Analyse the performance of a DC motor speed control when subjected to external disturbances.

Q: An op-amp has a maximum output voltage swing between ± 14 V. The feedback resistors are R1 = 1.5 KQ,…

A:

Q: a. For the circuit shown in Figure 4, calculate the Thevenin voltage, VTh, with respect to the…

A: given circuit is                       to determine the Thevenin's voltage , Thevenin's resistance…

Q: 1. Determine the inverse z-transform for each of the following: 1 (1+-z-¹)(1-2z-¹)(1-3z-¹) (a) X(z)…

A: Given Functions   To determine:Inverse Z-transform of the functionsProperties of Z-transform

Q: 3. The figure below shows a robot used to move 55-pound bags of pellets; a vacuum head lifts the…

A:

Q: Switch S1 has been closed and S2 has open for a long time until the capacitors are fully charged. At…

A:

Q: Three resistors. R₁ = 390, R₂=2902, and R₂=4692, are connected to a capacitor of capacitance C=24µF…

A:

Q: 2. Vi 450ΚΩ 1μF 14 V₁ IB Vc 1kQ 3ΚΩ Ic 1μF HH + VCE Vo

A:

Q: Problem 5: Consider the circuit in Figure 5. Assuming that V³ ≥ VÃ, and that the op-amp is ideal.…

A:

Q: 3- a) An actual transformer is connected to a load with a given impedance, in that case draw…

A: The above questions are related to a 1 phase transformer.

Q: 14 The "charge-holding" ability of a capacitor is called its capacitance.  a True  b False

A: The area of the plates and the spacing between the plates are two variables that affect a…

Q: G(s) = 1 s(1 + s)(1+) R(s) ign a Lag Compensator using Frequency Response method such that: 1- The…

A: Lag compensator: It is used to improve stability and performance. It provides attenuation (or…

Q: Find the Thevenin voltage associated with this circuit (in Volts) 1 ww 2 | + 0 Answer in Volts. R1…

A: In this questionWe need to determine the Thevenin voltage. We knowVoltage across the resistance R,…

Q: In an energy transmission system with a normal grid frequency of f=50Hz, a Voltage Vector Shift…

A: Change in frequency is caused by the imbalance between the input mechanical power and load. Due to…

Q: The impulse response of a linear time- invariant system is: h(n) = = x(n) While the input signal is:…

A: Given dataImpulse function, Input function, To find outWe have to determine the convolution of…

Q: An analog light transducer sensor outputs a 5 V signal at a 1500 lumen intensity light exposure. If…

A: Analog light sensor:Outputs: 5V for 1500 lumenADC: 12bit resolutionTo determine:Sensitivity of…

Q: Find the fault current in both generators and in the engine for a three -phase failure In the middle…

A: To find the fault current in both generators and the engine, as well as the voltages in nodes 1 and…

Q: 2.The device has the open loop transfer function Ke-st (s + 1)(s + 3) G(s) Determine a suitable gain…

A:

Q: ask 7 Examine the P, I, and D parameters on the dynamic responses of the transfer functions in…

A:

Q: draw the schematic diagram for single phase AC Voltage regulator and three phase AC Voltage…

A: Step-1->schematic diagram for single phase AC Voltage regulator-:

Q: Design PD Controller for a unity feebbuck temperaturs control system has open loop. Tf G(S) K 5+6)…

A: The open-loop transfer function of a system is given asWe need to design a PD controller to meet the…

Q: 1-12 Find the voltages V₁ and V₂ in Fig. 1-4d: + V₁ < 5kQ + OM O MO V₂ ↓ 2mA 10kQ

A:

Q: C(s)=K(s+1)/[s+0.1] inspector given and in a control system with feedback in series with it…

A:

Q: Question 17 a) i. Define the resistivity of a material. ii. A 2.5 m length of Nichrome wire, AB, of…

A:

Q: Q2. For the circuit given below assume that at t = 0, the initial current through the inductor is -1…

A:

Q: A- For the lossless T.L with 1-30m, Zr-Zo-502, f-10MHz, find Zs, and Za at d=0.125 2.

A: For the lossless transmission line,

Q: A) Calculate the DC output voltage and the emitter currents of Q1 and Q2. B) Sketch then the…

A: here

Q: B=100 रै 4302 M Vin 30 V wwww UCCI Six = ?

A:

Q: reduce block diagram

A: The transfer function of the given system needs to be obtained by using the block diagram reduction…

Q: 3. Using Mason's Rule, find the transfer function T(s) = for the system represented in the fugre.…

A: Signal flow graphwe have to find Transfer function

Q: 4) Calculate the voltage Vx and the current through the coil in the circuit below. (For t=0, it is…

A:

Q: 5- For the control system shown in Fig. 4, determine the steady state error for step input to 5, and…

A:

Q: Find to in the circuit of fig. 5, given the source is 540⁰A. j4n2 22 M -jan- -m- -j2n= Fig. 5 I. H↓…

A: Current divider rule:

Q: Analyze the logic function of the circuit A₁ B₁ CH D -S₁ Ca

A: In this questionWe need to determine the output of the given circuit. This is full adder logic…

Q: 5. An automatic switch or cutout is allowed in the equipment grounding conductor circuit when A.…

A: Explaination:In electrical systems, the equipment grounding conductor is a crucial safety component.…

Q: 3) Find the transfer function of the system given below R(S) + G₁ G₂ HA H₁ وٹو G3 G4 H3 H₂

A: Asked to find transfer function of the system?

Q: This question uses construction skills to determine the machine characteristics. A three-phase…

A: For a  three-phase delta-connected synchronous induction motor,

Q: sa 250 .. adm 200 (1) A A 01

A:

Q: An 50 2 resistor, a 5 mH inductor, and a 1.25 μF capacitor are connected in series. The…

A: A series RLC circuit is given R=50ohm ,L=5mH, C=1.25 uF , source voltage is Vs=600cos(8000t+20°)…

Q: Digital signal where frequency of massage 4000 and Quntzation value 4?? ۱:۰۲ ↓↓

A:

Q: 338 Network analysis and synthesis 11.7 An impedance function has the pole-zero pattern shown in the…

A:

Q: What is the capacitive reactance of the capacitor? Express your answer to three significant figures…

A:

Q: Find X(e) if the discrete time function is given by x[n] 96[n-2]+7μµ[n] b. C. d. X(e) = X(c)= 9…

A: This problem is related to frequency response of x(n).The step wise solution is given in next steps…

Q: A plane electromagnetic wave propagating along the z-direction in an unbounded medium has E(2,1)=3…

A:

Q: Consider the system shown below. Determine the value of a such that the damping ratio (3) of the…

A:

Q: 3- What is the minimum sampling rate required for the following signal that avoid aliasing case?…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: Equivalent circuit parameters of a delta connected induction motor; Its equivalent impedance is…

A: Given Circuit:Line voltage Equivalent Impedance To determine:Currents

Q: 1) Two identical voltage waveforms of difference phase angles are shown in Figure B. Write down the…

A:

Q: 1 A 2,400/2,200 V autotransformer delivers a load of 90.5 kW at a power factor of 0.75. Calculate…

A: 1.A 2,400/2,200 V autotransformer delivers a load of 90.5 kW at a power factor of 0.75. 2.Two…

Q: Design PD Controller for a unity feedbuck temperaturs control system has open loop. TF G (S) K such…

A: The open-loop transfer function of a system is given asWe need to design a PD controller to meet the…

Q: Consider the circuit shown below, where K = 0.2 mA/V2 and Vto = 0.8V. Suppose V1 and V3 must be…

A:

Speed control of motor

Speed control by DC motor-speed controller is required to realize variable speed drive. Whenever a motor drives a particular load, it is called drive, and variable speed drive refers to a load requiring variable speed. All this is obtained by a DC motor speed controller.