An inductor has the folowing characteristics: Air core, diameter = 5cm 980 turns Length = 15cm Given that the permeability of air is 1.25 x 10-6, what is the inductance of this inductor? Ensure that your answer is in mH

An inductor has the folowing characteristics: Air core, diameter = 5cm 980 turns Length = 15cm Given that the permeability of air is 1.25 x 10-6, what is the inductance of this inductor? Ensure that your answer is in mH

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 3RQ: A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted...

See similar textbooks

Related questions

Q: R. R. For the circuit shown, R, Vi20 W R, Vi30 W R1 = 5.6 kN • R2 = 1.8 k2 R3 = 4.7 kN Ry= 3.9 k2 Vi...

A: In this question, Operation amplifier is given with three inputs. Find the output voltage Vo We a...

Q: circuit has one 10 Ohm resistor and you want to drop the current by a factor of two. Which of the me...

Q: F1 T1 RL 400 1_AMP V1 5:1 40Vpk 60HZ 0, Using the circuit above, solve for the following: Secondary ...

Q: Solve for the diode current Ip and the voltage across the load R using the three diode model: below:...

Q: 724 PART I Abranced Crouit Analyes cos ar.= 24 -1. Answer: 19) Figuel6 ha 4

A: Fourier transform is used for time domain discrete signals. It is used for converting the time domai...

Q: 100 Q ww 60 Q 40Q 100 V 88 Q

Q: Question 30 Solve for beta(5) collector current is 6.236mA and emitter current is 6.292mA. O 114.16 ...

A: This question belongs to analog electronics . It is based on the concept of relation among base curr...

Q: Ex. Q 8. EXAMPLE 8.8 The self-bias configuration of Example 7.2 has an operating point defined by VG...

A: The required parameters can be calculated by using AC analysis of the amplifier circuit.

Q: 4. O Detwmine Vo if V, e 10v 4 V2 = ov. b. Detrmire Vo if V,- SV 1 vz- OV C. Determire Vo it V, 1ov ...

Q: Electromagnets are utilized as key components of transformers in power supplies that convert electri...

A: Televisions Computers Cars Motors Water pumps MRI machines Relays Speakers Microphones

Q: Vi 40 V ideal diodes Vo 2.2 Kr 2.2Kn { 2.2Kr -40v a. Detevmine Vo and Vac b. Draw Vo

A: When Multiple diodes are present in the circuit, then the best way to analyze the circuit is by know...

Q: Ex. 316. Determine the closed-loop steady-state error given a R(s) + E(s) ->0----->| G(s) |---+---> ...

A: The solution is given below

Q: General Block diagram of an Electrical Drive system is shown in Figure 5. Electric Power Electric Me...

A: Induction Motor: It is a ac electric motor in which the electric current in the rotor needed to prod...

Q: true or false: transistors take up less space than tubes and they count faster.

A: Transistor: "A transistor is a device that functions as a switch or gate for electrical signals and ...

Q: A signal s(t) is ideally sampled at a sampling rate (a) 15HZ, (b) 9Hz, (c) 10HZ. If the sampled sign...

A: a f=15 Hzfm=6 Hzfs+fm=21 Hzfs-fm=9 Hz No aliasing

Q: DIRECT-CURRENT CIRCUITS II–NETWORK THEOREMS, LAws 111 11kalerring to Fig. 423 determine (a) the eurr...

A: The solution is given below

Q: loss saftymorgn= Pout -Pin Assignment Tasks %3D 1. An analog optical fiber system employs an LED whi...

A: (a) PIN FET receiver has sensitivity=-54 dBmPower produce by LED=3 dBmTotal allowable power loss= 57...

Q: Can a Water Heater and socket-outlets be combined in one circuit? Justify

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A voltage or cu...

Q: A moving coil instrument has a resistance of 75 ohm and gives full scale deflection of 100- scale di...

Q: D1.4. The three vertices of a triangle are located at A(6.-1.2). B(-2,3. -4), and C(-3. 1.5). Find: ...

Q: 2. An industrial plant consisting primarily of induction motor loads absorbs 1200KVA at 0.85 power f...

A: This question belongs to power system . It is based on the concept of calculation of required shunt ...

Q: V) For the circuit shown in the figure answer questions 13 and 14, the voltage value is given in RMS...

A: In this question, We need to choose the correct option We know at maximum power transfer, ZL = Zth...

Q: I. Solve the current flowing through each resistors using Superposition Theorem: R1 R3 R5 20 2.50 V1...

Q: Exercise 1-4: Consider the red wave shown in Fig. E1.4. What is the wave's (a) amplitude (at x = 0),...

Q: Determine Zi, Zo, and A, for the network shown in Fig X.

A: According to guidelines we are supposed to solve only the first 3 subparts. The first part consists ...

Q: generation current density at a reverse bias

A: Semiconductor- Materials which don't have free electrons in valence so there is no flow of current ...

Q: Give reason why dc motor requires starter.

A: When a DC supply is given to a motor through brush and commutator then the commutator generates a ro...

Q: Vacuum Circuit Breaker & SF6 Circuit Breaker

A: Vacuum Circuit breaker In the Vacuum Circuit breaker, the arc quenching medium is a vacuum. It is ge...

Q: 2 kn 18 V 4kn 2kN 4 k2 4kn 3mA 3mA 1kn

Q: IV) For the voltage waveform shown below. If the voltage is in volts and the time is in milliseconds...

A: The solution is given below

Q: 1. In the following figure: R = 3 kN X; = 2 kN Xc = 1 kN %3D + VC + VR VL e = 6 sin(314t + 60°)

Q: +48 V For the circuit shown, the value of R2 in (KO) is: R1 R +12 V 16 mA E 100 V 多 Ry Rs -20 V

A: Given,

Q: 34. Consider the following statements: (1) If the vector field is curl free, a scalar potential may ...

A: Any charged particle produces an electric field. This electric field is directed from the positive c...

Q: An inductor has the following characteristics: Air core, diameter = 5cm 980 turns Length = 15cm Give...

Q: 9. Determine Vo por (+) and (-) ayde. 1-skr 3. diodes D2 loksn 2 Vo b. Draw Vo. 2.5v - nov

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: Directional Overcurrent Relay & Non-Directional Overcurrent Relay

A: When the current flowing through the device is more than the pickup current set for the device then,...

Q: Ex. Q 7. EXAMPLE 8.8 The self-bias configuration of Example 7.2 has an operating point defined by Vo...

Q: An inductor has the folowing characteristics: Iron core, diameter = 5cm 894 turns Length = 14cm Give...

Q: 10.25: For the following electric circuit, find Z and Y parameters? Also, compute input and reflecte...

Q: Given an equation in three dimensional spherical coordinates p² sin? ¢ = 9. Show that it represents ...

A: In spherical co-ordinates we havex=ρsinϕcosθy=ρsinϕsinθz=ρcosϕ ......(1)and cylindrical co-ordinates...

Q: 20 V Ic Rc = 20 2 RB I k2 C; B = 25

Q: For the ladder network in Fig. 2.104, find I and Reg- 8Ω ww 33 2 5 V Reg (+1)

Q: Q1. A 3-phase, 440-V, 50-Hz, 4-pole, Y-connected induction motor has the following per-phase paramet...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: etermine the maximum power that can be delivered to the load RL in the network n the figure below. 1...

Q: Given the potential V = 10 sin 0 cos o, (a) Find the electric flux density D at (2, a/2, 0). (b) Cal...

A: We will find out flux density and work done

Q: Answer: sin 2nt.

Q: factor is 0.66 leading, what will be the reading of each wattmeter? For what power factor will one o...

Q: 4. Three identical impedances ZA = 9430°N are delta-connected to 220V source by three identical line...

A: The solution is given below

Q: )Using the method that applies the Laplace Transform to the circuit below, assuming initial conditio...

Q: 1. A single-phase 120 volts, 60 Hz source supplies power to a parallel RLC circuit consisting of R a...

A: The formulae used and detailed solution is provided below.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
Three capacitors having values of 2.2 F, 280 F, and 470 pF are connected in parallel. What is the total capacitance?
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
4. In what form is the energy of a capacitor stored?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
What is the unit of measurement for the strength of a capacitor? microamp microtorque microfarad microwatt
A pure capacitive circuit is connected to a 480-volt, 60-Hz power source. An ammeter indicates a current flow of 24 amperes. The circuit current must be reduced to 16 amperes by connecting a second capacitor in series with the first. What is the value of the existing capacitor? What value capacitor should be connected in series with the original capacitor to limit the circuit current to 16 amperes?
You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor to a 480-V, 60-Hz line. To determine the proper conductor and fuse size for this installation, you need to know the amount of current the inductor will draw from the line. The nameplate on the inductor indicates that it has an inductance of 0.1 H. An ohmmeter reveals that it has a wire resistance of 10 . How much current should this inductor draw when connected to the line?