An inductive reactance of 10 W is connected in parallel with a capacitive reactance of 30 W. If the combination is connected in series with a 10 W resistance, solve for total real power if the whole circuit is connected across a 240 V 60 hz supply

An inductive reactance of 10 W is connected in parallel with a capacitive reactance of 30 W. If the combination is connected in series with a 10 W resistance, solve for total real power if the whole circuit is connected across a 240 V 60 hz supply

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 5PP: Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 -...

See similar textbooks

Related questions

Q: Question 6: Given r[n] = u[n] + u[-n – 1] and h[n] = 8[n – 1]. What is r[n] * h[n]? %3D %3D A: 1 B: ...

Q: Does the reverse saturation current of the diode change significantly in magnitude for the reverse-b...

A: Given: Diode reverse saturation current

Q: A point charge of -10 milli C is at (1,-5,8) find the electric flux density D at G(-2,7,9)

Q: Define three phase, three wire system in a maximum of five sentences.

A: Three phase three wire system: This type of distribution system is used for feeding balanced three p...

Q: A 50 Hz, 250 V single phase power line has the following loads placed across it in parallel; 4 kW at...

A: Given Single phase 50 Hz,250 v power line Three parallel loadsLoad-1P1=4 kwPF1=0.8 laggingLoad-...

Q: When an air-gap is added to an electro-magnetic structure, the self-inductance of the structure is e...

A: The solution is given below

Q: A: periodic and power B: nonperiodic and power C: nonperiodic and energy D: none of these E: periodi...

A: It is decaying sinusoidal signal Decaying is done because of negative exponential

Q: If the stator flux density (Bs) of a machine is 0.5490°T and the rotor flux density (Br) is 0.34-80°...

Q: Determine the value of v and the power supplied by the independent current source. 6 kN. 2i,1 24 mA ...

Q: Draw the diagram for the two phasors as described. Please try to draw them to scale. Phasor A: magn...

A: diagram for the two phasors: Phasor A: magnitude 10, angle 45° Phasor B: magnitude 10, angle —45°

Q: Question 5. A continuous-time, LTI system has the impulse response shown below. h(t) 7/2 -1 (1)r* If...

Q: Assume that at the instant the 2 A current source is applied to the circuit in Fig. P8.32, the initi...

Q: Q.4. What do you mean by iron space factor with respect to transformer core? he eunnl h

A: Consider the formula for the iron space factor. k=AAc Here, A is the gross area of the core and ACis...

Q: 2) Find: e.(s)/ei(s), if R1=R3=10kohms, R2-R4=100kohms, Ci=C2=10microfarad. R4 R2 C2 R1 R3 eo

Q: 15.Calculate the DAC output of 010000 by R-2R ladder network method, and circuit analysis. Assume th...

A: In this question, We need to determine the DAC output of 010000 by R-2R ladder network method. I...

Q: 5. In a solidly grounded electrical system with a phase-to-phase voltage of 4160 volts and a phase-t...

A: Given that : Phase to phase voltage =4160 volts phase to ground voltage of 2400 volts voltage level ...

Q: Ex:obtain the bode plot for the gain of the cirent IK 20 MF 5K lonF 5K 200

A: To draw the bole plot

Q: Given a 20 kVA, 50 Hz, 2000/200 V single-phase transformer. The parameters of the transformer equiva...

A: In this question we need to find a voltage regulation of transformer

Q: A- Using Kirchhoff's current law, determine the unknown currents for the below network. 5 mA 3.5 mA ...

A: Given, We have a network. We have to find the unknown Currents. Please find the below attachments fo...

Q: 2. How does the magnetic blood flow meter work? Explain briefly.

A: Magnetic blood flow meter is a device that works on the Faraday's Law of electromagnetic induction.

Q: electric power system

A: NOTE- “Since you have posted a question with multiple sub-parts, we will solve first three subparts ...

Q: B- For the potentiometer in the below network: 80 0 Pot. 1-What are the voltages Vab and Vbc with no...

A: We need to find out voltage with load and without load for given circuit .

Q: Determine the trigonometric Fourier series to represent the periodic voltage function v() shown in F...

A: "According to the Company's policy, we will solve the first subpart of the question". Given the sign...

Q: 10 ohm resistor is connected in parallel with an inductive reactance of 10 ohms. The combination is ...

A: We need to find out resonance frequency for given circuit.

Q: Induction type instruments are used to measure A8 a) AC only b) DC only c) AC and DC d) Voltage only...

A: Induction type instruments are used to measure AC quantities only.

Q: - Calculate the energy in the signal x(t) 5t, for 0 <t < 1 and r(t) 0 otherwise. a.. 25 b. infinity ...

Q: Given the circuit fed by 50HZ voltage source Vs, knowing that Z1 is an inductive load with 0.8 power...

A: Given circuit shown frequency f=50 HzZ1 is inductive load Z2 is capacitive load

Q: For the circuit shown below, if the load voltage (VLoad 400-30 Vrms), and the load absorbs power of ...

Q: (a) What frequency is 1 octave above 5 kHz? (b) What frequency is 1 decade below 10 kHz? (c) What fr...

Q: The EMF induced in the secondary winding of a 50 Hz single-phase transformer having 500 turns on its...

Q: 1.2K 22K 100K 12V 100K 10K 18K 9V o- 12K 2.2K 47K 33K 1.5K -5V

Q: Make a distinction between the three levels of data modeling.

A: Data modeling is the process of arrangement of data in a structured form so that it can be easily un...

Q: A 60 kW, 240 V, 1800 rpm separately excited de motor is controlled by a converter, as shown in Figur...

A: Answer -

Q: 2. GIVEN. (Include symbols and units) 3. REQUIRED/FIND/MISSING (with symbol/s and units) 4. ILLUSTRA...

Q: Given a 100 kVA, 50 Hz power transformer. The maximum efficiency of the transformer is 98.0 % when s...

A: In this question Choose the correct option What is the copper losses? If maximum efficiency = 98% A...

Q: state how the Direct coupled amplifier differs from the RC coupled and Transformer coupled amplifier...

A: Direct coupled amplifier- it is directly connecting output of one transistor with the input of the n...

Q: (d) bd'+acd' +ab'c+a'c'

A: We need to find out SOP and POS from for given Boolean function

Q: 1.Determine the resistance of a four-band resistor having a color sequence of red, yellow, black and...

A: Resistance values of four band indicates 1st digit 2nd digit 3rd multiplier and 4th tolerance Black-...

Q: d) This addressing mode is always used to access memory, shown here as the source operand of this in...

A: LDR R1, [R0]; Load into R0 the contents of the memory location pointed to by R3 This is Register ind...

Q: Given the circuit fed by 3 phases 380V phase to phase voltage, with 50HZ. a) Draw the power triangle...

A: In this question, 2 parallel loads are given. Draw the power triangle. We know Power P= S cos(V^I) R...

Q: The following data were obtained on a 20 kVA, 50 Hz, 2000/200 V Transformer: OCT: 200 V, 1.2 A, 120 ...

A: The solution is given below

Q: The self-inductance of a linear the magnetic circuit is a constant that is: dependent on the winding...

Q: ELECTRICAL CIRCUIT: Solve the problem and show your complete solution. Three currents, i1, i2, İ3 me...

A: In this question we have given three currents meeting at any node...With the help of 3 currents we h...

Q: 24. The Fourier transform of u(21) is 1 C) Tő(w) + a. jw b. 2nd(w)+ jw C. none of these d. ro(w) + j...

Q: 11. Which of the following statements about the use of structural steel as an equipment grounding co...

A: We are authorized to answer the first question since the exact one wasn’t specified. Please submit a...

Q: I, = 2 A Z 0° %3D IR YT 20 XL 50 E ll +

A: We need to find out admittance and current and power factor for given circuit

Q: The system described by y(t) = e'r(t- to) is %3D (a) nonlinear and time-varying (b) insufficient inf...

Q: Using 2 half adders, design a 2 bit combinational decrementer ( a circuit that subtracts 1 from a 2 ...

A: Combinational circuits- Circuit in which present output depends on present input only are combinatio...

Q: Find the magnitude of voltage gain corresponding to a decibel voltage gain of 55 dB.

Q: For the circuit shown below, the value of the secondary current 12 is..A. 12Ω 8Ω 1:2 ww j16 Q 18 2 1...

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Alternating Current (AC) Series Motor and Universal Motor

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
A series circuit consists of resistance of 10 ohm, an inductance of 200/π mH and capacitance of 1000/π μF . Calculate (a) the current flowing in the circuit if supply voltage is 200 V, 50 Hz, (b) power factor of the circuit, (c) power drawn from the supply. Also draw the phasor diagram.
A 120 V, 60 Hz power source is connected across an 800 ohm resistance in series with an unknown capacitor. The voltage drop across the resistor is 102 V. Find the, a.) current of the circuit b.) impedance of the circuit c.) Capacitive reactance d.) capacitance value.
A series circuit consists of a resistance of 10 ohms, an inductance of 200/π mH, and capacitance of 1000/π μF. Calculate (a) the current flowing in the circuit if the supply voltage is 200 V, 50 Hz, (b) the power factor of the circuit, (c) the power drawn from the supply. Also, draw the phasor diagram.
An inductive coil and a non-inductive resistance R ohms are connected in series across an a.c. supply. Deriveexpressions for the power taken by the coil and its power factor in terms of the voltage across the coil, theresistance and the supply respectively. If R = 12 Ω and the three voltages are in order, 110 V, 180 V and 240 V,calculate the power and the power factor of the coil.
6) A circuit consisting of a resistor in series with an inductance takes 210W at a power factor of 0.6 from a 50V, 100 Hz supply. Find (a) the current flowing, (b) the circuit phase angle, (c) the resistance, (d) the impedance, (e) the inductance.
12. A series circuit having pure resistance of 40 ohms, pure inductance of 50.07 mH and acapacitor is connected across a 400 V, 50 Hz, AC supply. This R, L, C combination drawsa current of 10 A. Calculate (a) Power factor of the circuit and (b) Capacitor value.
Three identical inductors are connected in delta to a 415 V, 50 Hz, 3-phase supply. If L = 0.17 H, then the value of the inductive reactance is,
i) Three identical capacitors are connected in delta with 400 V. If the line current is 12 A determine the capacitance of each of the capacitors. If the θ = 600 then calculate the power dissipation in kW when it is connected in STAR? ii) Three coils each having resistance 6  and inductance are connected in star with 415V. If the line current is 30 A, find the value of inductive reactance as well as inductance value. If θ = 450 then calculate the power dissipation in kW when it is connected in Delta?
A series resistance – capacitance (R – C) circuit is connected to 230 – volt, 50 cycle AC source. The current through the resistor is 45.45 A and the power taken by the circuit is 5,000 watts. Compute the following: 1.) Capacitive reactance 2.) Capacitance in microfarad 3.) Apparent Power
An RLC series circuit connected to a 110 – volt and 50 – cycle AC source, contains the following series resistances and reactances: R1 = 10 ohm, R2 = 15, R3 = 5 ohms, XL1 = 20 ohms, XL2 = 25 ohms, XC = 40 ohms. Find the following: a.) EQUIVALENT REACTANCE b.) TOTAL IMPEDANCE c.) VOLTAGE DROP ACROSS THE CAPACITOR d.) TOTAL INDUCTANCE IN MILLIHENRY e.) TOTAL CURRENT f.) REACTIVE POWER g.) REAL POWER DRAW THE PHASOR DIAGRAM IF POSSIBLE AND ROUND OFF TO FOUR DECIMAL PLACES