An absolute pressure of 7 psia corresponds to what gage pressure for standard atmospheric pressure of 14.7 psia?

Q: 5. A spring subjected to a mass(m) are designed to be as a damped spring mass system. Suppose the…

A: Given: natural frequency, fn=0.5Hz damping coefficient, ξ=0.2 wave length, λ=10m amplitude, Y0=20cm

Q: Which property of material can be determined by impact test?

A: following is the answer to the above problem-

Q: Find the fluid force on the vertical side of the tank, where the dimensions are given in feet.…

A:

Q: A single drum drier, operating at atmospheric pressure, is being used to dry a wet slurry,…

A:

Q: A piston–cylinder assembly contains 2 lb of water, initially at 100 lbf/in.2 and 400°F. The water…

A:

Q: Instruction: a. Draw a schematic diagram of each problem with labels of states of a substance; b.…

A: To find: a)Thermal efficiency b) Mass flow rate of the steam entering the first turbine

Q: Steam, initially at 700 lbf/in.2, 550°F undergoes a polytropic process in a piston-cylinder assembly…

A:

Q: Steam, initially at 700 lbf/in.2, 550°F undergoes a polytropic process in a piston-cylinder assembly…

A:

Q: For the 2D geometry shown in Fig.1, evaluate the shape factors F13 and F33 if F12-0.54. H 4 m 0 =…

A: Given, From the figure Radius, R=4+6=10 m Length of area 1, L1=6 m Length of area 2, L2=6 m Central…

Q: Water contained in a piston-cylinder assembly, initially at 300°F, a quality of 60%, and a volume of…

A:

Q: A 50-mm diameter cylinder is made of a brass for which the stress-strain diagram is as shown. The…

A:

Q: (1-a) 4m 3 m 3 kN

A: given; lets take horizonta reaction force at A=RAHlets take verticalreaction force at A=RAVlets take…

Q: Problem#3: Can the system in given figure be in static equilibrium in the position shown? The…

A:

Q: A piston-cylinder assembly contains 2 lb of water, initially at 100 lbf/in.² and 600°F. The water…

A:

Q: Consider a stack of six pancakes. Each pancake is made of 1/4 cup (approximately 60 mL) of batter,…

A: Given data: A stack consists of six pancakes. Volume of pancake = V = 60 mL = 60 cm3 Density of…

Q: 1 QUESTION 1 Consider a desired pump operating condition which adds 35 psi at a flowrate of 500 gpm…

A: Given data  Flow rate = 500 gpm Pressure = 35 psi Density = 62 lbm/ft^3 Find the pump head

Q: For the same cross-sectional area A , for a square cross-sectional area shaft and a circular…

A: To determine the cross-section which will have greater angular rotation.Let the torque acting be…

Q: 1.3 Two solid cylindrical rods AB and BC are welded together at B and = loaded as shown. Knowing…

A: Given P = 10 kips To find Average normal stress

Q: Water contained in a piston-cylinder assembly, initially at 300°F, a quality of 70%, and a volume of…

A:

Q: please anwer all the subquestions. thank you.  1. Air at 30°C db & 50% RH Solve for the following:…

A: Given: Dry bulb temperature of air: →DBT=30°C Relative humidity: →RH=50% At the above condition:…

Q: A crate of mass 132 kg is held in the position shown. Determine (a) the magnitude, sense, and point…

A:

Q: 2. Block A has a weight of 500N. Using the coefficients of friction indicated, determine the largest…

A:

Q: Steam, initially at 700 lbf/in.2, 550°F undergoes a polytropic process in a piston-cylinder assembly…

A:

Q: The two cylindrical rod segments shown in the figure below (Eigure 1) are fixed to the rigid walls…

A:

Q: Liquid A(sp gr = 1.02) at a temperature of 29°C is flowing at a rate of 124gal/min in a pipe with an…

A:

Q: A piston-cylinder assembly contains 0.4 lb of air initially at a pressure of 30 lb/in² and a…

A: Given data:mass of air, m=0.4 lbor m=0.18 kgInitial pressure of air, P1=30 lbf/in2or P1=206.84…

Q: The lap joint is fastened with four 3/4-inch diameter rivets. a. If the allowable shearing stress of…

A:

Q: 3.5 A dormitory at a large university, built 50 years ago, has exterior walls constructed of L, =…

A: Given data Ls = 25 mm Ks = 0.1 W/mk Li = 25 mm Ki = 0.029 W/mk Lg= 5 mm Kg = 1.4 W/mk Ti = 22°C ,…

Q: Given the barometric pressure of 14.696 psia ( 29.92 in. Hg as. ), Make these  conversion: c. 24.5…

A: Given:-  Atmospheric pressure = 14.696 psia Pressure (P) = 24.5 psia To Do:- Convert pressure P…

Q: A cylindrical rod made of directionally solidified alloy CM 247 (1050 oC/16h/AC) is to carry a…

A: Given Data For the solidified alloy the load acting is: F=10000 N The temperature is:…

Q: A stone is dropped from a balloon which rises vertically at a constant rate for 4 seconds from the…

A: Given data: t1=4 sect2=10 sec Need to determine the velocity of the balloon when the stone is…

Q: A simple ideal Rankine cycle with water as the working fluid operates between the pressure limits of…

A: Given data: Cycle : Simple Rankine cycle Turbine inlet pressure = P1 = 10 MPa  Turbine inlet…

Q: HVAC (Already answered here in bartleby. Do not copy. Manual Calculations are needed.) UPVOTE WILL…

A: Givendry bulb temperature of 25°Cwet bulb temperature of 21°C

Q: Consider the figure below. Two workers are hauling the construction materials from the staging area…

A:

Q: iew Policies urrent Attempt in Progress Air is compressed in a piston-cylinder assembly from p₁=25…

A:

Q: The cantilever bracket is bolted to a column with three M12x1.75 ISO 5.8 bolts. The bracket is made…

A: The ability of a system's structural capability to be viable beyond its projected or actual loads is…

Q: A simple ideal Rankine cycle with water as the working fluid operates between the pressure li the…

A: GivenP1=10MPaP2=10kPaT1=500oCm=165 kg/s

Q: PROBLEM: One insulated rigid tank contains 1 kg of carbon dioxide CO2 at 3 bar and 150℃, while a…

A:

Q: A canal of trapezoidal section has bed width of 8 m and bed slope of 1 in 4000. If the depth of flow…

A:

Q: What is the elongation fracture for Gary Cast Iron 35? in percentage (Brittle)

A: Given question: What is the elongation fracture for Gray Cast Iron 35 in percentage?   The given…

Q: write vector loop equation(s) theta2=57 also if a new length is constructed find its value.

A:

Q: Consider a flat plate as shown below. Freestream air approaches parallel to the plate with the…

A: Given: The dynamic viscosity of the air = 1.63x10-5 kg/.ms The Mach number, M = 0.4 The altitude, h…

Q: Air with a density of 0.45 kg/m3 enters an experimental jet engine at a rate of 175 m/s. The inlet…

A: Given: at inlet, velocity = 175 m/s density = 0.45 kg/m3 area = 7 ft2 At exit, velocity = 695 m/s…

Q: A room being air conditioned is held at 25°C db & 50% RH. A flow rate of 5m³/s of supply air at 15°C…

A: Given data P=100 kPaV1=5 m3/sT1=15°C Here, P is the pressure and V1 is the volume of the air flow.…

Q: A single drum drier, operating at atmospheric pressure, is being used to dry a wet slurry,…

A:

Q: The block has a mass of 4.0 kg and rests on the smooth plane as shown in (Figure 1). Figure k = 200…

A: Given data:- Mass of block = 4 kg Spring constant = 200 N/m Find the unstretched length of spring

Q: 4. The inner wall of a thermos bottle is at 32°F while the outer at 102.0°F. The space between the…

A: Given data: Ti=32°F=273 KTo=102°F=312 Kε=0.1A=700 cm2=700×10-4 m2 Need to determine the energy…

Q: The 5-lb packages ride on the surface of the conveyor belt as shown in (Figure 1). The coefficient…

A: Part (A): Write the given data. vi=0vf=2 ft/st=2 sμs=0.45

Q: 4. A roller chain is to transmit 38.5 hp from a splitphase motor, turning 650 rpm, to a…

A: Given: P = 38.5 hp = 28.71 kW N1 = 650 rpm N2 = 200 rpm T1 = 21 teeth Ks = 1.6

Q: For a cylindrical S-590 specimen (Animated Figure 8.33) originally 10 mm in diameter and 516 mm…

A: Given data :- Original diameter = 10 mm Length = 516 mm Total elongation = 2.6 mm Sum of…