An algal bloom has a biomass of 5.0 mg/L. Assuming the algae remains suspended in the water column, how much algae will remain 2 weeks after the bloom has died? Assuming K, = 30y K2 = 3 y and that the reactive and non reactive fractions comprise 70%, and 20% of the organic matter respectively. Select one: a. 10 mg/L b. 5 mg/L C. 2.5 mg/L d. 3 mg/L

An algal bloom has a biomass of 5.0 mg/L. Assuming the algae remains suspended in the water column, how much algae will remain 2 weeks after the bloom has died? Assuming K, = 30y K2 = 3 y and that the reactive and non reactive fractions comprise 70%, and 20% of the organic matter respectively. Select one: a. 10 mg/L b. 5 mg/L C. 2.5 mg/L d. 3 mg/L

Appl Of Ms Excel In Analytical Chemistry

2nd Edition

ISBN:9781285686691

Author:Crouch

Publisher:Crouch

Chapter3: Statistical Tests With Excel

Section: Chapter Questions

Problem 6P

See similar textbooks

Similar questions

The bisulfate (or hydrogen sulfate) anion, HSO4 , is a weak acid. The equilibrium constant for the aqueous acid reaction HSO4 (ag) = H* (ag) + SO,2- (ag) is 1.2 x 10-2 (a) Calculate AG° for this equilibrium. Assume a tempera- ture of 25.0°C. (b) At low concentrations, activity coefficients are approxi- mately 1 and the activity of a dissolved solute equals its molality. Determine the equilibrium molalities of a 0.010-molal solution of sodium hydrogen sulfate.
Gypsum (CaSO4) is a common percipitant in water desalination. CaSO4 <=> Ca2+ + SO42- where Ksp=10-4.6. Assuming that: [Ca2+]=2x10-2 M; [SO42-]=2x10-3M: a) Find Qsp or IAP for the given water b) Find the solubility index (SI) and determine whether CaSO4 is under, super, or at saturation in water. Feel free to make any assumptions you wish, as long as they're stated.
You work with two amino acids. Tryptophan (MW=204 Da) and Methionine (MW=149 Da). You make varioussolutions of each amino acid separately and compare them When you compare two solutions at the same percentage concentration (e.g. 1%), there are moremoles of Tryptophan in solution than moles of Methionine because the molecular weight of Tryptophan ishigher. When you compare two 1-liter solutions containing these amino acids at a 10mM concentration, thereis the same number of amino acid molecules in each solution
5. Barium chloride is reacted with sodium sulfate to produce barium sulfate and sodium chloride. How many moles of the precipitate is produced from 0.8 moles of BaCl2?A. 0.4 moleB. 0.8 moleC. 1.6 molesD. None of the above 6. 315mL of water was added to 2100 mL of 19M NaCl solution. What is the new concentration of the solution?(Use the given information: MW: Na = 23g / mol , CI=35g/mol)A. 2.85 MB. 2.48 MC. 18.60 MD. 19.0 M
In one experiment, 0.0995M HCl was used to analyze soda ash and the following data were obtained: 0.2980 g Mass of Na2CO3 Initial reading of HCI Final reading of HCI 0.20mL 20.00mL What is the net volume in liters of HCl used? How many moles of Na2CO3 was used in the analysis? What is the corresponding Normality of the HCl used? What is the percent Na2CO3 in the soda ash sample?
A 10 ml of concentrated acetic acid was added in a sufficient quantity of water to make 350 ml of the acid solution. SG acetic acid= 1.05 kb acetate = 5.556x10^-10 What is the weight of acetic acid in grams? What is the molarity (mole/Liter) of acetic acid solution? What is the ka of acetic acid? What is the Hydronium ion concentration? What is the pH of the solution?
Which parameter is measured by determining the drop in dissolved oxygen in a sealed water or wastewater sample for a fixed number of days? microbial count COD BOD phosphorus nitrogen
Solubility data of 2 furoic acid are as the following 1.0g/26mL water at 15 degrees Celsius and 1.0g/4.0ml of water at 100 degrees Celsius .How much hot water do you use to purify 2.0 g of impure furoic acid by recrystallization ? a) 8.0mL water b) 2.0mL water c) 20.mL water d) 52.mL
You have a 5.0 ml sample of a protein in 0.5M NaCl. You place the protein/salt sample inside dialysis tubing and place the bag in a large beaker of distilled water. Your goal is to remove as much NaCl from the sample as possible. Since you know that the final salt concentration will be the same inside the tubing as out, you can calculate the final concentration of the salt. a)=0.62 B.What would the final salt concentration be if instead of placing the dialysis bag in 4.0 L of distilled water for 12 h, you placed the bag in 1.0 L of distilled water for 6.0 h and then in another 1.0 L of fresh distilled water for another 6.0 h? ___mM
if 0.200 L of 0.335 M Ca(NO3)2 and 0.300 L of 0.077 M Na2CrO4 are mixed, what is the Qip? Ksp for CaCrO4(s)= 7.1 x10^-4
Tc-99m sulfur colloid is to be reconstituted with 75 mCi Tc-99m pertechnetate, to be drawn from an eluate with activity concentration of 325 mCi/mL. You will add constituents totaling 2.5 mL to the kit. What volume of eluate and of normal saline should be added to reach 5 mL final volume?
Table 1: Temp vs. solubility data of ammonium chloride. Test tube g NH4Cl/10 mL H2O Crystallization temp. (ºC) 1 1.0 g/10 mL H2O 10 oC 2 1.8 g/10 mL H2O 20 oC 3 2.9 g/10 mL H2O 40 oC 4 3.8 g/10 mL H2O 65 oC 5 4.4 g/10 mL H2O 95 oC Use the table to plot a solubility curve for ammonium chloride on the graph provided below. For the best fit line, use a smooth curve. "Mass of Solute per 100 mL of H2O," should be written on the y-axis (use increments of 2g for every box). "Temperature (°C)" should be written on the x-axis (use increments of 10 °C for every 2 boxes).