An industrial load is modeled using the combination, in parallel, of a capacitor and a resistor, as shown in the following figure: An inductor, L, is required to be connected to the industrial load in a that when the network operates at 10 ^ 6 rad / s the voltage and current in the total impedance, observed between terminals a-b, are in phase. a) Determine the necessary value of inductance, L, to satisfy the previous requirement.

An industrial load is modeled using the combination, in parallel, of a capacitor and a resistor, as shown in the following figure: An inductor, L, is required to be connected to the industrial load in a that when the network operates at 10 ^ 6 rad / s the voltage and current in the total impedance, observed between terminals a-b, are in phase. a) Determine the necessary value of inductance, L, to satisfy the previous requirement.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.16P

See similar textbooks

Similar questions

A 565 IC PLL has an external resistor R1 of 1.2 kΩ and a capacitor C1 of 560 pF. The power supply is 10 V. (a) What is the free-running frequency? (b) What is the total lock range?
Design a Single-phase bridge rectifier that is required to energize a load with (X) Watts and with max IDC≤ 2A with voltage ripples must not exceed 5%. - Determine the system parameters and select the appropriate transformer, didoes and filter -Plot the waveforms.
A group of UTAS-Nizwa students are working on a project entitled "Gas leak detector alarm" for their final year in Diploma level. The circuit works on DC voltage of 16 volts and DC current of 7 milliampere. Students need to design a power supply circuit for their project. Consider an RMS voltage input of 220 volt, 60 Hz. Using a Full Wave Bridge Rectifier with Transformer, Silicon diode and Capacitor Filter, Design the power supply. a. Compute for the load resistance, peak output voltage, input peak voltage to the diodes (secondary voltage), peak input voltage and the turns ratio of the transformer. 1. What is the value of the load resistance? b. Draw the Power Supply circuit (capacitor filter connected in parallel with the resistor) and write the computed values (No value for the capacitor).
-BJT AC ANALYSIS -USE EXACT ANALYSIS - show diagram answer c1 only thanks
Regarding to the Wien bridge oscillator, Explain the working principle in details.Draw the oscillator output gain and phase shift plots(Design the electronic circuit of an oscillator using 22KΩ resistors and correct valuedcapacitors that produces a sinusoidal signal with a frequency of 50KHz.
Find for the dc voltage across the load resistor of the three rectifiers when connected to a capacitor filter with a value of 1. 47uF 2. 4700uF
Using the circuit shown in figure 1 below, design a Wien-bridge circuit to oscillate at a frequency of 100 kHz.
Differentiate between Hybrid Model and re- Model. Sketch a hybrid and re-model for CC Configuration.
Subject: Electronic Engineering Plzz solve all questions
An FET phase-shift oscillator having gm = 5500 mS, rd= 36 kilo ohm, and feedback resistor R = 10 kilo ohm is to operate at 2.5 kHz. Select C for specified oscillator operation.
Give examples for the following: A.) 1 example of DC analysis of darlington pair solved problem. B.) 1 example of AC analysis of darlington pair solved problem.
Q. The IC used in OPAMP is LM 741. True False