Answered: Air, P. Water level Water 60 cm A…

Engineering

Mechanical Engineering

Air, P. Water level Water 60 cm A FIGURE P3-67

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.122P: The 12-ft wide quarter-circular gate AB is hinged at A. Determine the contact force between the gate...

See similar textbooks

Related questions

Q: P2.96 The tank in Fig. P2.96 is 3 m wide into the paper. Ne- glecting atmospheric pressure, compute…

A: Given: The width of tank b=3 m, The length AB is AB=6 m, The radius of the quarter circle is…

Q: 3-51 Two water tanks are connected to each other through a mercury manometer with inclined tubes, as…

Q: 2.143 The tank of water in Fig. P2.143 is full and open to the atmosphere (Patm = 15 psi = 2160 psf)…

A: Pe = 15 lbf/in2

Q: Patm Air P= 80 kPa, 40 cm density=? 22 cm Hg

A: As per given question P1 =80kpa We have to determine density of other fluid.

Q: Suppose a very tall open cylindrical container having 1.5 m diameter and is filled with 2226.6…

Q: Determine the required value for M in kg

A: h = 2.7 m d = 0.75 m width of the gate = 2 m. It is required to determine mass M of the cylinder.

Q: The gate is 160 cm wide, is hinged at point B, and rests against a smooth wall at point A. what is…

Q: In the figure below, the tank contains water and immiscible oil at 20°C. What is h in cm if ha =…

A: Solution: Given dataha = 24 cmhb = 20 cmhc = 18 cmρ0 = 898 kg/m3ρw = 998 kg/m3…

Q: A closed tank of fluid (with density = 1100 kg/m³) as shown in the figure is 1 m in diameter and 1.5…

A: Given DataρL=1100 kg/m3d=1m, h=1.5mr=3m, ω=40 rad/sPA=4,00,000paTo find1 PB 2 PC 3 PD

Q: Oil h a m bm Water B

A: The pressure gradient along vertical direction in a hydrostatic system depends on density and…

Q: Q3/ A hinged rectangular gate is held at an angle of 70 degrees to the horizon by a cable, with…

A: VERTICAL DISTANCE,h: h=l/sin70' h=3/0.94 h=3.19m Magnitude of hydrostatic force(F), F=yAh…

Q: The open tank shown, which has a liquid with a specific gravity of S-2.0 as shown in the give…

Q: Pr. 2: 2.159 The three-legged manometer in Fig. P2.159 is filled with water to a depth of 20 cm. All…

Q: A gasoline pipe is connected to a pressure gage through a double-U manometer, as sho in the figure…

A: Given:Reading of pressure gauge, Pg=370 kPaSG of oil=0.79SG of mercury=13.6SG of gasoline=0.70water…

Q: C5-98 A water tank at the aquarium has a circular win- dow 2 m in diameter in a vertical wall as…

A: Considering the minimum depth of the fluid is greater than the top point on the window (2.5 m from…

Q: 3-49 The gage pressure of the air in the tank shown in Fig. P3-49 is measured to be 65 kPa.…

Q: Q3: gage A in the figure reads 290 Kpa. What is the height h of water? and what does gage B read.

Q: 3-153 A gasoline line is connected to a pressure gage through a double-U manometer, as shown in Fig.…

A: Given, Pgage=260 kPa So=0.79⇒ So=0.79×1000=780 kg/m3 Sw=1000kg/m3 Sa=1.9kg/m3…

Q: 1. What is Boyle's law? 2. What is the relationship between volume and pressure? 3. Calculate the…

Q: 3-55 Consider a double-fluid manometer attached to an air pipe shown in Fig. P3-55. If the specific…

Q: For the curved surface AB shown in the figure below, if the specific gravity of the fluid, S = 3.6,…

A: Given data: S=3.6, L=2.5mwater density ρ=1000 kg/m3To be Find: aMagnitude of vertical…

Q: A tank containing water moving horizontally with a constant linear acceleration (3.5m/sec2), and…

A: This problem is related to fluid mechanics. Fluid mechanics is the subject of mechanical engineering…

Q: If the piston mass is 20 kg and the car mass with its base is 400 kg, what will the minimum pressure…

A: we need to calculate minimum pressure required to lift the car

Q: Find the difference in pressure between tanks A and B in kPa shown in Fig. 2-64 if d1, d2, d3, and…

Q: H.W.2/: The bottom quarter of a vertical cylindrical tank of total height 0.4 m and diameter 0.3 m…

A: Radius = R = D/2 = 0.3/2 = 0.15 m

Q: 4. A sliding gate of height 1.4m and width 2.8 lies in vertical plane that weighs 25kN. Determine…

Q: Q2) There is gate inclined by 50° that separates a fluid from water on the left. Calculate he volume…

A: The position and magnitude of the water pressure force operating on water-control structures like…

Q: SS 3-35 An open tank is filled with water to the depth indicated. Atmospheric pressure acts on all…

Q: (1) The mercury manometer in the Figure below is connected to the inlet and outlet of a water pump…

A: givendensity of mercury ρMg=13593kg/m3density of water ρw=1000kg/m3h2=15cm=0.15m

Q: 3-49 The pressure difference between an oil pipe and water pipe is measured by a double-fluid…

Q: (b) The water side of the wall of a 100-m-long dam is a quarter circle with a radius of 10 m as…

Q: 2. Please refer to the figure below. A storage tower was filled with different fluid having…

Q: The tank in Fig. has a 4-cm-diameter plug at the bottomon the right. All fl uids are at 20 ° C. The…

A: Given data The density of mercury, ρHg=13,546Kg/m3 The density of water, ρwater=1000Kg/m3

Q: Let the pressure in the cylinder shown below be a function of volume such that P = C/V (where C is a…

A: Work is said to be done by the system if the sole effect to the things external to the system gets…

Q: P2.30. Determine the pressure difference, P, – Pa betv 0.5 m Water 0.6 m 1.3 m Gage fluid (SG = 2.6)…

Q: Q4/ Fig. Q4, shows a U-tube differential manometer connecting two pressure pipes at A and B. The…

A: The height "h" from the U-tube manometer is as follows:…

Q: 1. What will be the absolute pressure if the gage pressure is (140 cm Hg), take (g=9.81 m/s?, p…

A: Given data Gage pressure is 140 cm Hg g = 9.81 m/s2 Density of Mercury = 13600 kg/m3 Density of…

Q: Consider a 6-m-diameter spherical gate holding a body of water whose height is equal to the diameter…

A: Given : The diameter of spherical gate = 6 m The density of water = 1000 kg/m3

Q: Find the resultant hydrostatic force on plate AB and its location from B. Gama water = 10 kN/m^3.…

Q: Figure Q4a shows a water reservoir with a 20 m wide rectangular gate that is hinged at point A and…

A: Given:Width of the rectangular gate, w=20 mDepth of the water, H=10 mPosition of hinged A from the…

Q: P2.39 An 8-cm-diameter piston compresses manometer oil into an inclined 7-mm-diameter tube, as shown…

A: Given data: The diameter of the piston is, D=8 cm×1 m100 cm=0.08 m. The diameter of the tube is,…

Q: Q2/ The figure shows vessel which contains water with air pressure P above of its surface as…

A: Given: Atmospheric pressure Po=101kPaAssuming the given air pressures inside the tank are absolute…

Q: A vertical rectangular plate with a width of 16 m and a height of 12 m is located 4 m below a water…

A: Given data: Width of the rectangular plate, a = 16 m Height of the rectangular plate, b = 12 m Depth…

Q: : The tank shown in figure below is partially filled with water. On the top of the water there is…

Q: gate in an irrigation canal is constructed in the form of a trapezoid 7 m wide at the bottom, 55 m…

Question

A cylindrical tank is fully filled with water (Fig. P3–67).
In order to increase the flow from the tank, an additional
pressure is applied to the water surface by a compressor. For
P0 = 0, P0 = 5 bar, and P0 = 10 bar, calculate the hydrostatic
force on the surface A exerted by water.

Air, P.
Water level
Water
60 cm
A
FIGURE P3-67

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Approach

VIEW

Step 2: Calculation part

VIEW

Step 3: Conclusion

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

Panels AB and CD in Fig. are each 120 cm wide intothe paper. ( a ) Can you deduce, by inspection, which panelhas the larger water force? ( b ) Even if your deduction isbrilliant, calculate the panel forces anyway.
A triangular wooden body (S=0.80) is placed in water in theposition indicated in the figure. If the width of the body is 7.0 m,determine if the same for this position is stable or not indicating themetacentric height (YM).
A 6-m-high, 5-m-wide rectangular plate blocks the end of a 5-m-deep freshwater channel, as shown . The plate is hinged about a horizontal axis along its upper edge through a point A and is restrained from opening by a fixed ridge at point B. Using appropriate software, investigate the effect of water depth on the force exerted on the plate by the ridge. Let the water depth vary from 0 to 5 m in increments of 0.5 m. Tabulate and plot your results.
16. A semi-circular plate whose radius is 3.6 m and its bottom diameter is 5.6 m from the water surface. What it’s the hydrostatic force acting on the plate?685.3 kN758.9 kN704.5 kN813.2 kN
Figure AB Cover rests on a flat surface. Cover 180 kg weight and 1.2 m wide. At what height is the water depth the lid won't open? find it. (glycerin density is 1260 kg/m3 , That density 1000 kg/m3 )
An inclined rectangular gate AB is constructed at the bottom of a vertical surface of an open dam as shown in the figure below. The gate is 2.5 m wide and 4.0 m long. What is the pressure force of water to the gate? Express your answer in kN.
What is the pressure at the bottom of 0.5m height fluid if the container moves 5m/s2 upward? Fluid has a density of 2000kg/m3 a. 13665Pab. 13258Pac. 14810Pad. 16145Pa
body diagram and complete solution pls
A 4-m-high, 5-m-wide rectangular plate blocks the end of a 4-m-deep freshwater channel, as shown inthe Figure 2 below. The plate is hinged about a horizontal axis along its upper edge through a point Aand is restrained from opening by a fixed ridge at point B. Determine the force exerted on the plate bythe ridge. Clearly state all asuumptions and illustrations.
A circular tank with a diameter of 4.5m is filled with two immiscible fluids. Water to a depth of 3m andoil with a relative density of 0,9 to a depth of 2mDetermine the Hydrostatic force acting on the verticalside of the tank and the position of the centre of pressure from the oil-free surface.
A 6-m-high, 5-m-wide rectangular plate blocks the end of a 5-m-deep freshwater channel, as shown in Fig. below. The plate is hinged about a horizontal axis along its upper edge through a point A and is restrained from opening by a fixed ridge at point B. Determine the force exerted on the plate by the ridge.
Consider a cubical water tank with a side length of 4 m. The tank is half filled with water, and is open to the atmosphere. Now, a truck carrying this tank is accelerated at a rate of 7 m/s^2 on a flat road. The maximum vertical rise (in meters) of free surface of the water is? only HANDWRITTEN answer needed ( NOT TYPED)