An AC generator produces a sinusoidal waveform, given by the expression: (t) = -25 sin(150nt – 30°) V. (b) (i) (ii) (iii) (iv) (v) Determine the amplitude and phase. Find the frequency in Hz. Determine the period of the voltage in ms. Determine the instantaneous voltage at t = 3.215 ms. Find the RMS value of v(t).

An AC generator produces a sinusoidal waveform, given by the expression: (t) = -25 sin(150nt – 30°) V. (b) (i) (ii) (iii) (iv) (v) Determine the amplitude and phase. Find the frequency in Hz. Determine the period of the voltage in ms. Determine the instantaneous voltage at t = 3.215 ms. Find the RMS value of v(t).

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.10MCQ: The average value of a double-frequency sinusoid, sin2(t+), is given by (a) 1 (b) (c) Zero

See similar textbooks

Similar questions

The average value of a double-frequency sinusoid, sin2(t+), is given by (a) 1 (b) (c) Zero
Find the resultant of the two out of phase current If the component currents are 12 and 16 amp., respectively, and the corresponding sinusoidal wave are out of phase by 60 deg. Calculate the rms value of the voltage at a resistance of 50 kilo Ω?
Two units, connected in parallel, are energized by an a-c source. If the component currents are 15 and 19 amp, respectively, calculate the corresponding sinusoidal waves are out of phase by 60 electrical degrees, calculate the rms value of the total current.
Two electric devices A and B are connected in parallel, and the rms current in A is 15 amp. If the current in B lags behind A by pi/3 radians and the line current is 23.4 amp, determine the current in B.
An AC generator causes 50 Hz current in a circuit containing a 290 Ω resistor, 4.89 µF capacitor, 0.362 H inductor, and switch in series. At time t=0, the switch is closed at an instant when the voltage from the generator is 0 V. We measure the rms current as 41.1 mA. a) Write an expression for the instantaneous voltage (aka, the voltage as a function of time). v(t) = ______ b) Does the voltage lead or lag the current? Explain how you know. c) Draw a phasor diagram at an instant when the current is zero. Label the phase angle. d) Draw a phasor diagram at an instant when the current is maximum. Label the phase angle.
An audio power amplifier delivers a 30 volt RMS 1 kHz sine to a loudspeaker. If the loudspeaker impedance at this frequency is 7 at 45°, determine the RMS current delivered to the load and the true power.
Q.3/ Answer the following: A- Analternating voltage is given by V =220 sin 314t volt. Find: (1) the amplitude, the peak-to-peak value, (2) the r.m.s. voltage (3) the periodic time, the instantaneous value of voltage when 7 = 6 ms, (4) Draw the waveform, write the phase difference.
If the rms phasor voltage is given as V angle= 60-degree, then how v(t) can be written.
Determine the peak-to-peak voltages, RMS voltage, frequency, period and phase shift for the following expression: v(t) = −10 sin (2π 250 t + 180°).
Two electric devices A and B are connected in parallel, and the rms current in A is 15 amp. If the current in B lags A by p/3 radians and the line current is 23.3 amp, determine the current in B.
The rms output voltage of an AC source is 150 V and the operating frequency is 90 Hz. Which of the following equation gives the output voltage as a function of time? a. (150 ?) sin(283?)b. (150 ?) sin(565?)c. (212 ?) sin(283?)d. (212 ?) sin(565?)
An alternating voltage given by v = 120 sin (240t + п / 4) V, is applied to a coil withnegligible resistance and inductance of 100 mH. Determine (a) the reactance of thecoil, and (b) the RMS current flowing through the circuit.