An inverted U-tube manometer \17 containing oil (SG = 0.8) is located between two reservoirs as shown in Fig. The reservoir on the left, which contains carbon tetrachloride, is closed and pressurized to 55 kPa (gage). The reservoir on the right contains water and is open to the atmosphere. With the given data, what the depth of water, h, in the right reservoir. Take Gamma_water = 9810 N/m3 and GammaCCI4 = 15640 N/m3

An inverted U-tube manometer \17 containing oil (SG = 0.8) is located between two reservoirs as shown in Fig. The reservoir on the left, which contains carbon tetrachloride, is closed and pressurized to 55 kPa (gage). The reservoir on the right contains water and is open to the atmosphere. With the given data, what the depth of water, h, in the right reservoir. Take Gamma_water = 9810 N/m3 and GammaCCI4 = 15640 N/m3

Name: نقطة واحدةAn inverted U-tube manometer \17containing oil (SG = 0.8) i
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: نقطة واحدةAn inverted U-tube manometer \17containing oil (SG = 0.8) is located%3Dbetween two reservoirs as shown inFig. The reservoir on the left, whichcontains carbon tetrachloride, isclosed and pressurized to 55 kPa(gage). The reservoir on the rig

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.122P: The 12-ft wide quarter-circular gate AB is hinged at A. Determine the contact force between the gate...

See similar textbooks

Similar questions

An air-filled, hemispherical shell is attached to the ocean floor at adepth of 10 m as shown in fig. A mercury barometer located inside the shell reads 765 mmHg (absolute pressure inside the shell)m, and a mercury u-tube manometer designedto givethe outside water pressure indicates differential reading of 735 mmHg as illusrated. Based on these data,what is the atmospheric pressure at the ocean surface for seawater (SG=1.03)
Capillary rise in the glass tube used for measuring water level isnot to exceed 0.5 mm. Determine its minimum size, given thatsurface tension for water in contact with air = 0.07112 N/m.
Two small vessels are connected to a U-tube manometercontaining mercury(relative density 13.56) and the connectingtubes are filled with alcohol (relative density 0.82). Thevessel at the higher pressure is 2 m lower in elevation than theother. What is the pressure difference between the vessels whenthe steady difference in level of themercury menisci is 225 mm?What is the difference of piezometric head? If an inverted U-tubemanometer containing a liquid of relative density 0.74 wereused instead, whatwould be the manometer reading for thesame pressure difference?
A closed tank contains 1.5 m of SAE 30 oil, 1m of water, 20 cm of mercury, and an air pocket in its upper part, all of them at 20 ° C. The absolute pressure at the bottom of the tank is 60 kPa. What is the pressure in the air bag?
Determine the pressure at the interface of liquids of an open tank containing 3 m of oil (SG=0.79) and 10 cm of mercury (13.6)
An isosceles triangular plate of base 5 m and altitude 5 m is immersed vertically in an oil of specific gravity 0.8. The base of the plate is 1 m below the free water surface, determine:(i) The total pressure, and(ii) The centre of pressure.
In a fluid 1 is oil (sg=0.87) and fluid 2is glycerine at 20 degrees Celsius (w=12360N/m cubed) if Patm=98kpa determine the absolute pressure at p1 Here is the diagram in the picture below
A cylindrical tank of 1.5 m diameter and height 0,75 m has a hemispherical dome. The tank contains oil of relative density 0.84. The dame is joined to cylinder position by four equally spaced bolts. If pressure gauge at point M, 0.3 m above base of tank read 50 kPa. Determine force each bolt.
Pressure in a water container can be measured by an open vertical tube. If the expected water rise is about 20cm. What tube diameter is needed to ensure the capillary action is less than 3%?
Calculate the capillary rise in cm in a glass tube of 3.0 mm diameter when immersed vertically in mercury. Take the surface tensions for mercury as 0.0725 N/m in contact with air. The specific gravity of mercury is 13.6.
Two thin flat plates, tilted at an angle α , are placed in a tankof liquid of known surface tension Y and contact angle θ ,as shown in Fig. C1.3. At the free surface of the liquid inthe tank, the two plates are a distance L apart and havewidth b into the page. The liquid rises a distance h betweenthe plates, as shown.( a ) What is the total upward ( z -directed) force, due to surfacetension, acting on the liquid column between theplates?( b ) If the liquid density is ρ , fi nd an expression for surfacetension Y in terms of the other variables.
A compressed air tank is designed to contain 50 standard cubic feet of air when filled to a gaugepressure of 200 atm at an ambient temperature of 70 F. Assume this is an air tank for scubadiving, and that the approximate shape of the tank is a cylinder with circular cross section. The interior volume of the tank is v=0.253 ft^3(a) If the interior length of the cylinder is 1 ft, what would be the inner diameter?(b) It is desired that the air tank be neutrally buoyant when empty. The density of aluminum is2700 kg/m3. If the tank is made of aluminum, what should be the wall thickness in order forit to be neutrally buoyant?