An inductor and a capacitor are connected to a power system with the frequency of 55 Hz in parallel. If the size of the inductor is 7mH, what is the size of capacitor (in uF) that cancels all the reactive power consumption of the inductor?

An inductor and a capacitor are connected to a power system with the frequency of 55 Hz in parallel. If the size of the inductor is 7mH, what is the size of capacitor (in uF) that cancels all the reactive power consumption of the inductor?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: - 3.4-3 Signals gi(t) = 103e-1000u(t) and g2 (t) = 8(1 100) are applied at the inputs of the ideal…

A: Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: The total average power of the sum of two orthogonal signals can be always computed as the sum of…

A: The average power of the combined signals may not always be equal, to the sum of the signal powers.…

Q: The single-sided power spectral density function of the signal: x(t) = 10cos (40nt + ) +20sin (707t…

A: A continuous-time signal is given as:We need to determine its single-sided power spectral density…

Q: 52 The value of the parameters in the circuit shown in Fig. P10.52 are L₁ = 4 mH; L₂ = 1 mH; k =…

A: The RMS value, or root mean square value, is a measure of the "effective" or "equivalent" value of a…

Q: 6. Find V, using source exchange. m 4mA 1+ 6kQ2 12V 3kQ M +1 + 3kQ2 Vo = ? 12V

Q: For the amplifier circuit, B=171, VA=infinity, R1-47 Kohm, RC=3.4Kohm, RE=4.4Kohm, determine the VEC…

A: In the given question we need to calculate the VEC.

Q: 1- Derive equation 1. 2- Calculate R4. 3- What are the sources of errors of the bridge? E tili w…

A: A Wheatstone bridge is a circuit used to measure an unknown electrical resistance by balancing two…

Q: Calculate the node voltages from Va to Vd

A: The given circuit is shown below.

Q: can ou please answer question d?

Q: In Nodal Analysis, the currents in KCL equations are expressed using node voltages, i.e., V1 and V2.…

A: Given:we need to write:expressions of I1, I2 and I3 in terms of V1 and V2.

Q: Va Vc la In Ic Line Impedance Line Impedance Line Impedance Line Impedance Load Load n Figure 1.…

A: GIVEN DATA:-Va=120<0°Vb=170<−120°VC=170<−240°Zload=20+j20Zline=1+j10A). Line currents and…

Q: 15. For the network in Fig. 74: a. Determine the currents Is, 11, 13, and I4. b. Calculate Va and…

Q: 1 The NTC-type thermistor (NTC-negative thermal coefficient) has the characteristic curve shown…

Q: 10 kn w 3 kn w 15 kn 50 v 15 k 6 kf w 5 kn w 1 mA 1 mA 20kn 15 For the circuit shown above, (a)…

A: In this question, we need to determine the current io as shown in the circuit using the source…

Q: EXERCISE 7.2.1 (a) Find vc(t) for t > 0 in the circuit shown below. 3 ΚΩ t = 0 12 V + + Oc(1) 4 ΚΩ…

Q: (b) A robot arm control system is represented by a block diagram shown in Figare Q.1b. R(s)- (1)…

A: The given block diagram can be reduced by considering the cascade and parallel connected blocks…

Q: 4.26 In a certain region of space, the charge density is given in cylindrical coordinates by the…

A: Given that, the charge density function in cylindrical coordinate system is, .The objective is to…

Q: Or(a) A direct current (DC) transmission facility is modded t circuit shown in Figure Q1(a). If the…

A: Since you have posted the multiple questions with multiple support. So we are supposed to answer the…

Q: Practice Problem equations and solve for the nodal voltages. For the circuit shown, write the nodal…

Q: Determine Vx and ix by using: (d) Thevenin's theorem

A: In this question, we need to determine the voltage Vx and current Ix using the Thevenin theorem.

Q: A Vector Field B = î cos (4) + forsin (6) exists in the closed Contour region show in the tragram…

A: According to the question, a vector field exists in the closed contour region as shown belowWe need…

Q: Given the information provided in Fig. 6.81, find the unknown quantities: E, R1, and 13. 12.3 A R₁…

Q: How would the total current compare to the currents through each resistor? how do the currents…

A: The current through all the resistors needs to be calculated and the relationship between the total…

Q: Determine Vab, Vcb, and Vc for the network AL-BAY - R₂ Vch R₁ + E₁-19 Vo -O E₂ = +35 V + Σ 25 Ω Vwb…

Q: s electricity total usage is 182,000 MWh and the elect Calculate to the nearest 1000 MWh the amount…

A: We are given that in year 2022, an energy inventory and analysis indicated that approximately…

Q: Given 1 Y₁ [n] = 2N+1 Σ x[n-k] k=-N a) Get the impulse response b) If h₁ [2] = 1 2N + 1 2N + 1 2 sin…

A: The input-output relationship of filter 1 is given as:(a) We need to determine its impulse…

Q: 7 The input offset voltage in each op-amp in Figure P14.57 is Vos = 1 mV at T = 25°C and the input…

Q: Q.2 (a) (i) Briefly explain TWO major power losses in a power transformer. (ii) Suggest one method…

A: Since you have posted the multiple questions with multiple support. So we are supposed to answer 1st…

Q: 3.36. Consider a causal discrete-time LTI system whose input x[n] and output y[n] are related by the…

Q: Given the following Boolean function, F = AB + A'C + BC Derive a truth table of the above…

A: Given the following Boolean function,F = AB + A'C + BC derive a truth table of the above…

Q: Another resistor is made out of aluminum (= 3.5.107) with the same length and resistance as the one…

Q: Determine the complex power of the following case

A: In this question, we need to determine the complex power. We know, Complex power representation by…

Q: 10.24 Three loads are connected in parallel across a 125 V (rms) line, as shown in Fig. P10.24. Load…

A: Given three parallelly connected loadsSupply voltage VS=125Vasked to find the following:equivalent…

Q: 4Ω 2 Ω www i2 10 Ω i +1 1Ω 8 V 6V + 13 5Ω

Q: a. Design the circuit in Fig. VR₂ = 3VR, and VR, = 4 VR₂ b. If the current is reduced to 10 μA, what…

A: In the given questions we need to calculate the value of resistor.

Q: Complete the truth table for a three-input AND gate: (replace the question marks with a number) ABC…

A: The given logic gate is,Given truth table is,Asked to find the output of the truth table?

Q: 10.52 The value of the parameters in the circuit shown in Fig. P10.52 are L₁ = 4 mH; L₂ = 1 mH; k =…

A: The RMS value, or root mean square value, is a measure of the "effective" or "equivalent" value of a…

Q: 10.33 The steady-state voltage drop between the load and the sending end of the line seen in Fig.…

Q: N-1 Σαπ n=0 n = Evaluate the sum Σ₁ ejπn/2 using the following identity N, 1-qN 1-a ' a = 1 for any…

A: The given identity is ;We need to evaluate the sum ∑n=09ejπn/2.

Q: Sometimes light fixtures are controlled by more than one switch. Circuits need to be designed so…

A: A logic circuit is an electronic circuit that performs logical operations on input signals to…

Q: A Turgo type hydro-electric plant uses a 92% efficiency generator to produce its rated output of…

Q: Solution to question 3 NBFM:

A: As asked in the question, we need to derive NBFM equation.

Q: Is R, in ty डाट Hyg टिप इंटिड

Q: 1.→ Transform the following circuit to the frequency domain and draw the frequency domain circuit.…

A: The given circuit is shown below.The instantaneous AC voltage source is Volts.The phasor value of…

Q: The circuit in the drawing contains five identical resistors. The 45-V battery delivers 81 W of…

Q: Get the z-transform of the next function and get its ROC

Q: *12. For the network in Fig. 71: a. Find currents Is, Iz, and 16. b. Find voltages V₁ and V5. c.…

Q: A 3 , 500 kVA salient pole synchronous machine has a direct axis and quadrature axis synchronous…

A: We are given a salient pole synchronous machine has a direct axis and quadrature axis synchronous…

Q: Consider the scenario depicted in Fig. 2.11 again. Suppose the electron concentration is equal to N…

Q: The exercise question is: Design a digital circuit that takes a 3-bit binary number A and outputs B…

A: The digital circuit needs to be designed based on the given specification by using the truth table…

Question

An inductor and a capacitor are connected to a power system with the frequency of 55 Hz in parallel. If the size of the inductor is 7mH, what is the size of capacitor (in uF) that cancels all the reactive power consumption of the inductor?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given

VIEW

Step 2: Solution

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 8 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Resonance and Different Parameter

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Which of the following is the capacitance of two 20-microfarad running capacitors connected in parallel? 10 microfarad 20 microfarad 30 microfarad 40 microfarad
Three capacitors having values of 2.2 F, 280 F, and 470 pF are connected in parallel. What is the total capacitance?
A postage stamp capacitor has the following color marks starting at the upper-left dot: black, orange, orange, black, silver, and white. What are the capacitance value and tolerance of this capacitor?
List the five capacitor replacement rules.
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
The circuit is connected to a 60-Hz line. The apparent power in the circuit is 29.985 VA, and the power factor is 62.5%. The resistor has a voltage drop of 14.993 V, the inductor has an inductive reactance of 60 , and the capacitor has a capacitive reactance of 45 . ETITZVA29.985PF62.5%ER14.993VIRRPELILXL60VARsLLECICXC45VARsCC
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
Which of the following is the capacitance of an 88-microfarad and a 108-microfarad starting capacitor connected in series? 196 microfarad 96 microfarad 48 microfarad 40 microfarad
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
Assume that the voltage drop across the resistor, ER, is 78 V; the voltage drop across the capacitor, EC, is 104 V; and the circuit has a total impedance, Z, of 20 . The frequency of the AC voltage is 60 Hz. Find the missing values. ET ER78V EC104V IT IR IC Z20 R XC VA P VARSC PF C
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Capacitive Circuits Fill in all the missing values. Refer to the formulas that follow. XC=12fCC=12fXCf=12CXc Capacitance XC Frequency 38 F 60 Hz 78.8 400 Hz 250 pF 4.5 k 234 F 10 kHZ 240 50 Hz 10 F 36.8 560 nF 2 MHz 15 k 60 Hz 75 nF 560 470 pF 200 kHz 6.8 k 400 Hz 34 F 450