After resurfacing a brake drum: Technician A cleansit using hot water and a lint-free cloth. He then usescompressed air to thoroughly dry it. Technician Bcleans the drum using a lint-free cloth dipped in aspecial brake cleaning solvent. She then allows thedrum to dry before reinstallation. Who is correct?a. Technician A onlyb. Technician B onlyc. Both A and Bd. Neither A nor B

After resurfacing a brake drum: Technician A cleansit using hot water and a lint-free cloth. He then usescompressed air to thoroughly dry it. Technician Bcleans the drum using a lint-free cloth dipped in aspecial brake cleaning solvent. She then allows thedrum to dry before reinstallation. Who is correct?a. Technician A onlyb. Technician B onlyc. Both A and Bd. Neither A nor B

Automotive Technology

7th Edition

ISBN:9781337794213

Author:ERJAVEC, Jack.

Publisher:ERJAVEC, Jack.

Chapter52: Disc Brakes

Section: Chapter Questions

Problem 4ASRQ: When reassembling an overhauled brake caliper: Technician A cleans brake components in denatured...

See similar textbooks

Similar questions

Asbestos has not been used in brake linings or pads since 2003. a. True b. False Technician A says low-drag calipers retract the pistons and pads farther from the rotor than traditional calipers. Technician B says systems that use low-drag calipers cannot use quick take-up master cylinders. Who is correct? a. A only b. B only c. both A and B d. neither A nor B A brake line must be single-flared to provide a good seal at a joint or junction block. a. True b. False Vehicles use brake pedal position sensors. a. True b. False
What are the risks of working with brake fluid?
List at least five seperate types of wear and distortion to look for when inspecting brake drums.
The types of wear and distortion to look for when inspecting brake drums are
why is brake fluid removed from the master cylinder prior to working on disc brakes
Which of the following is true about a brake service? A. It should always include a comprehensive brake inspection B. It requires specialized tools. C. It may lead to additional work if performed properly. C. All of the above
it has been determined that chatter and brake pull are being caused by hard spots on the brake drum: Technician A say that the problem can be solved by grinding off the hard spots. Technician B says that the drum must be replaced. who is correct?
Which of the following statements about drum brakeshoes is not true?a. Web thickness varies only with changes in shoesize.b. Many shoes have indented places along the edgeof the rim.c. The shoe rim is welded to the web.d. The primary/leading shoe is typically the one thatis positioned toward the front of the vehicle
True or False? Backing plates, struts, levers, and other metal brake parts should be cleaned with a wet-cleaned using water or a water-based solution.
Describe two methods of trapping asbestos/brake dust.
What is the difference between block brakes with short and long shoes?
Technician A says that flare nut or line wrenches should be sued to loosen or tighten brake line or tubing fittings Technician B says that open-end wrenches will surround the fitting's nut and provide a positive grip on the fitting. Who is correct? Group of answer choices Technician A only Technician B only Both Technicians A and B Neither A nor B