An organic compound X with a relative molecular mass of 88.0 was found to contain 54.54% carbon, 36.36% oxygen and 9.10% hydrogen by mass. A portion of its infra-red spectrum is shown below. Determine the molecular formula of the compound and deduce possible structure or structures of the compound. A) Butanoic acid B) 1,3-Dioxolan-2-one C) Ethyl Acetate D) 2-Butene-1,4-diol E) Methyl propionate

An organic compound X with a relative molecular mass of 88.0 was found to contain 54.54% carbon, 36.36% oxygen and 9.10% hydrogen by mass. A portion of its infra-red spectrum is shown below. Determine the molecular formula of the compound and deduce possible structure or structures of the compound. A) Butanoic acid B) 1,3-Dioxolan-2-one C) Ethyl Acetate D) 2-Butene-1,4-diol E) Methyl propionate

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Chapter5: Signals And Noise

Section: Chapter Questions

Problem 5.9QAP

See similar textbooks

Similar questions

The resolution product of Ag2SO3 is 1.5 x 10-14. Calculate E0 for Ag2SO3 (k) + 2e- ↔ 2 Ag (k) + SO32-. Ag + + e- ↔ Ag E0 = + 0.799 V A. + 0.799 VB. + 0.803 VC. + 0.020 VD. + 0.390 V
5 0.0030 0.0015 0.0005 6 0.0030 0.0057 0.0089 7 0.0086 0.0057 0.0089 Show the Calculations of Qc and Kc for Exp. 5-7 Please help me out. Thanks
A 1.2cm diameter glass cuvette is filled with a Cu(NH3)42+ solution that is deep blue. The cuvette is placed into a pre-blanked spectrophotometer. At 620nm, the transmittance is 23%. If the solution has molarity = 0.0133 M and path length of light through the solution = 1.2 cm, what is the value of molar absorptivity at 620 nm?
The following are the reasons why instrumental analysis methods are used, except for: a. Narrow concentration ranges may be detected. b. Extreme low sensitivity, with molecule and noise signal detection. c. Separate equipment or facilities for control, data handling, and optimization procedures. d. All of the above
Calculate the resolution required to resolve the following peaks; i) CH3N+ (MW = 28.0187) and N2+ (MW = 28.0061) ii) C2H4+ (MW = 28.0313) and CO+ (MW = 27.9949) iii) C3H7N3+ (MW = 85.0641) and C5H9O+ (MW = 85.0653) iv) 116Sn+ (At W = 115.90219) and 232Th2+ (At W = 232.03800)
The transmittance of a solution in 1-cm cuvette is 60.0%. Calculate the transmittance of the same solution in 2-cm cuvette.
5.4.5 Chemical microanalysis5.4.5.1 Exploitation of characteristic X-raysElectron probe microanalysis (EPMA) of bulk samples is now a routine technique for obtaining rapid, accurate analysis of alloys. A small electron probe (100 nm diameter) is used to generate X-rays from a defined area of a polished specimen and the intensity of the various characteristic X-rays measured usingeither wavelength-dispersive spectrometers (WDS) or energy-dispersive spectrometers (EDS). Typically the accuracy of the analysis is š0.1%. One of the limitations of EPMA of bulk samples is that the volume of the sample which contributes to the X-ray signal is relatively independent of the size of theelectron probe, because high-angle elastic scattering of electrons within the sample generates X-rays. The consequence of this is that the spatial resolution of EPMA is no better than ¾2 µm. In the last few years EDX detectors have been interfaced totransmission electron microscopes which are capable of operating…
Peaks of scattered intensity are observed when the path difference would becomes equal to __________ λ/2 λ 2λ 3λ/2
a solution of 5.47 ppm kmno4 has a transmittance of 0.409 in a 1 cm at 520nm. Calcualate the molar absorptivity of KMnO4 Express in 5 SF
The transmittance of a solution is found to be 35.0%. What is the transmittance if the solution is diluted in half?
The molar absorptivity for aqueous solutions of phenol at 211 nm is 6.17 × 103 L cm-1 mol-1. Calculate the permissible range of phenol concentrations if the transmittance is to be less than 85% and greater than 7% when the measurements are made in 1.00-cm cells.
9. Calculate the Go in kJ/mol. 3Fe2+ (s) + 2Cr(aq) ⟶2Cr3+(aq) + 3Fe (s); Eocell=0.30 V Group of answer choices -170 +170 +87 +58 -195 10. Calculate Ecell in volts. Zn(s)|Zn2+(2.50x10-4M)||Sn2+(1.50M)|Sn(s) Eocell=+0.624 V Group of answer choices 0.736 0.635 0.512 0.848 no correct answer