An inductor with an inductance of 5.75 H and a resistance of 9.00 2 is connected to the terminals of a battery with an emf of 7.00 volt and negligible internal resistance. a) Find the initial rate of increase of current. b) Find the rate of increase of current when the current is 0.500 A. c) Find the final steady state current.

An inductor with an inductance of 5.75 H and a resistance of 9.00 2 is connected to the terminals of a battery with an emf of 7.00 volt and negligible internal resistance. a) Find the initial rate of increase of current. b) Find the rate of increase of current when the current is 0.500 A. c) Find the final steady state current.

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter32: Inductance

Section: Chapter Questions

Problem 32.16P

See similar textbooks

Similar questions

When a camera uses a flash, a fully charged capacitor discharges through an inductor. In what time must the 0.100-A current through a 2.00-mH inductor be switched on or off to induce a 500-V emf?
Show that for the circuit shown below, the initial energy stored in the inductor, LI2(0)/2 , is equal to the total energy eventually dissipated in the resistor 0I2(t)Rdt.
When the current through a large inductor is interrupted with a switch, an are appears across the open terminals of the switch. Explain.
What resistance R must be connected in series with a 200-mH inductor of the resulting RLC oscillating circuit is to decay to 50% of its initial value of charge in 50 cycles? To 0.10% of its initial value in 50 cycles?
In Figure 14.12, =12V , L = 20 mH, and R=5.0. Determine (a) the time constant of the circuit, (b) the initial current through the resistor, (C) the final current through the resistor, (d) the current through the resistor when t=2L , and (e) the voltages across the inductor and the resistor when t=2L .
Calculate the reactance of a 5.0-mH inductor at (a) 60 Hz, (b) 600 Hz, and (C) 6000 Hz.
In an RLC series circuit, can the voltage measured across the capacitor be greater than the voltage of the source? Answer the same question for the voltage across the inductor.
A 20.0 kHz, 16.0 V source connected to an inductor produces a 2.00 A current. What is the inductance?
Check Your Understanding The angular frequency of the oscillations in an LC circuit is 2.0103rad/s . (a) If L = 0.10H, what is C? (b) Suppose that at t = 0, all the is stored in the inductor. What is the value of ? (c) A second identical capacitor is connected in parallel with the original capacitor. What is the angular frequency of this circuit?
Can a circuit e1eent have both capacitance and inductance?
A step-up transformer is designed so that the output of its secondary winding is 2000 V(rms) when the primary winding is connected to a 110-V (rms) line voltage, (a) If there are 100 turns in the primary winding, how many turns are there in the secondary winding? (b) If a resistor connected across the secondary winding draws an rms current of 0.75 A. what is the current in die primary winding?
Check Your Understanding A transformer steps the line voltage down from 110 to 9.0 V so that a current of 0.50 A can be delivered to a doorbell (a) What is the ratio of the number of turns in the primary and secondary windings? (b) What is the current in the primary winding? (c) What is the resistance seen by the 110-V source?