An athlete doing sports activities running in the hot sun. Before doing the activity, the physiological parameters of the athlete were as follows: Tcore = 36.5ºC and HR = 83 bpm. After running for 5 km, the physiological parameters reached Tcore = 38.1ºC and HR = 140 bpm. Perform analysis using the physiological strain index and interpret the results of your analysis.

An athlete doing sports activities running in the hot sun. Before doing the activity, the physiological parameters of the athlete were as follows: Tcore = 36.5ºC and HR = 83 bpm. After running for 5 km, the physiological parameters reached Tcore = 38.1ºC and HR = 140 bpm. Perform analysis using the physiological strain index and interpret the results of your analysis.

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter19: Temperature, Thermal Expansion And Gas Laws

Section: Chapter Questions

Problem 79PQ

See similar textbooks

Similar questions

A student foolishly attempts to stop a steel bar, of length L = 1 m and at a temperature of 20ºC, from thermally expanding by attaching it to a wooden support with a nail at each end. Steel's Young's modulus is Y = 1.1 × 1011 N/m2 and it's linear thermal expansion coefficient is α = 13 × 10-6 1/C. Randomized Variables Y = 1.1 × 1011 N/m2α = 13 × 10-6 1/C What is the volue of the stress, in pascals, that develops due to a rise of temprature to 21 C? Assuming the nails have a cross- sectional area of A= 10^-5 m^2 all of which is perpendicular to the stress force from the bar, what is the force acting on each due to that temperature rise?
A plastic bar ACB having two different solid circular sections is held between rigid supports as shown in the figure. The diameters in the left- and right-hand parts are 50 mm and 75 mm, respectively. The corresponding lengths are 230 mm and 320 mm. The modulus of elasticity E is 6 GPa & the coefficient of thermal expansion α is 10-4 /0C. The bar is subjected to uniform temperature increase of 300C. Determine: i. maximum compressive stress in the bar. ii. displacement of point C.
1. The time required for peanut oil to flow between the two marks on the Ostwald pipette was 2,400 sec and 120 sec for water at 25°C. The ρ of peanut oil is 2.5 and that of water is 0.997. The η of water is 0.8904 cp at this temperature. What is the kinematic viscosity of peanut oil? a. 0.04 cstokes b. 17.86 cstokes c. 2.84 cstokes d. None of the choices e. 22.33 cstokes 2. Calculate the amount of sodium chloride to be added in a 100 mL solution of 1% drug solution with L iso value of 2.2 ˚C/M. MW = 216.32 g/mol using Freezing point depression method. a. 1.45 g b. 0.73 g c. 0.88 g d. 1.77 g
Atmospheric pressure atop Mt. Everest is 4 2 3.30x10 N/m . (a) What is the partial pressure of oxygen there if it is 20.9% of the air? (b) What percent oxygen should a mountain climber breathe so that its partial pressure is the same as at sea level, where atmospheric pressure is 1.01 × 10^5 N/m^2 ?
1.) It is found from a calculation thatQ=AB2/√C. What is the value of Q for: (a) A= 1500.0 kg^2,B= 1.4×10^−2m, and C= .025s^4? (b) A= 1500.0 kg^−2,B= 1.4×10^−2m^−1, and C= .025s^−4?
A solid aluminum alloy [E=69 GPa; α=23.6×10−6/C∘] rod (1) is attached rigidly to a solid brass [E=115 GPa; α=18.7×10−6/C∘] rod (2), as shown in the figure. The compound rod is subjected to a tensile load of P=5.3 kN. The diameter of each rod is 11 mm. The rods lengths are L1=507 mm and L2=705 mm. Compute the change in temperature required to produce zero horizontal deflection at end C of the compound rod.
How much stress is cleated in a steel beam if its temperature changes from 15 to 40 but it cannot expand? For steel, the Young's modulus Y=210109N/m2 from Stress, Strain, and Elastic Modulus (http://cnx.org/content/m58342/latest/#fs-id1163713086230). (Ignore the change in area resulting from the expansion.)
(a) Given that air is 21% oxygen, find the minimum atmospheric pressure that gives a relatively safe partial pressure of oxygen of 0.16 atm. (b) What is the minimum pressure that gives a partial pressure of oxygen above the quickly fatal level of 0.06 atm? (c) The air pressure at the summit of Mount Everest (8848 m) is 0.334 atm. Why have a few people climbed it without oxygen, while some who have tried, even though they had trained at high elevation, had to tum back?
How much stress is created in a steel beam if its temperature changes from –15 °C to 40 °C but it cannot expand? For steel, the Young’s modulus Y = 210 × 109 N/m2 from Stress, Strain, and Elastic Modulus .
The maximum flow rate of standard shower heads is about 3.5 gpm (13.3 L/min) and can be reduced to 2.75 gpm (10.5 L/min) by switching to low-flow shower heads that are equipped with flow controllers. Consider a family of four, with each person taking a 5-min shower every morning. City water at 15°C is heated to 55°C in an electric water heater and tempered to 42°C by cold water at the T-elbow of the shower before being routed to the shower heads. Assuming a constant specific heat of 4.18 kJ/kg·°C for water, determine (a) the ratio of the flow rates of the hot and cold water as they enter the T-elbow and (b) the amount of electricity that will be saved per year, in kWh, by replacing the standard shower heads by the low-flow ones.
The band in the figure below is stainless steel (coefficient of linear expansion = 17.3 ✕ 10−6°C−1; Young's modulus = 18 ✕ 1010 N/m2). It is essentially circular with an initial mean radius of 4.8 mm, a height of 4.2 mm, and a thickness of 0.51 mm. If the band just fits snugly over the tooth when heated to a temperature of 79°C, what is the tension in the band when it cools to a temperature of 37°C? _____________N
A deep-sea diver should breathe a gas mixture that has the same oxygen partial pressure as at sea level, where dry air contains 20.9% oxygen and has a total pressure of 1.01 X 105 N/m2. (a) What is the partial pressure of oxygen at sea level? (b) If the diver breathes a gas mixture at a pressure of 2.00 X 106 N/m2, what percent oxygen should it be to have the same oxygen partial pressure as at sea level?