An 1.000 L aluminum pot is filled to the brim withwater and heated from 10.0°C to the boilingpoint of water (Kraft Dinner, anyone?). The linearcoefficient of expansion for aluminum is 24 × 10-6(°C) 1 and the volume expansion coefficient forwater is 210 x 10-6 (°C)-1. How much water spillsfrom the pot due to the differences in thermalvolume expansion?O A) 2 mLB) 18 mLC)no water spills outO D) 12 mL

An 1.000 L aluminum pot is filled to the brim with water and heated from 10.0°C to the boiling point of water (Kraft Dinner, anyone?). The linear coefficient of expansion for aluminum is 24 x 10-6 (°C)*1 and the volume expansion coefficient for water is 210 x 10-6 (°C)*1. How much water spills from the pot due to the differences in thermal volume expansion?

An 1.000 L aluminum pot is filled to the brim with water and heated from 10.0°C to the boiling point of water (Kraft Dinner, anyone?). The linear coefficient of expansion for aluminum is 24 x 10-6 (°C)1 and the volume expansion coefficient for water is 210 x 10-6 (°C)1. How much water spills from the pot due to the differences in thermal volume expansion?

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter8: Natural Convection

Section: Chapter Questions

Problem 8.36P

See similar textbooks

Similar questions

To ensure a tight fit, the aluminum rivet used in airplane construction are made slightly larger than the rivet holes and cooled by dry ice (solid CO2) before being driven. If the diameter of a hole is 0.500 cm, what should be the diameter of a rive at 20 degree Celsius if its diameter is equal that of a hole when the rivet is cooled to -78 degree Celsius, the temperature of dry ice? Assume the coefficient of expansion to remain constant. (Given and solutions)
Most automobiles have a coolant reservoir to catch radiator fluid that may overflow when the engine is hot. Such a radiator, made of copper, is filled to its 12-L capacity when at 10.0°C. -What volume of radiator fluid, in liters, will overflow when the radiator and fluid reach their 99.5°C operating temperature, given that the fluid’s thermal coefficient of volume expansion is 400.0 × 10-6 / °C? The coefficient of volume expansion for copper is 5.1 × 10-5 /°C.
A hollow aluminum cylinder 16.5 cm deep has an internal capacity of 2.000 L at 23.0°C. It is completely filled with turpentine at 23.0°C. The turpentine and the aluminum cylinder are then slowly warmed together to 75.0°C. (The average linear expansion coefficient for aluminum is 2.4 10-5 °C−1, and the average volume expansion coefficient for turpentine is 9.0 10-4 °C−1.) How much turpentine overflows?
SUPPOSE THE AMBIENT TEMPERATURE IS 20degrees CELSIUS, AND THE HOT RESERVOIR CONSISTS OF A SPHERICAL TANK WITH A RADIUS OF 4.00 m, THAT ACTS AS AN IDEAL EMITTER OF RADIATION. IF ALL THE RADIANT ENERGY EMITTED BY THE TANK COULD BE CAPTURED, WHAT IS THE AVERAGE AMOUNT OF WORK THAT COULD BE DONE EACH SECOND? ( please only answer if your 100% correct) (show work)
Hi, can you help me with the following problem? A thermally insulated tank of water 2 m x 2 m, depth 1 m is stirred with a paddle for threehours. If the paddle is driven by a motor whose shaft power is 8 kW determine the rate ofchange of temperature in degrees C per hr and the increase in temperature of the water.The specific heat of water is 4200 J/kgC. Identify a system and start your analysis from anappropriate form of the Fist Law of Thermodynamics
A steam pipe carrying steam at 380 kPa pressure for a distance of 120 m in a chemical plant is not insulated. Estimate the Amount of heat saved if 16 cm steam line were covered with 85% magnesia pipe covering 5 cm thick. Take room temperature to be 36 ℃. Thermal conductivity of 85% magnesia is 0.0745 W/m−K , unit convective coefficient of room air, ho = 12 W m2−K .Take the steam temperature as 142℃. Use atleast 4 decimal places in every computation
A 2m^2 wall of 1010steel is 8 mm thick. If the outside of the wall is100 °C, andyou measure aheat flux of 80 kW/m2coming off the wall, what is the temperature of the insideof thewall?
3.4 Estimate the rate of heat loss due to radiation from a covered pot of water at 95 ° C. How does this compare with the 60 W that is lost due only to convection and conduction losses? What amount of energy input would be needed to maintain the water at its boiling point for 30 minutes? The polished stainless steel pot is cylindrical, 20 cm in diameter and 14 cm high, with a tight-fitting flat cover. The air temperature in the kitchen is about 25 ° C. State any assumptions you make in deriving your estimates
Answer 3-19Please include solution and brief reflection.
A pipe passes through a room in which the surrounding air is at 22 ºC. The diameter of the pipe is 200 mm, the length of the pipe is 3metersand its surface temperature is 250ºC and the emissivity of the surface is 0.9 What is the surface emissive power (radiation heat loss)? If convection heat transfer coefficient from the surface to the air is 20 W/m2.K, what is the rate of heat loss from the surface of pipe by convection? Total heat loss from the surface of the pipe per unit length
What is the minimum amount of ice at OPC that must be added to the contents of a can of diet cola (340m) to cool it down from 20.5C to 0C Assume that the specific heat and density of the diet colo are the same as for water and that no heat is gained or lost to the surroundings. The latent heat of fusion of ice à 3353/g Specific Heat of water 4.184 J/gK and Density of water is 1 g/mL
Convection heat transfer from a plate (2 m x 2 m) is 450 W. If surface temperature of plate is 450 K and surrounding temperature is 300 K, what will be value of heat transfer coefficient?