An n-p-n transistor at room temperature has its emitter disconnected. A voltage of 5 V is applied between collector and base. With collector positive, a current of 0.3 μA flows. When the base is disconnected and the same voltage is applied between collector and emitter, the current is found to be 25 µA. Find and a, IE, Ip when collector current is 1 mA.

An n-p-n transistor at room temperature has its emitter disconnected. A voltage of 5 V is applied between collector and base. With collector positive, a current of 0.3 μA flows. When the base is disconnected and the same voltage is applied between collector and emitter, the current is found to be 25 µA. Find and a, IE, Ip when collector current is 1 mA.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Draw, Illustrate and label your schematic diagram before solving the problem. 1) Given a Fixed-Biased transistor circuit with Beta DC is 200 , voltage at common collector is +22v ,base supply voltage is +11V, Base resistor is 47kOhms , collector resistor is 390 ohms ,Voltage at Base-emitter junction is 0.7v. Determine the Q-point of collector current and Voltage at collector-emitter junction. These might be help as a guide to solve the problem.
The dc bias circuit for a common emitter amplifier is shown in the figure. In the circuit, Vcc=15v,RB1=20k Ω,RB2=100k Ω,Rc=5.1k Ω,and RE1=1k Ω, Assume that when the transistor is on, the voltage drop from base to emitter VBE=0.7v. Also assume that β= ∞, which implies that the base current can be considered zero (IB=0) in your calculations. Solve for the base voltage VB. Solve for the emitter voltage VE. Solve for the emitter current IB. Solve for the collector current IC
The common-emitter amplifier given in the figure in the circuit, Vcc=9V, R1=27kΩ, R2=15kΩ, RE=1.2kΩ and RC=2.2kΩ. Transistor β=100 has value. a-) If it has values of Rsig=10kΩ and RL=2kΩ Calculate the IE of the amplifier. b-) For small signal analysis of transistor Find the value of Rin by deriving the π-model c-) Calculate vo/vsig and io/ii.
In an NPN transistor used as an amplifier, which components or connections control the current flow between the others? Pick those that apply. Either N-doped regions. The base, symbolized by B controls the current between the emitter, symbolized by E, and the collector, symbolized by C. The emitter, symbolized by E controls the current between the base, symbolized by B, and the collector, symbolized by C. The P-doped depletion region.
In order to express the effect of the internal capacitors of BJT and the high frequency reception, the current gain expression depending on the frequency (Figure b) (hfe) is used in the case of collector emitter short circuit, voltage source connected at base end and emitter grounded (Figure la).. The catalog information of the 2N2222 transistor is given in Figure Ic. In the catalogue, when Ic=20 mA, it is seen as fT=250 MHz. a) Find the total capacitor effect for the case where gm> > wCμ. (Cpi) + (Cμ) = ?pF
An npn transistor with IS = 5 × 10−16 μA, αF =0.95, and αR = 0.5 is operating with VB E = 0.3 Vand VBC = −5 V. This transistor is not truly operating in the region defined to be cutoff, but we still saythe transistor is off. Why? Use the transport modelequations to justify your answer. In what region isthe transistor actually operating according to ourdefinitions?
A common emitter amplifier is given in the circuit in the figure. The current gain β of the transistor in the circuit is 50 a.For Rb = 100 kΩ and Ib = 60mA, find the currents Ic , IE and the voltage falling on the load resistor Rc. b.For Rb = 50 kΩ and Ib = 120mA, find the currents Ic,IE and the voltage falling on the load resistor Rc. c.Find the α (alpha) and γ (gamma) current gains of the transistor
The transistor in the circuit below is an enhancement n-type MOSFET with kn’= 400 μA/V2, W=4 μm, L=800 nm, and Vtn= 0.8 V. Solve the circuit below to find all the node voltages and all the branch currents.
In the common emitter amplifier, R1 = 50Ω, R2 = 1kΩ, and CL=1 pF. Determine the quiescent collector current, ICQ, needed such that the unity gain frequency, fu, = 1 GHz. Show your complete solution and state all your assumptions.
A transistor has Tox = 40 nm, VTN = 1 V,μn = 500 cm2/V ·s, L = 2 μm, and W = 20 μm.What are Kn and the saturated value of iD for thistransistor if VGS = 4 V? (b) The technology isscaled down by a factor of 2. What are the newvalues of Tox, W, L, VTN , VGS, Kn, and iD?
a. What collector current is required for a bipolar transistor to achieve a transconductance of 5.5 mS ? Use VT=0.026V and express your answer in µA up to 2 decimal places. b. A transistor operating with nominal gm of 80 mS has a ββ that ranges from 50 to 150. Also, the bias circuit, being less than ideal, allows a 20% variation in ICIC. What is the smallest value found of the resistance looking into the base, in kΩkΩ? Use VT=0.026VT=0.026V and express your answer up to 3 decimal places. c. Given that a BJT is biased to have a small signal input resistance rπ = 25 kΩkΩ with β = 100, what is the BJT's transconductance gmgm? Use VT=0.026VT=0.026V and express your answer in mS and up to 2 decimal places.
For the transistor , IS = 4 × 10−16 μA,βF = 75, and βR = 4. (a) Label the collector, base,and emitter terminals of the transistor. (b) What isthe transistor type? (c) Label the emitter-base andcollector-base voltages, and label the normal direction for IE , IC, and IB. (d) Write the simplified formof the transport model equations that apply to thisparticular circuit configuration. Write an expressionfor IE /IB. Write an expression for IE /IC. (e) Findthe values of IE , IC, IB, VC B, and VE B.