analog signal za (t) = sin(360xt) + 3 sin(840xt) is sampled at 600 nes per second. What is the expression for the resulting discrete time signal n]? O a. - sin( ) 3nn Бь. 2sin() C. -2 sin( 3m 3mm O d. -4 sin() De. sin() O f. 4 sin()

analog signal za (t) = sin(360xt) + 3 sin(840xt) is sampled at 600 nes per second. What is the expression for the resulting discrete time signal n]? O a. - sin( ) 3nn Бь. 2sin() C. -2 sin( 3m 3mm O d. -4 sin() De. sin() O f. 4 sin()

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A continuous time signal, x(t) = sin(20πt) + cos(40πt), is sampled uniformly at intervals of T to obtaina discrete time signal,x(n) = sin(πn/5) + cos(2πn/5).a) What is the value of T assuming no aliasing has occurred?b) Assume both frequency components have been aliased. In this case, is your choice of T unique? If not,specify some choices of T consistent with the information given
A Pulse Code Modulation based system is processing a sampled voice signals ranges from X Hz to Y Hz before it is going through the telephone line. If the bandwidth for that signalis set as 2,000 Hz, suggest a best value for X and Y.
The conventional amplitude modulated signal is in the time domain; m(t) message sign, Ac carrier the amplitude of the signal and fc the frequency of the carrier signal in the form below. What we did in our laboratory with a sinusoidal message signal with a single tone (that is, a single frequency component) The modulated signal time we obtained as a result of the traditional amplitude modulation experiment in the domain Qm (t)= 0.5cos (1800πt)+ 2cos (2000πt)+ 0.5 cos(2200πt) a) Draw the spectrum of the modulated signal in the frequency domain. In the modulated signal Show the lower sideband and the upper sideband. Sideband frequencies with carrier signal specify. b) Determine the message sign in the time domain m(t) and the carrier sign in the time domain c(t). These signs Write the Fourier transform and plot it in the frequency domain. c) Draw the modulated sign in the time domain. find the Modulation index (μ) . d) Interpret by determining the ratio of the power in the sidebands to…
In case the sound from the engine of a vehicle is modelled by the function y(t) = cos[ω(t + τ) + θ] where time delay=τ & phase=θ Determine the frequency & period of the signal u(t) whena)[ω, τ, θ] = [π/3, 1/2, π/2]b)[ω, τ, θ] = [3π/4, 1/2, π/4] N.b time should be in seconds & frequency in Hertz. c) y(t) = e-atu(t) for t≥0 & y(t) = 0 for t<0 where a>0 is a constant The function above defines the model of the decay of the vibration of a vehicle engine. i.Make a sketch of the signal y(t) & determime its fourier transform.
Find the highest sampling frequency fs so that if the signal v(t) = 12 cos(2π125t + π/3) + 18 cos (2π85t) is sampled at times t = nT where T = 1/fs, you obtain the signal vs(n) = A cos (Ωn + ψ) with a single frequency component. Find the amplitude A, normalized radian frequency Ω, and phase ψ of the sampled signal.
An interview is held with a student about the importance of education for thirty minutes at a radio station. It was later amplitude modulated & transmitted to receivers on the school campus.The expression below describes the transmitted signal a(z) a(z)= Acos(16πz) where A=3cos(10πz) a. In an expression form, express a(z) as a sum of sinusoids & determine the frequency components of the signal a(z)b. To adequately & fully recover the signal at the receiver, determine the rate at which the signal should be sampled.c. Determine the discrete signal,a[n] that was transmitted in a reduced form & the angular frequency assuming the signal a(z) is sampled at ten Hertz.
An audio signal described as 25 sin 2π (5 X 103 )t amplitude modulates a carrier which is described as 40 sin 2π (1 X 106 )t Determine the modulation factor, percent modulation and the upper and lower sideband frequencies and write the AM equation.
The carrier c(t) = 100 cos(2πft) is frequency modulated (FM) by the message signal m(t) = 5 cos( 20000πt), where f.= 100MHz. The peak-frequency deviation is 20 kHz. The modulated signal is a wide-band FM.1. Determine the amplitude and frequency of all signal components that have a power level of at least 10% of the power of the unmodulated carrier component.2. From Carson's rule, determine the approximate bandwidth of the FM signal.
Obtaining broadband FM signal from narrowband frequency modulated (FM) signal is shown below. The narrowband FM signal has a maximum frequency deviation of 100 Hz. The frequency of the local oscillator is f0=100 kHz. Since the sign at point A is Ac(cos 2πf0t+θ(t)), express the signs at points B and C. Ac is a constant and θ(t) is a function of m(t).
1. Given an analog signal x(t)=10 cos(2π.5500t)+5 cos(2π.7500t) is sampled at a rate of 8,000 Hz, a. Sketch the spectrum of the sampled signal up to 20 kHz; b. Sketch the recovered analog signal spectrum if an ideal low pass filter with a cutoff Frequency of 4 kHz is used to filter the sampled signal in order to recover the original signal; c. determine the frequency/frequencies of aliasing noise.
What is the bandwidth of an AM signal whose carrier is 2.1 MHz modulated by a 1.5-kHz square wave with significant harmonics up to the fifth? Calculate all the upper and lower sidebands produced? (Our lesson is AMPLITUDE MODULATION FUNDAMENTALS) (Please box the answer )
Determine the energy content of the even symmetric component of the signal defined asx(t) = 10+2t volts, -5≤t≤5= 0, otherwise