Answered: acuum, willh increase or descrease and…

Engineering

Civil Engineering

acuum, willh increase or descrease and by how much? ume atmospheric pressure is 100 kPa. Air space h Water

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter11: Temperature And Temperature- Related Variables In Engineering

Section: Chapter Questions

Problem 9P: Calculate the R-value for the following materials: a. 4 in. thick brick b. 10 cm thick brick c. 12...

See similar textbooks

Related questions

Q: A manometer is used to measure the pressure in a tank filled with air. The fluid has a specific…

A: The Absolute Pressure in the Tank :

Q: Given a liquid water having a volume of 6m3 and weight of 44kN at 4°C, Calculate a. Specific weight…

A: Note:-Hi! Thank you for the question, As per the honor code, we are allowed to answer three…

Q: PROBLEM 6: A gasoline line is connected to a pressure gage through a double-U manometer, as shown.…

Q: 75-mm inside diameter Flow 0.25 m 200- mm inside 0.60 m diameter Water

A: Venturi meter is used to find the rate of flow through closed pipe . Venturi meter has 3 parts…

Q: 10. What is unit for flow rate for gases? a) m³/s b) litres/s c) cm³/s d) kgf/s

A: Explanation : m3/sec, litres/sec and cm3/sec are the units for discharge. The unit flow rate for…

Q: Calculate the capillary effect in millimeters in a glass tube of 4mm diameter, when immersed in…

A: Solution- Given, The Diameter of tube=4mm

Q: Q5) For the inverted manometer of Figure , all fluids are at 20C. If pB – PA=7 kPa, what must the…

A: Pressure at height h of the fluid= density of fluid × g × height of fluid.

Q: In the system given in the figure, the flow rate of the current passing through the AC pipe is how…

Q: A volume of 25 in3 of air is measured at a pressure of 30 in HG absolute and a temperature of 70°F.…

A: Given P1 = 30 in HG P2 = 10 psig = 20.36 in HG T1 = 700 F T2 = 20 C = 35.60 F V1…

Q: 1.20 Calculate the work done in blowing a soap bubble of diameter 12 cm. Assume the surface tension…

Q: Both a gage and a manometer are attached to a gas tank to measure its pressure. If the reading on…

Q: The pressure in an automobile tire depends on the temperature of the air in the tire. When the air…

A: T1=25°C=298KT2=60°C=333Kso,using gas lawP1V1T1=P2V2T2P2=210kPa+PatmP2=333298210+100P2=346.41kPa

Q: 3. The system in Figure is at 20°C. If atmospheric pressure is 101.33 kPa and the pressure at the…

A: Given:- SG of oil=0.9 Pressure=242kPa To find:- Specific gravity of fluid X

Q: 4. 1.7. Surface Tension H.W. 1: Derive an equation to estimate the internal pressure that is due to…

A: in case of liquid drop forces act on drop is like, gauge pressure exerted on area of droplet and…

Q: -Water 5 Mercury 175 cm IM

A: Step 1

Q: Meriam red oil, SG=0.827 P2.32 Water A 18 cm H 35 cm B Mercury

A: Given data:- The PB-PA=89.5 kPa=89500 Pa The specific weight of water is, Wwater=9790 N/m3 The…

Q: A useful theoretical equation for computing the relation between pressure, velocity, and the…

A: The values are given below, po=p+12ρV2+ρgZpo=Stagnation Pressurep=Pressure in moving…

Q: The density of a liquid is to be determined by an old 1-cm- diameter cylindrical hydrometer whose…

Q: The volume flow rate of a given fluid is 0.002 m/sec. What is the mass flow rate of that fluid…

Q: The water in a tank is pressurized by air, and the pressure is measured by a multifluid manometer as…

Q: A barometer is used to measure the height of a building by recording reading at the bottom and at…

A: Given density of air = 1.18kg/m3 density of mercury = 13600 Kg/m3 ATM at bottom = 73cm and at top =…

Q: The reading of an automobile fuel gage is proportional to the gage pressure at the bottom of the…

Q: Problem 1. A manometer is first filled with water (blue) and then with mercury (gray). The mercury…

A: To find pressure at point a

Q: . Determine the difference in pressure between points A and B from the figure above. Kerosene…

A: The unit of pressure is kPa , but in option it is given in m.

Q: For the figure below, the atmospheric pressure equal to 101.3 kPa and the bottom pressure is 240…

A: Given-Specific gravity of oil=0.89Specific gravity of water=1.0Specific gravity of X=?Specific…

Q: Calculate the absolute pressure (in psia) in the natural gas pipeline. Assume that the effect of air…

A: Calculate the absolute pressure (in psia) in the natural gas pipeline.

Q: In a manometer shown in Fig.1, the fluid from A to B is mercury (sp. gravity 13.6) and from B to C,…

A: Given: The specific gravity of the mercury is 13.6. The specific gravity of the oil is 0.80. The…

Q: 1. For the computation of density of liquids to be tested, use the following values of density of…

Q: QUESTION 1 "The gage pressure in a pipe is measured by a manometer containing mercury (density:…

A: To determine the gage pressure in the pipe. Given, Density of mercury (ρHg) = 13600 kg/m3…

Q: the surface tension of water in contact with air at 20c is given as 0.0716 n/m. the pressure inside…

A: Given Data:- Surface tension σ=0.0716 nm Excess Pressure inside droplet of water ∆P = 0.0147ncm2…

Q: The density of a liquid is to be determined by an old 1-cm-diameter cylindrical hydrometer whose…

Q: 2. Calculate the kinematic viscosity (v) as follows Where: - absolute viscosity P. density of fluid…

A: Answer: To Calculate the dynamic and kinematic viscosity of the fluids we need to calculate Average…

Q: A hemisphere of radius 12 inches and base up is full of water that runs out through an orifice of…

Q: Problem 1. (10 points) What is the mass in grams and the weight in dynes and in gram-force of 12 oz…

Q: PROBLEM 5: The water in a tank is pressurized by air, and the pressure is 4 points measured by a…

Q: the surface tension of water in contact with air at 20c is given as 0.0716 n/m. the pressure inside…

Q: Calculate the location of the center of pressure, Lp, to in m to the nearest 1000th. Fluid: Orange…

A: NOTE : as per our guidelines we are supposed to answer only one question. Kindly repost the another…

Q: An industrial tank is discharging a fluid through a 5-inches nozzle with a velocity of 5 meters per…

A: Given; Diameter of nozzle=5"=5×0.0254m=0.127m Velocity of water flowing out = 5m/s Rate at which…

Q: The figure below shows a closed tank that contains gasoline floating on water. Calculate the air…

A: Solution: Given Data S.G for mercury=13.54 Pressure is given byP=ρghρ=density of…

Q: 4. Calculate the pressure of air at a height of 3500m from sea level where pressure and temperature…

A: Fluid mechanics is the discipline of physics that studies the mechanics of fluids (liquids, gases,…

Q: The water in a tank is pressurized by air, and the pressure is measured by a multifluid manometer as…

Q: AIR P=150mmHG WATER FLUID X SG=3.69 FLUID Y SG-4.69 FLUID Z SG=5.69

Q: PROBLEM 5: The water in a tank is pressurized by air, and the pressure is measured by a multifluid…

A: The given data is: h1=0.4 m h2=0.6 m h3=0.8 m Water density=1000 Kg/m3 Oil density=850 Kg/m3 Mercury…

Q: Q1: Air flows through a pipe that consists of two sections at a specified rate. The differential…

A: The given data is shown below:

Q: 3. A conical tank shown in the figure has a diameter of 3 meters and an altitude of 5 meters. Find…

Q: Three different fluids, water, oil (SG = 0.83), and unknown fluid, fill the tank and manometer tube…

Q: the surface tension of water in contact with air at 20c is given as 0.0716 n/m . the pressure inside…

A: Given: Surface tension at Tatm - 20 degree C = 0.0716n/m The pressure inside a droplet of water is…

Q: For the figure below, find the pressure at Point A and at Point B. The fluid in the system is castor…

Q: 18. Calculate the pressure exerted by 4 kg mass of nitrogen gas at a temperature of 15°C if the…

A: Step 1

Q: a) As shown in Figure 1, what is the pressure of the air in the tank if = 40 cm, 62 = 100 cm, lz =…

A: Taking pressure equation:P1+l3γhg-γairl2+Sγwl2-Sγwl2-l1=P2

Concept explainers

Pressure and Stress

Question

Fluid Mechanics question:

As shown in the image, an air space above a long tube is pressurized to 50 kPa vacuum. Water (15^oC) from a reservoir fills the tube to a height h. If the pressure in the air space is changed to 25 kPa vacuum, will h increase or decrease, and by how much? Assume atmospheric pressure is 100 kPa.

acuum, willh increase or descrease and by how much?
ume atmospheric pressure is 100 kPa.
Air space
h
Water

Branch of science that deals with the stationary and moving bodies under the influence of forces.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Convert 15,14 poises to kinematic viscosity if the liquid has aspecific gravity of 0.964.
Sorry maybe i have included not enough information. Esteel = 200 GPa , Coefficient of thermal expansionsteel = 12 * 10^-6 , yieldstell =345 MPa ; Ealuminum = 73.1 GPa , Coefficient of thermal expansionaluminum 23*10^-6 ,yieldaluminum= 414 MPa
The unit weight of water at 50°F is 62.4 pcf. If the volume of the vessel that contains water is 3.50ft³. A. What will the be the change volume when it is heated to 160°F ( unit weight of water is 61 pcf 160°F) B. Compute the percentage change of volume C. What weight of water must be removed to maintain the original volume (Our Subject is FLUID MECHANIC)
A gas expands from 0.03 m3 to 0.05 m3 at constant pressure of 3.5 atm. Determine the work done.
Determine the amount of coagulant required per day (kg/day).• Assume that the optimum dosage of alum at 25 mg/L was used and that the density of alum was 600kg/m3, Power = 1736.3 watt, Volume= 10.83 m^3 , water temperature is 20 oC, and velocity Gradient is 400 1/s.• Amount of alum = ? (kg/month)• Volume of alum = ? (m3/month)
In a wastewater treatment plant, the supply of oxygen supply is 073 kgO2/h is necessary underoperating conditions, using a mechanical aeration system. Calculate theStandard Oxygen Transfer Rate. Using relevant data: Liquid temperature: T = 23 ◦C, Altitude = 1000 m, DO concentration to be maintained in the liquid CL = 1.5 mg/L, α = 0.90, β = 0.95, θ = 1.024 (Note: calculate the required value if it is missing)
A tank initially contains 60 gallons of brine in which there is dissolved 8 lbs. of salt. Brine containing 2 lbs. of dissolved salt per gallon flows into the tank at the rate of 5 gal/min. The mixture is kept uniform by stirring, and the stirred mixture simultaneously flows out at the slower rate of 3 gal/min. How much salt is in the tank at any time t>0?
Give me right solution. A foam with specific weight of 0.628 kN/m^3 is attached to a square bottomed material. What specific weight of the material is required so that the computed metacenter is 5 cm higher than the center of gravity and the location of center of buoyancy is 0.90 m when placed in oil (sg=0.80)?
Give me the solution of this please: Answer:Ans. 10.2 Mpa
A liquid having a Reynolds number of 1900 flows thru a 200mm diameter pipe 150m long. The head loss of the pipe due to friction is 22m. Compute the friction factor. Compute the kinematic viscosity of the liquid in sq.m/s. Compute rate of flow in liters/hour.
Discuss atleast 6 negative effects of carbon monoxide and 6 negative effects of carbon dioxide
Air in a large tank, at 300 °C and 400 kPa, fl ows through aconverging-diverging nozzle with throat diameter 2 cm. Itexits smoothly at a Mach number of 2.8. According to onedimensionalisentropic theory, what is (a) the exit diameter,and (b) the mass fl ow?