3. A conical tank shown in the figure has a diameter of 3 meters and an altitude of 5 meters. Find the volume of the liquid when the tank is full in cubic meters? Find volume "A" when the tank is filled to a depth of 3 meters in gallons. What is the surface area covered by volume "A" (or the wet surface area) in sauare meters?

3. A conical tank shown in the figure has a diameter of 3 meters and an altitude of 5 meters. Find the volume of the liquid when the tank is full in cubic meters? Find volume "A" when the tank is filled to a depth of 3 meters in gallons. What is the surface area covered by volume "A" (or the wet surface area) in sauare meters?

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter8: Time And Time-related Variables In Engineering

Section: Chapter Questions

Problem 33P

See similar textbooks

Similar questions

Using the information given in Table 10.4, determine the ratio of local pressure and density to sea-level values. Estimate the value of air density at the cruising altitude of most commercial airliners. Altitude (m) sealevel PPsealevel 0 (sea level) 1000 3000 5000 8000 10,000 12,000 14,000 15,000
The outside diameter of a right circular cylindrical tank is 3,000 mm and its height is 6,000 mm. If the thickness of the tank is ¼ inch, calculate the capacity in gallons.
A hemisphere of radius 12 inches and base up is full of water that runs out through an orifice of area 1 in2 in the bottom of the tank. How long will it take the water to run out? Assume orifice coefficient is 1.0
From point A to point B of the system shown in the figure, oil flows (specific gravity of 8.64 kN/m3). A) Calculate the volumetric flow of the oil. ( WORK LIKE NEW PLEASE)
Fluid Mechanics question: As shown in the image, an air space above a long tube is pressurized to 50 kPa vacuum. Water (15oC) from a reservoir fills the tube to a height h. If the pressure in the air space is changed to 25 kPa vacuum, will h increase or decrease, and by how much? Assume atmospheric pressure is 100 kPa.
What is the absolute pressure inside the tank after it was submerged in a liquid if the volume of the air inside decreased by 25%? Atmospheric pressure = 101.325 kPa 135.100 kPa 145.778 kPa 152.353 kPa 141.638 kPa
The tanks shown in the figure has the form of a frustum of a cone with dimensions as shown. The bottom of the tank contains orifice that has a coefficient of discharge of 0.62. Then the tank contains water to its depth of 3.5m. Find the diameter of the orifice needed to empty the tank in 8 minutes.
Determine the specific volume in m3/kg of a fluid with specific gravity of 2.5
For water, starting with 1 m3 of water in a container, what is the pressure required to decrease the volume of water by 1%?
Oil flows through a pipe as shown in the figure below. The coefficient of discharge for the orifice in the pipe is 0.85. What is the discharge of oil in the pipe in L/s?
Water flows through a pipe 25 mm in diameter at a velocity of 6 m/s. Determine whether the flow will be laminar or turbulent assuming that the dynamic viscosity of water is taken as1.30 × 10−3 kg/ms and its mass density as 1000 kg/m3. If oil of specific gravity 0.9 and dynamic viscosity 9.6 × 10−2 kg/ms is pumped through the same pipe, what type of flow will occur?
Show complete solutions and figures. The shown tank with an attached manometer contains water unit weight is 9.79 kN/cu.m.at 200oC. The atmospheric pressure is 100kPa. There is a valve located 1m from the surface of the water in the manometer. The valve is closed trapping the air in the manometer, and the water is added to the tank to the level of the valve. Find the increase in the elevation of the water in the manometer assuming the air in the manometer is compressed isothermally. a) 101.3mm b) 92.7mm c) 73.2mm d) 82.4mm e) None