The water sample from the polluted estuary (number 4), was then subjected to a series of instrumental analysis like chromatography and spectroscopy to determine the exact identities of the pollutants. What kind of analysis are done to the unknown? a. Qualitative analysis b. Quantitative analysis c. Characterization analysis d. Fundamental analysis

The water sample from the polluted estuary (number 4), was then subjected to a series of instrumental analysis like chromatography and spectroscopy to determine the exact identities of the pollutants. What kind of analysis are done to the unknown? a. Qualitative analysis b. Quantitative analysis c. Characterization analysis d. Fundamental analysis

Chemistry & Chemical Reactivity

10th Edition

ISBN:9781337399074

Author:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Publisher:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Chapter4: Stoichiometry: Quantitative Information About Chemical Reactions

Section4.9: Spectrophotometry

Problem 3.1ACP

See similar textbooks

Similar questions

Approximately 6.0mL of concentrated perchloric acid (70%) was transferred to a bottle and diluted with about 1.0L of water. A sample containing 251.5 mg of primary standard Na2B4O7.10H2O required 27.41 mL of the HClO4 solution to reach the methyl red end point. Calculate the molar concentration of the HClO4 (Fwt = 382g/mole)
Volumetric Analysis The mass of KHC8H4O4 is measured to the nearest milligram; however, the volume of water in which it is dissolved is never of concern—water is even added to the wall of the Erlenmeyer flask during the titration. Explain why water added to the KHC8H4O4 has no effect on the data, whereas water added to the NaOH solution, may drastically affect the data.
. 100 ml boiled cooled and filtered water sample takes 9.6 ml of M/50 EDTA in titration. The Permanent hardness of the water sample in terms of ppm of CaCO3 equivalent is
100 mL water sample was subjected to DO analysis using the Winkler method. The initial reading of the titrant (0.025 M Na2SO3) in the buret was 2.51 mL. The endpoint was obtained and the final reading was 7.07 mL. A blank was also titrated and 0.75 mL of the titrant was consumed. Compute for the amount of DO (mg/L) in the sample.
A suitable target for the titration is 30.0 cm3 of 0.025 moldm-3 Br2(aq) Justify why a much smaller target titre would not be appropriate Calculate the amount in moles of bromine in the target titer Justification? calculate a suitable massof alive oil to transfer to the volumetric flask using your answer to of above question and the structure of Y Assume that the olive oil contains 85/- of Y by mass (If you were unable to calculate the amount of bromine in the target titer,you should assume it is 6.25×10^-8 mol .this in not the correct amount)
7. 3.0g of impure anhydrous sodium carbonate was dissolved in water to make 250cm3 of solution. 25.0cm3 of this solution required 21.0cm3 of 0.10M hydrochloric acid for complete reaction using methyl orange indicator. Calculate the percentage purity (and impurity) of sodium carbonate
The Kjedahl procedure was used to analyze 256 µL of a solution containing 37.9 mg protein/mL. The liberated NH3 was collected in 5.00 mL of 0.033 6 M HCl, and the remaining acid required 6.34 mL of 0.010 M NaOH for complete titration. What is the weight percent of nitrogen in the protein? wt%
A piece of Gold weighing 12,359 Kg is suspected of being contaminated with Iron. To perform an instrumental analysis and To confirm whether or not it contains Fe, a portion of the sample (0.954 g) is taken from the piece and dissolved with 25 mL of aqua regia. Heats up For its complete dissolution, it is cooled and made up to 100 mL. A 10 mL aliquot is taken from this solution and made up to 50 mL. From This last solution is given the appropriate treatment to visualize Fe+2, for which the 1,10-phenanthroline reagent is added. (it forms a complex that is red in color) and is taken to a visible spectrophotometer and with a 12 mm cell a absorbance of 0.45. Previously, a calibration curve of Fe+2 was obtained under the same instrumental conditions obtaining the following data: (view table) Calculate the purity of the gold piece, assuming impurities only due to Fe.
1. Why is there a need to correct conductivity of the sample solution?2. Cite three possible sources of error in the experiment and discuss their effects on the computed ionization constant of the acetic acid. (See details below----- literature value- Ki, acetic acid= 1.75 x 10^-5). 3. What is the effect of dilution on the fraction of the acetic acid ionized?
On the redox titration experiment, Standardization of Na2S2O3 with KIO3 standard solution, what can be replaced KIO3 to make safer solvent and auxiliaries( reduced toxic waste)? explain why?
a) When considering the overall dialysis procedure, why is it important to exchange old/used dialysis buffer (or “dialysate” solution) with a fresh dialysis buffer solution at least once throughout the process? NOTE: Your TAs will do this for your group’s samples over the next week. b) This week’s lab utilizes a dialysis buffer with the following composition: 10 mM Tris-HCl, 10 mM MgSO4, and a pH of 7.4. Let’s presume an ERROR occurred with the creation of this buffer during the pH titration and you unknowingly titrated to a final pH of 5.0. What effects, if any, could you expect to observe on your final, dialyzed sample?
A sample is known to contain about 20% soda ash. What sample size should be taken for analysis, if it is to be dissolved into a 50 mL volumetric flask, with 10 mL aliquots analyzed, if it is desired that the analysis consume a total of 40 mL 0.10 M HCl with 10 mL of 0.10 M NaOH used in the back-titration, after boiling.