in each member using method of joints.

Q: 12. A 15 m thick clay layer has Gs=2.72 and e=0.45. The water table is at the ground surface. a.…

A: Given data in question  Void ratio 0.45 Specific gravity 2.72 Water table at top Depth 15 m To find…

Q: Q4. A flownet for flow of a dam shown bellow, find the total flow in m³/day if the length of the dam…

A: X = 1.6 m Y = 2.8 m Length = 1200 m

Q: Example: For the three hinged arch shown in figure below, find the support reactions and axial force…

A:

Q: A rigid 2m square footing is constructed over a loose sand layer as shown on the figure. It carries…

A:

Q: 10 ml of wastewater is diluted to 1 liter, aerated, and sealed. The initial dissolved oxygen level…

A: Given that,Volume of waste water,Vs = 10 mlIt is diluted to 1 liter aerated and sealed.Initial…

Q: An annual flood series contains 100 years of flood data. For a return period of 200 years the…

A:

Q: Q.2 An open, clean glass tube (0 = 0) is inserted vertically into a pan of water. The surface…

A: Given data- An open clean glass tube θ=0, Surface tension- σ=7.34×10-2 N/m, The water level in the…

Q: What is the shear deformation? δ = mm What is the seismic force? P = N must be: 4.91[6-8]mm…

A:

Q: In soil mechnics, discuss how flow-related, volume change-related, and strength-related engineering…

A: Flow-Related Engineering Properties: Friction, permeability, adhesion, and cohesion of soil are the…

Q: 6. Draw the shear and bending moment diagrams of the beam loaded as shown in the figures below.…

A:

Q: step by step solution please, thank you!

A:

Q: Question- For a fully developed laminar flow of water (dynamic viscosity 0.003 Pa-sec) through a…

A: Given data- A fully developed laminar flow of water, Dynamic viscosity μ=0.003 Pa-sec, Radius of the…

Q: 10 kN/m 3 m 4m (a) 12 kN/m 3m

A: Shear and bending moment diagrams are analytical tools used in conjunction with structural analysis…

Q: |||lll FI=∞ EI=80 K₂ K₁ 7777777 k= 400 -300 -300 300 Find the value of K₁ =)

A:

Q: If the radius of a circular curve is 105.47 feet and one full station is 200 feet, what is its…

A: This question is related to the Simple curve from Surveying Engineering. Given Data -  Radius of…

Q: Three boards, each 2 in. thick, are nailed together to form a beam that is subjected to a vertical…

A: Given : Thickness of boards = 2 in. Allowable shearing force = 250 lb To Determine : Determine the…

Q: An underpass crossing a reinforced concrete bridge along the Shaw Blvd has a symmetrical vertical…

A: An underpass crossing a reinforced concrete bridge along Shaw Blvd has a symmetrical vertical curve…

Q: Only answer A. Explain why the obtained answer makes sense.

A: This question is related to the Strength of the material from Civil Engineering. As per question…

Q: The pin-connected structure consists of a rigid beam ABCD and two supporting bars. Bar (1) is an…

A:

Q: The flanged steel cantilever beam with riveted bracket is subjected to the couple and two forces…

A:

Q: Situation 2. Neglecting weights of the members, compute the forces acting on the pins B, C, and D.

A: Answer  Let us first calculate the reactions at A and E Consider Moment equilibrium at A Ey*15 =…

Q: tion 5 Given the tangent distance equal to 243.28 meters and the angle of intersection equal to 26,…

A:

Q: A quadrilateral ABCD (violet) is subjected to axial and shear forces transforming it into a right…

A: The given figure is shown below:

Q: 9. For the three-hinged arch shown, determine the reactions at A and B. The vertical distance…

A:

Q: A container of volume 3 x 103 m³ weighs 10 N. Dry sand was poured to fill the container. The…

A:

Q: Q3. A flow net for flow around a single row of sheet piles in a permeable soil layer is shown in…

A:

Q: Problem 3 & 4. For the following built up beams, calculate the shear flow q (lbs/in or kips/in) at…

A:

Q: 9. For the three-hinged arch shown, determine the reactions at A and B. The vertical distance…

A:

Q: water enter an inward flow turbine at an angle of 22° to the tangent to the outer rim and leaves the…

A: Given : Speed of the wheel = 300 rpm Velocity of flow = 3 m/s Diameter of inner turbine = 30 cm…

Q: Working on discharge and peak flow for hydrology. I did some data analysis and need to know what is…

A: Given: The average depth of runoff produced across the basis and the measure of flashiness has been…

Q: If the radius of a circular curve is 223.93 meters, what is its degree of curvature (in d

A: Given data  R=223.93m D=?

Q: P.1. The distributed load has a magnitude of w = 225 N/m. Determine the reactions at the roller at A…

A:

Q: If the radius of a circular curve is 221.48 meters and one full station is 50 meters, what is its…

A: Given: Radius of the curveR=221.48 m Length of curveL=50 m To find: Degree of curvature

Q: The deflection angles of two intermediate points A and B of a highway curve are given below. The…

A: Answer  Calculation of the Radius of curve Based on the given deflection angle of A and B let us…

Q: 9. For the three-hinged arch shown, determine the reactions at A and B. The vertical distance…

A:

Q: Question 5 (a) The beam has the rectangular cross section shown in the Fig. Q5(a). i) Determine the…

A:

Q: The following data were obtained by conducting liquid limit and plastic li tests on a soil collected…

A: To determine: a) Draw the flow curve and determine the liquid limit b) Using the Casagrande…

Q: Please

A: