Answered: An aerostat balloon is filled with…

An aerostat balloon is filled with hydrogen. It has a volume of 1000m^3 at constant air temperature of 270 C and pressure of 0.98bar. Determine the load that can be lifted with the air of aerostat.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.121P: One side of the container has a 03-m square door that is hinged at its top edge. If the container is...

See similar textbooks

Related questions

Q: The block is subjected to a force V = 48 kN. What is the resulting deflection Δ?

A: Given information:d1 = 3 cmd2 = 3.7 cmd3 = 4 cm

Q: Water flows at a rate of 2.4 ft³/s in an old, rusty 7.8-in.-diameter pipe that has a relative…

A: Given data:

Q: What size UNF bolt made from SAE grade 5 steel is needed to carry a static tensile load of 3000lb…

Q: The total volume of a new house is 685 m3. Before the heat is turned on, the air temperature inside…

Q: 2 Problem The mechanized arm shown below is simulatenously rotating upward and extending as it holds…

Q: Draw free-body diagrams (FBDs) for the specified rigid bodies. Then, write the coordinates of each…

A: Given:2 structures.To find:(a) Draw free body diagram of each.(b) Write the coordinates of each…

Q: Water flows at a rate of 2.4f * t ^ 3 / s in an old, rusty 7.8-in.-diameter pipe that has a relative…

A: Given;

Q: When a uniform stream flows past an immersed thick cylinder, a broad low- velocity wake is created…

A: The width is .

Q: A compressed tank contains water at 70 °C and unknown pressure. If the tank volume is 0.6 m3 and the…

Q: Q2) 3-40 The gage pressure of the air in the tank shown in Fig. P3 40 is measured to be 65 kPa.…

Q: At an amusement park there are 200-kg bumper cars A, B, and C that have riders with masses of 45 kg,…

Q: Two thick walls are separated by a vacuum gap of thickness L. A cylinder of diameter D runs between…

A: Given:To find:(a) Derive the expression for the shape factor.(b) Determine the value of the shape…

Q: The 2014-T6 aluminum rod has a diameter of 0.7 in. and fits snugly between rigid supports at A and B…

A: Given:To find:Reaction force at A and B.

Q: A Pelton wheel has to be designed for the following data. Power to be developed = 6 000 kW. Net head…

Q: flux plot of this set up and determine its shape factor.

A: Given the above drawing with entrance temperature as T1 and exit temperature as T2, determine the…

Q: 5 (1) Complete the following table for water. P, kPa T, °C v, m³/kg (a) 1200 (b) 500 (c) 160 187.96…

A: from the steam table we have to see the various data to fill the complete table (a) from the data…

Q: 4. The following data gives the height (in inches) of a sunflower plant as a function of time (days…

A: The MATLAB code to plot the height versus time is given below.1% Given data 2time_days = [10, 20,…

Q: Determine the z-coordinate of the mass center of the homogeneous paraboloid of revolution shown. 5…

A: At y = 5 in,z = 15 inTherefore, h = 15 in

Q: Figure 10 ft B 30 ft 15 ft 12.5 ft 10 ft. 15 ft W Part B Determine the tension developed in cable…

Q: Calculate the decrease of enthalpy of 2 kg of Butane from 2 MPa, 800 K and 100 kPa, 0.35 kg/m3, in…

Q: ****USE MATLAB TO SOLVE THIS QUESTION**** 5. A composite cantilever beam, made of High Strength (HS)…

A: Given thatthe uniform applied load length of the beam, width of the beam, Young's modulus, value of…

Q: Find: The magnitude of the horizontal component of the reac The magnitude of the vertical component…

A: The section AC -The section BC-

Q: Can you show me how to read that psychometric chart, please!

Q: 3/80 The 2-kg collar is at rest in position A when the constant force P is applied as shown.…

Q: DH table for WLKATA robot

A: Explanation of DH Parameters:θi (Joint Angle): This parameter represents the rotation about the…

Q: BFN ww -Pump BEND Wp known Boiler Qin Skam = Turbine T Wt 5.10⁰ kg/₁ kg/ Back work ratio Ⓒ Saturated…

Q: A tensile test is being conducted on a steel-rod specimen with a gauge length of L0=4.0 in and an…

A: given :Intial length Lo = 4 inInitial diameter do = 0.75 inFinal length Lf = 5.53 in

Q: The bars of the truss, shown in the Figure, are made of aluminium (yield strength-410 MPa), each…

Q: 3 Problem Consider a sled, modeled as a particle P of mass m = 100 kg, moving down a snowy hill. At…

Q: Determine the acceleration of the ball

A: To find the acceleration of the ball.given, the ball displacement by the spring, x = 2mthe velocity…

Q: 2. A 35 cm diameter solid sphere (p=450 kg/m³) is Suspended by a cable as shown below. Half of the…

A: The free-body diagram is as follows-Where,T=tension in the cableW=weight of the spherebuoyancy…

Q: Solve the heat equation u, = 0.2u on a digital computer using the Crank-Nicolson scheme. for the…

Q: Q1: A large slab of steel 0.1 m thick has in it a 0.1 m-diam hole, with axis normal to the surface.…

A: Given:To find:Rate of radiative heat loss from the hole.

Q: Consider the bar in Figure 2 loaded as shown. Determine the nodal displacements, stress in each…

A: Given:To find:(a) Nodal displacements.(b) Stress in each element.(c) Support reaction.

Q: 3-37E A spring-loaded piston-cylinder device is initially filled with 0.2 lbm of an R-134a…

A: Given:Find:The final temperature and enthalpy of R-134a.

Q: The frame supports a cylindrical container containing money, the container with the money weighs…

Q: The magnitude of the force F is 120 N. Find the moment of F about the axis AB using (a) the vector…

Q: Q2. A 2 lb of steam, initially at 700 lbf/in.², 550°F undergoes a polytropic process in a piston-…

A: The mass of the steam, The initial pressure, The initial temperature, The final pressure, The…

Q: (Suppose you need to design a tension test machine capable of testing specimens that have nominal…

A: Given data:Ultimate stress, σu = 100 ksidiameter of the specimen, d = 0.5 in (from the given…

Q: A Д 2q a | P=2qa C q а В

A: Note:- As per the honor code and answering guidelines I can answer 1st question (As both questions…

Q: ₁ of 5 rad/s in the direction angular velocity of gears have the following diameters

Q: Replace the loading by an equivalent resultant force and couple moment at point O. Suppose that F₁ =…

A: Given:The forces are and .Coordinates of the point .The coordinate of the point where force is…

Q: I will be selling a Summer Camp Innovative Sleeping System (SCISS) that suspends beds from the…

A: Calculate the total downward force acting on the system:Total downward force = (bottom beds) (top…

Q: Two kg of Argon at 25 deg C, 1 bar are contained in a rigid tank connected by a valve to another…

Q: Air expanded from 0.05m3 to 0.3m3 with a temperature change of 20K at a constant pressure of 3atm.…

Q: Plot the variation of Ex, Gxy, νxy, mx, and my for a lamina with the following properties: EL = 35…

A: Given:To find:Plot the variation of Ex, Gxy, νxy, mx, and my for a lamina.

Q: What I am struggling to understand from this problem. (1) Why does the external load not show up in…

A: The force F=400 N acts at point C.When drawing free body diagrams (FBD) of individual members, we…

Q: Refrigerant-134a, at 1.5 MPa, 90 °C, is to be cooled by air to a state of 1 enters at 110 kPa, 25 °C…

A: For refrigerant-For air-

Q: what is the volume of a unit cell of an orthorhombic crystal system

A: Given:Orthorhombic crystal systemRequired:Volume of a unit cell of orthorhombic crystal system

Q: 1. Consider a unity-feedback control system whose open-loop transfer function is given by: k(s+4)…

A: Use the Routh-Hurwitz criterion to determine the range of k for which the system is stable.The…

Question

An aerostat balloon is filled with hydrogen. It has a volume of 1000m^3 at constant air temperature of 270 C and pressure of 0.98bar. Determine the load that can be lifted with the air of aerostat.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Understand the Concept of Aerostat Balloons

VIEW

Step 2: Convert Pressure to Pascal

VIEW

Step 3: Establish the Gas Constant for Hydrogen

VIEW

Step 4: Calculate the Mass of Hydrogen in the Aerostat

VIEW

Step 5: Determine the Load that can be Lifted

VIEW

Solution

VIEW

Step by step

Solved in 6 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

One side of the container has a 03-m square door that is hinged at its top edge. If the container is filled with water, determine the smallest force F that must be applied to the bottom edge of the door to keep it closed.
The test tube opens at 293 K with 13 cm Hg at the bottom, and 5.6 cm water above Hg. Calculate the pressure at the bottom of the tube if the atmospheric pressure is 760 mm Hg. Use a density of 13.55 g / cm3 for Hg and 0.998 g / cm3 for water. Give answers in terms of dyne / cm2, psia, and kN / m2 • (See conversion table). = kPa. = ..... dyne / cm2. = .... psia = ....
A tire having a volume of 3 ft3 contains air at a gage pressure of 26 psi and a temperature of 70°F. Determine the density (slugs/ft3) of the air contained in the tire. For air, R = 1.716 x 103 ft-lb/slug-°R.
A gas is contained in a vertical, frictionless piston– cylinder device. The piston has a mass of 5 kg and a cross-sectional area of 35 cm2. A compressed spring above the piston exerts a force of 75 N on the piston. If the atmospheric pressure is 95 kPa, determine the pressure inside the cylinde
A spherical balloon containing Oxygen (initially at sea level) has a radius of 8 inches. If the uniform density of air is 0.07498lb/ft3 and that the pressure at sea level is 14.7psia, determine the new radius (inch) of the balloon if it has been brought above sea level by 6000ft.
The initial pressures at A and B are the same at 103 kPa. If the pressure at the liquid at A (SG1 = 1.25) is increased to 148 kPa while keeping the pressure at B constant, determine the new position (Δh, in mm.) of the mercury meniscus inside the tube as shown. Assume no change in the liquid densities. The connecting tube is a 1-cm in diameter, Y1 = 0.51 cm, and the inclination of the tube is 18 degrees with respect to the horizontal. Assume unit weight of air to be negligible.
2. A spherical balloon containing Oxygen (initially at sea level) has a diameter of 8in. If the uniform density of air is 0.07498lb/ft3 and that the pressure at sea level is 14.7psia, determine the new diameter (inch) of the balloon if it has been brought above sea level by 6000ft. Draw a figure or FBD that will support the problem. Explain each step by step formula.
A gas under a pressure of 1 MPa absolute has a specific weight of 99 N/m^3. What is the value of R for the gas if T = 60°C?
A tire having a volume of 3 ft3 contains air at gage pressure of 26 psi and a temperature of 70 °F. Determine the weight of air (in pounds) contained in the tire.
A gas is contained in a vertical, frictionless piston– cylinder device. The piston has a mass of 2.10 kg and a cross sectional area of 8 in². A compressed spring above the piston exerts a force of 24 lbf on the piston. If the atmospheric pressure is 99 kPa, determine the pressure inside the cylinder. Draw the schematic diagram.
Nitrogen is compressed to a density of 4kg/m^3 under an absolute pressure of 400kPa. determine the temperature in degree celcius.
A rock weighs 60 N in air and has a volume of 2.5 x103 m³. The weight of the rock when submerged in water is