Answered: An ideal gas ( = 1.4) Volume 2 m3 and…

An ideal gas ( = 1.4) Volume 2 m3 and if is compressed to 4x106 Pa adiabatic at Volume 0.5 m3. Calculate the work in that process

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter3: The First Law Of Thermodynamics

Section: Chapter Questions

Problem 67P: A monatomic ideal gas undergoes a quasi-static adiabatic expansion in which its volume is doubled....

See similar textbooks

Related questions

Q: A Carnot engine operates between 100°C and 20°C. How much ice can the engine melt from its exhaust…

A: Given: T1 = 100 degree C = 273 + 100 = 373 K T2 = 20 degree C = 20 + 273 = 293 K W = 5 x 104 J

Q: A heat engine with a monatomic ideal gas reversibly goes through the following cycle. A ⟶ B is an…

A: Given information:' Here, P and V are the pressure and the volume respectively and the subscript…

Q: In an isothermal reversible process, the internal energy is equal to zero A Yes B) No c) It depends…

A: Given: In an isothermal reversible process, the internal energy is equal to zero

Q: On a winter day, a certain house loses 5.00 × 108 J of heat to the outside (about 500,000 Btu). What…

A: On a winter day, a certain house loses 5.00 × 108 J of heat to the outside (about 500,000 Btu). What…

Q: In a constant-volume process, 214 J of energy is transferred by heat to 1.10 mol of an ideal…

A: (a) According to the thermodynamics law, the work done on the gas is, W=∫PdV At constant volume…

Q: Suppose 2.00 mole of an ideal gas of volume V1=3.50m3 at T1=300K is allowed to expand isothermally…

Q: Air in a piston cylinder occupies 0.12 cubic meter at 552 kPa. The air expands in reversible…

A: Given: The intial volume is 0.12 m3. The initial pressure is 552 kPa. The final volume is 0.24 m3.…

Q: A firebox is at 750 K, and the ambient temperature is 300 K. The efficiency of a Carnot engine doing…

Q: Distinguish between quasi-static and non-quasi-static processes?

A: The quasi static process is a thermodynamic process, and it occurs slowly enough for the system to…

Q: A Carnot engine uses Ethylene as its medium. The volumes at the beginning and end of the reversible…

Q: A monoatomic ideal gas is taken through the cycle A→B→C→A shown in the figure. Express all the…

A: A mono-atomic ideal gas is taken through the cycle and It does work and some heat transfer during it

Q: An engine using 1 mol of an ideal gas initially at 22 L and 448 K performs a cycle consisting of…

A: The P-V diagram of cycle is shown below. Write the formula for efficiency of this cycle as given…

Q: Helium is used in the Carnot engine where the volumes beginning with constant temperature heat…

Q: Calculate the work output of a Carnot engine when 4000 J of heat is transferred to the engine for…

Q: Find the final temperature of one mole of an ideal gas which has an initial temperature t K. The gas…

A: TInitial = t K Work, W = 9R Ratio of specific heats, γ = Cp / Cv = 4/3

Q: In an adiabatic process, 550 J of net work is done on a gas to significantly reduce its volume.…

A: Given Net work done on the gas= 550 J Process is adiabatic

Q: An ideal gas expands isothermally, performing 3.40 x 103 J of work in the process. Calculate (a) the…

A: (a) The change in the internal energy of the gas can be determined as, Here, n, cv and ΔT represent…

Q: A certain heat engine follows a cycle shown above. What is the thermodynamic work done by the…

A: The work done (W) in a thermodynamic process is given as the product of the applied pressure (P) and…

Q: A heat pump that operates based on an ideal Carnot cycle delivers output heat into a building at 312…

Q: low-pressure gas initially at 1 bar and occupying a volume of 2 m³ is isothermally compressed in a…

A: Given: The pressure of the gas is 1 bar. The initial volume is 2 m3. The final volume is half of…

Q: Consider the processes shown below for a monatomic ideal gas. p (atm) . 5 в A D 2 - 3 a. Find the…

A: Hi, I am solving the incorrect part. The process AD is an isobaric process. Write the expression for…

Q: A reversible isothermal process at constant pressure is to allow the system to expand without any…

A: we know that for Isothermal process: PV=nRT

Q: In a cyclic process, a heat engine absorbs 600 J of heat from a heat source, does work, and ejects…

A: The efficiency of a heat engine is, η=WQinη=Qin-QoutQin Here, Qin is the heat absorbed and Qout is…

Q: Three moles of a diatomic ideal gas are taken through a three process thermodynamic cycle. The gas…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: In the figure below you see the process done by 9.0 moles of an ideal gas with adiabatic constant…

Q: Compute the internal energy change and temperature change for the two processes involving 1 mole of…

A: a) Given: n= 1 mole Q=1500 J b) Given: n= 1 mole W=-1500 J

Q: Consider an inefficient engine that draws 200 J of heat from a hot reservoir at 100o C, converts 48…

Q: An ideal gas has undergoes two process AB and BC as shown in the figure below. 8 kJ of heat is…

Q: the work done during

A: The expression for the work done during an adiabatic process. Adiabatic process:- The thermodynamic…

Q: A low-pressure gas initially at 1 bar and occupying a volume of 2 m3 is isothermally compressed in a…

Q: You have 1.0 mole of ideal gas that undergoes an adiabatic change, going from 30.0°C to 10.0°C. What…

A: The expression of work-done for adiabatic change be given as, Where, R be defined as the gas…

Q: For an ideal gas in an isothermal process, there is no change in internal energy. Suppose the gas…

A: W is the work done and the process is isothermal.

Q: A cyclic thermodynamic process for an ideal gas has gone through four steps. The amount of heat…

A: we know that Q = U + W

Q: 10 moles of an ideal gas expands isobarically as shown in the process A→B. PA = PB = 190 kPa, VB =…

A: Given: The number of moles is 10. PA=PB=190 kPaVB=63 LVA=35 L

Q: Five grams of helium (molar mass = 4 g) expands isothermally at 400 K and does 9540 J of work.…

A: Given Data: The mass of helium is m=4g The molecular weight of helium is M=4 g/mol The temperature…

Q: A Carnot engine uses hydrogen as its medium. The volumes at the beginning and end of the reversible…

Q: A Carnot engine has a power output of 205 kW. The engine operates between two reservoirs at 8°C and…

Q: When 1.60 x 105 J of heat transfer occurs into a meat pie initially at 20.0°C, Its entropy increases…

A: solution as

Question

An ideal gas ( = 1.4) Volume 2 m3 and if is compressed to 4x106 Pa adiabatic at Volume 0.5 m3. Calculate the work in that process

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

What is the entropy change of 10 g of steam at 100 when it condenses to water at the same temperature?
Two moles of a monatomic ideal gas such as oxygen is compressed adiabatically and reversibly from a state (3 atm, 5 L) to a state with a pressure of 4 atm. (a) Find the volume and temperature of the final state. (b) Find the temperature of the initial state. (c) Find work done by the gas in the process. (d) Find the change in internal energy in the process. Assume Cv=5R and Cp=Cv+R for the diatomic ideal gas in the conditions given.
In an isochoric process, heat is added to 10 mol of monoatomic ideal gas whose temperature increases from 273 to 373 K. What is the entropy change of the gas?
Does the entropy increase for a Carnot engine for each cycle?
Find the work done in the quasi-static processes shown below. The states are given as (p, V) values for the points in the PV plane: 1 (3 atm, 4 L), 2 (3 atm, 6 L), 3 (5 atm, 4 L), 4 (2 atm, 6 L), 5 (4 atm, 2 L), 6 (5 atm, 5 L) and 7 (2 atm, 5 L).
Which of the following is true for the entropy change of a system that undergoes a reversible, adiabatic process? (a) S 0 (b) S = 0 (c) S 0
Check Your Understanding Why was it necessary to state that the process of Example 3.5 is quasi-static.
A Carnot engine operates in a Carnot cycle between a heat source at 550 and a heat sink at 20 . Find the efficiency of the Carnot engine.
On an adiabatic process of an ideal gas pressure, volume and temperature change such that pV is constant with =5/3 for monatomic gas such as helium and =7/5 for diatomic gas such as hydrogen at room temperature. Use numerical values to plot two isotherms of 1 mol of helium gas using ideal gas law and two adiabatic processes mediating between them. Use T1=500K,V1=1L, and T2=300K for your plot.
Steam to drive an old-fashioned steam locomotive is supplied at a constant gauge pressure of 1.75106 N/m2 (about 250 psi) to a piston with a 0.200-m radius. (a) By calculating pv , find the work done by the steam when the piston moves 0.800 m. Note that this is the net work output, since gauge pressure is used. (b) Now find the amount of work by calculating the force exerted times the distance traveled. Is the answer the same as in part (a)?
In a diesel engine, the fuel is ignited without a spark plug. Instead, air in a cylinder is compressed adiabatically to a temperature above the ignition temperature of the fuel; at the point of maximum compression, the fuel is injected into the cylinder. Suppose that air at 20 C is taken into the cylinder at a volume V1 and then compressed adiabatically and quasi-statically to a temperature of 600 C and a volume V2 . If =1.4 , what is the ratio V1/V2 ? (Note: static. In an operating diesel engine, the compression is not quasi-
A cylinder containing three moles of a monatomic ideal gas is heated at a constant pressure of 2 atm. The temperature of the gas changes from 300 K to 350 K as a result of the expansion. Find work done (a) on the gas; and (b) by the gas.