After lots of measurements and calculations, your friend has derived a correlation for connecting velocity (V) with convection coefficient (h) for flow over a flat plate. The correlation involves density (p), specific heat (cp), thermal conductivity (k), and dynamic viscosity (u) of the fluid. But you have your doubts about the equation. How can you prove, without any access to your friend's calculation, that the equation is indeed wrong. h = 0.0592 p¹/5c/3 4/5 ¹/3 ²/3 -7/15 V4/5.

After lots of measurements and calculations, your friend has derived a correlation for connecting velocity (V) with convection coefficient (h) for flow over a flat plate. The correlation involves density (p), specific heat (cp), thermal conductivity (k), and dynamic viscosity (u) of the fluid. But you have your doubts about the equation. How can you prove, without any access to your friend's calculation, that the equation is indeed wrong. h = 0.0592 p¹/5c/3 4/5 ¹/3 ²/3 -7/15 V4/5.

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter19: Temperature, Thermal Expansion And Gas Laws

Section: Chapter Questions

Problem 18PQ

See similar textbooks

Similar questions

Charles’ law states that for a fixed mass of gas under constant pressure, the volume V and temperature T of the gas (in kelvins) satisfy the equation V = kT, where k is constant. Find an equation relating dV>dt to dT>dt.
How strongly does a linear temperature vs volume graph support the assumption that the volume of a gas under constant pressure is directly proportional to the absolute temperature of the gas?
Consider a low-speed flight of the space shuttle as it is nearing a landing. If the air pressure and temperature at the nose of the shuttle are 121,590 Pa and 400K, respectively, what is the density? detailed solution pls, Thank you
What is the ratio of the multiplicity of water vapor at 100∘C to that of liquid water at 100∘C for 1.0 g of water at a pressure of 1.0 atm? Give your answer as a power of 10.
According to the Ideal Gas Law, PV = kT, where P is pressure, V is volume, T is temperature (in kelvins), and k is a constant of proportionality. A tank contains 400 cubic inches of nitrogen at a pressure of 130 pounds per square inch and a temperature of 300 K. (a) Determine k.k = (b) Write P as a function of V and T and describe the level curves.P = (c) Setting P = c, the level curves are of the form V =
Do you anticipate that the diffusion constant will increaseas the temperature of a liquid increases at constant pressure? Why or why not? Will the diffusion constant increasewith temperature for a gas and a solid? Explain.
Show the complete solution that the coefficient of volume expansion can be expressed as in the picture where p is the density.
If the atmospheric pressure is 0.995 atm, what is the pressureof the enclosed gas in each of the three cases depicted in thedrawing? Assume that the gray liquid is mercury.
Let’s assume dry air behaves like an ideal gas and has a molar mass of 28.8 g/mol.a) What is the approximate density of dry air at sea level when the air temperature is 32°C? Hint: How is the unit of standard atmosphere (symbol atm) defined?b) Briefly show and/or explain why this assumption for the molar mass of dry air is reasonable.c) Briefly show and/or explain how the density of air would change with increasing humidity.
How is the thermal entry length defined for flow in a tube? In what region is the flow in a tube fully developed?
What is the physical significance of the Biot number? Is the Biot number more likely to be larger for highly conducting solids or poorly conducting ones?
You buy an "airtight" bag of potato chips packaged at sea level, and take the chips on an airplane flight. When you take the potato chips out of your "carry-on" bag, you notice it has noticeably "puffed up." Airplane cabins are typically pressurized at 0.90 atm, and assuming the temperature inside an airplane is about the same as inside a potato chip processing plant, by what percentage has the bag "puffed up" in comparison to when it was packaged? Express your answer using two significant figures. (V2−V1)/V1= ?