Answered: An air compressor used for spraying…

An air compressor used for spraying paint has a tank of capacity 0.40 m that contains air at 27°C and 6.0 atm. How many moles of air does the tank hold? (A) 56.9 mol B) 97.5 mol 75.1 mol D) 88.4 mol

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter11: Temperature And Temperature- Related Variables In Engineering

Section: Chapter Questions

Problem 9P: Calculate the R-value for the following materials: a. 4 in. thick brick b. 10 cm thick brick c. 12...

See similar textbooks

Related questions

Q: Due to rise in temperature, the viscosity and unit weight of percolating fluid are reduced to 70%…

Q: A 0.025-cubic meter metal block is tied to one end of a 3000-mm long square wooden plank with…

A: Given, The volume of metal block=0.025 m3 Dimensions of wooden plank=210mm×210mm×3000mm Weight of…

Q: 15m SAE 30 ol Water 25m Oiive ol 29m Mercury 04m

Q: FLUID MECHANICS-WATER HAMMER: A valve at the end of a gasoline pipeline is rapidly closed (assume…

Q: Subject: Fluid Mechanics/Hydraulics 1.) What is the specific weight of air in N/m3 at 442 kPa…

Q: Calculate the volume and surface area of a solid cylinder 1.5 m diameter and 2.5 m tall.

A: Given- Solid cylinder-Diameter d=1.5 mHeight h=2.5 m

Q: If the atmospheric pressure is 101.3 kPa and the absolute pressure at the bottom of the tank as…

A: Given: The atmospheric pressure is 101.3 kPa. The absolute pressure at the bottom is 251.3 kPa. The…

Q: Oil of specific gravity 0.82 flows through an orifice at the vertical side of a closed cylindrical…

Q: By what percent is the volume of water decreased if its pressure is increased to an equivalent to…

A: To determine the percent decrease in volume of water for given increase in pressure and Bulk…

Q: A liquid having a Reynolds number of 1900 flows thru a 200mm diameter pipe 150m long. The head loss…

A: Given: Reynold's number of the flow, Re = 1900 Diameter of the pipe, d = 200 mm = 0.2 m Length of…

Q: 3. A liquid which is compressed in a cylinder has a volume of 1200 cm' at 1.2 MN/m² and 990 cm' at 2…

A: The proportional reduction in the material thickness under some specified conditions of improved…

Q: SAE 30 oil 15m Water 2-5m Olive oil 29m Mercury 04m

Q: Calculate the specific volume of oxygen in kg/m^3 at 20deg C and 40 kPa abs. a.23.6 b.1.90 c.5.15…

A: Given Pressure P = 40 kpa

Q: oil of viscosity 9 poise is flowing through a horizontal pipe of 60 mm diameter. the flow is…

A: Given data; Viscosity of oil = u = 9poise Diameter of pipe=D = 60mm Pressure drop = 1800kN/m² Length…

Q: A plunger (54 mm Ø and 0.5 m long) is moving through a horizontal cylinder (60 mm Ø) containing oil…

Q: An open tank has a vertical partition and on one side contains gasoline with a density p = 700 kg/m³…

A: Gate will start to open when the force from water side will be greater than gasoline side When Force…

Q: If a vessel that contains 9.2 ft3 of water at 50°F and atmospheric pressure is heated to 160°F, What…

Q: Problem #1. The pressure on a closed tank reads 58.86 kPa. a. What is the equivalent height in…

Q: In figure below, what is the pressure in pounds per square inch at A?

Q: Water is flowing through a 2 inch diameter pipe at a velocity of 4.3 ft/s. If the length of the pipe…

A: Given: Diameter, D = 2 in Velocity, v = 4.3 ft/s Length, L = 100 ft Kinematic viscosity = 1.21 x…

Q: Find the specific gravity of the material. b. How much weight is required to fully submerge the…

A: Given data: side = 4 in SG = 0.82

Q: a cylindrical vessel has 0.5m diameter and 1m height rotates at 10rad/s. initial height of Mercury…

Q: The cylinder in the figure is to be placed in fresh water. The top potion of the cylinder is foam…

Q: A horizontal cylindrical tank has an inside diameter of 5 ft. and an inside length of 18 ft. Oil…

A: Given: The diameter of the tank is 5 ft. The length (L) is 18 ft. The initial level is 45 in below…

Q: 200 cm 20 cm 60 cm 3. The cylinder in the figure is to be placed in fresh water. The top potion of…

A: To find Specific weight of cylinder?

Q: Problem 29: A light foam cup similar to a disposable coffee cup has a weight of 0.05 N. A steel bar…

Q: Groundwater table (free surface) Direction of seepage Impervious layer A permeable soil layer is…

Q: 24. A mercury barometer at the base of a mountain reads 736 mm. At the same time, another barometer…

A: Note : According to our company's guidelines we are allowed to solve 1st 3 questions only. Let A be…

Q: Question 1 5 Marks The air-oil-water system shown below is at 21°C. Gauge A reads 11 kPa and gauge B…

Q: 2. Calculate the actual work done on the 200 g mass using W = mgh. Be careful to use only the change…

A: The given data is: Mass=200 g The work done, W=mgh The work done to raise the mass to the C…

Q: The tank shown contains a liquid having a density of 1.22 slug/ ft^3 Determine the weight of the…

Q: If the atmospheric pressure is 101.30 kPa and the absolute pressure at the bottom of the tank as…

Q: An oil of density 892 kg/m³ is flowing in a pipe having an internal diameter 5cm. This pipe is…

Q: A gas expands from 0.03 m3 to 0.05 m3 at constant pressure of 3.5 atm. Determine the work done.

A: The initial volume is V1=0.03 m3. The final volume is V2=0.05 m3. The pressure is P=3.5 atm. The…

Q: A closed cylindrical tank 5m high contains 2.5m of water. A 100mm diameter circular orifice is…

A: To find the air pressure above surface of water

Q: Oil (relative density or specific gravity of 0.8) flows through a pipe. the diameter is 50 cm. The…

Q: 2. Freshwater and saltwater flowing in parallel horizontal pipelines are connected to each other by…

A: Considering the following points as shown in the figure below: Given data, ρHg = 13600 kg/m3 ρw =…

Q: A calibration test of a 12.5 mm diameter circular sharp-edged orifice ina vertical side of a large…

A: Given data, Horizontal distance (x) = 2.35 m Vertical distance (y) = 0.3 m Water height (H) = 4.7m…

Q: The pressure on a closed tank reads 58.86 kPa. What is the equivalent height in water? a. b. What is…

Q: A square plate 50 cm × 50 cm weighing 200 N slides down an inclined plane of slope 1 vertical: 2.5…

A: Solution: Given data: Considering the Diagram Area of plate=A=50×50=2500 cm2=0.25 m2Weight of…

Q: A 300 mm diameter test well penetrates 27 m below the static water table. After 24 hours of pumping…

Q: Empty weight of pycnometer + fully filled water : 1387 grams what is the value of W2 ?

A: Given : Specific gravity GS= 4.45 Empty weight of pycnometer W1=529 g Empty weight of pycnometer +…

Q: Water flows through a 5 inch diameter pipe at 10 ft/s. If a test is performed using mercury moving…

A: Given, For water Velocity = 10 ft/s Diameter = 5 inch For Mercury Velocity = 4 ft/s

Q: Calculate the dynamic viscosity of oil, which is used for lubrication b/w a square of size 0.8 x 0.8…

Q: Oil flows thru a 50 mm diameter pipe having a head loss of 12 m. The length of the pipe is 120 m.…

A: Given, Diameter of pipe (D) = 50mm Head loss (hL) = 12m Length of the pipe (L) = 120m Reynolds…

Q: A pump discharges water through a horizontal pipeline at 30 L/s. At a point in the suction side of…

A: Given data, Q = 30 L/s Suction side Diameter (D1) = 100 mm Suction side pressure (p1) = 125 Kpa…

Q: What height of mercury column is equivalent to a pressure of 74 psig? The density of mercury is 498…

Q: Water with kinematic viscosity equal to 1.02 x 106 m2/s flows in a 1000m long, 150mm diameter pipe…

A: Given data in question Kinematic viscosity Length Diameter Rate To find out Head loss

Q: Calculate the volumetric flow rate of oil flowing in a circular pipe of 50 mm diameter. The Reynolds…

A: Given data- circular pipe dia D=50 mm=50×10-3 mReynold's number Re=2320Density ρ=920 kg/m3Dynamic…

Q: A liquid rises to a height of 9 cm in a glass capillary tube of diameter 0.04 cm. What will be the…

Question

An air compressor used for spraying paint has a tank of capacity 0.40 m that contains air at 27°C and 6.0 atm. How many moles of
air does the tank hold?
(A) 56.9 mol
(B) 97.5 mol
(c) 75.1 mol
88.4 mol

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

SAE 30 oil is contained in a cylinder with inside diameter of 1 in. and length of 1 ft. What is the pressure required to decrease the volume of the oil by 2%?
Determine the pressure required to reduce the given volume of water by 1 % (Bulk modulus or water=2x108 N/m2)
Determine the rate of flow of water through a pipe of diameter 10 cm and length 60 cm when one end of the pipe is connected to a tank and other end of the pipe is open to the atmosphere. The height of water in the tank from the centre of the pipe is 5 cm. Pipe is given as horizontal and value of f= 0.01. Consider minor losses.
The surface tension of water in contact with air at 20°C is 0.0725N/m. the pressure inside a droplet is to be 0.02N/sq.cm greater than the outside pressure. Calculate the diameter of the droplet.
A tank of surface area 22m² contains water up to a depth of 5.8m. What will be : i) Weight of water in the tank ii) Pressure intensity at a point at the bottom of the tank iii) Total pressure at the bottom of the tank What have you concluded from the result?
Water with kinematic viscosity equal to 1.02x10^-6 m^2/s flows in a 1000m long. 150mm diameter pipe (E=0.00005) at a rate of 30L/s. solve for the head loss in the pipe. use 3 decimal places.
Q5. A brass cube “R” inch on a side weighs (Rx10)lb.Hold this cube in equilibrium underwater by attaching light foam buoy to it. If the unit weight of foam is 4.5 lb/ft3, calculate the minimum required volume of the buoy? (where R is ) 32)?
A right circular cone 4m in diameter at the base if 4m high has a super imposed right circular cylinder having a diameter of 4m and a height of 4m. How long will it take to empty its content through an orifice 1000 sq.cm at the vertex. Use C=0.60.
A plunger (54 mm Ø and 0.5 m long) is moving through a horizontal cylinder (60 mm Ø) containing oil at a speed of 8 m/sec that has a viscosity of 7.1x10-6 m2/sec and specific gravity of 0.84. Calculate the force needed to maintain its velocity. Use 2 decimal places.
A volume of 1 cu. meter of water is subjected to a pressure increase of 18 MPa Compute the change in its volume in m3 if it has a bulk modulus of 2942 MPa. Round your answer to 4 decimal places.
If 200 ft3of oil weighs 10,520 lb, calculate its specific gravity.
A cylindrical tank having a diameter of 1.5 m and a height of 4 m is open at one end and close at the other end. It is placed below the water surface with its open end down. How deep below the water surface should the tank be placed if the depth of the water inside the tank is 1.8 m? a.6.0 cm b.5.90cm c.6.25cm d.7.0cm show your complete solution