An experimental device imparts a force of magni-tude F = 225 N to the front edge of the rim at A to900 mm700 mmsimulate the effect of a slam dunk. Determine themoments of the force F about point O and aboutpoint B. Finally, locate, from the base at 0, a point Con the ground where the force imparts zero moment.B300 mm3050 mm

Solutiongiven dataF=225Ncosθ=35sinθ=45

An experimental device imparts a force of magni- tude F = 225 N to the front edge of the rim at A to simulate the effect of a slam dunk. Determine the %3D moments of the force F about point O and about point B. Finally, locate, from the base at O, a point C on the ground where the force imparts zero moment.

An experimental device imparts a force of magni- tude F = 225 N to the front edge of the rim at A to simulate the effect of a slam dunk. Determine the %3D moments of the force F about point O and about point B. Finally, locate, from the base at O, a point C on the ground where the force imparts zero moment.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter6: Beams And Cables

Section: Chapter Questions

Problem 6.66P: A uniform 80-ft pipe that weighs 960 lb is supported entirely by a cable AB of negligible weight....

See similar textbooks

Similar questions

The cable is loaded by an 80-lb vertical force at C and a horizonal force P at B. Determine P.
A 15-lb force acts at point A on the high-pressure water cock. Replace this force with (a) a force couple system, the force of which acts at point B; and (b) two horizontal forces, one acting at point B and the other acting at point C.
The 1800lbin. couple is applied to member DEF of the pin-connected frame. Find the internal force systems acting on sections 1 and 2.
Cable ABC of length 5 m supports the force W at B. Determine (a) the angles 1 and 2; and (b) the force in each cable segment in terms of W.
The cable AOB weighs 5.2 N/m. When the horizontal 30-N force is applied to the roller support at B, the sag in the cable is 5 m. Find the span L of the cable.
An experimental device imparts a force of magnitude F = 225 N to the front edge of the rim at A to simulate the effect of a slam dunk. Determine the moments of the force F about point and about point B. Finally, locate, from the base at 0, a point Con the ground where the force imparts zero moment.
At the shown position, the ground reaction forces measured using a force platform are 600N in the vertical direction (Fy) and 200N in horizontal direction (Fx). The mass of the limb below the knee is 4kg with the centre of gravity at the point G. Determine the forces and moment applied to the knee joint. Draw correct free body diagram using any part of the body shown below.
The 90-m microwave transmission tower is steadied by three guy cables as shown. Cable AB carries a tension of 11 kN. Express the corresponding force on point B as a vector.
If F=1kN,the magnitude of the vertical reaction force developed at the point B?
The pipe ABCDE is supported by ball-and-socket joints at A and D and by cable ECF that passes through a ring C with negligible friction and is attached to hooks at E and F. Knowing that the frame supports a uniformly distributed load of 1500 N/m along segment AB, do the following.1) Shows the correct vector representation of the resultant of the two tension forces acting at ring C. Note that T_CF = T_CE = T2) Explain along which line/axis you can sum moments to generate an equilibrium equation with only the magnitude of the tension force as the unknown. Explain your choice.3) Find the magnitude of the tension force.
A force of magnitude P = 180 N is applied to the stationary machine handle as shown. Write the force and moment reaction at 0 as vectors. Neglect the weight of the handle assembly.