Question

Article 300

Direct-buried conductors or cables can be spliced or tapped without the use of splice boxes when the splice or tap is made in accordance with 110.14(B).

a. True.         B. False

Expert Answer

1 Rating

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Electrical Engineering

Related Electrical Engineering Q&A

Find answers to questions asked by students like you.

Q: Show that the system shown in the figure below oscillates at a frequency of 1 rad/sec.

A: This is a unity negative feedback system. For this system to oscillate at some frequency, we need tw...

Q: 4.26 Use source transformation to find voltages V, Vs and V in the circuit shown in Figure P4.26. FI...

A: Convert the 15 mA current source into voltage source and draw the circuit as shown in Figure 1.

Q: Excercise 2: Ideal PID controllers. Consider the systems represented by the block diagrams below r k...

A: (a)The transfer function for the given unity feedback system is given by the equation as  shown belo...

Q: An antenna has an effective length of 100 m and the current at the base is 450 A (rms) at 40 kHz. Wh...

A: The power radiated by the antenna can be expressed as

Q: small appliance receptacles included in the 3 volt-ampere per square foot load calculation

A: Small appliances receptacles are those circuits devoted for the utilization of interfacing little ma...

Q: Use linearity and the assumption that Vo = 1 V to find the actual value of Vo in the following circu...

A: A linear circuit is one whose output is linearly related or in other words which is directly proport...

Q: The electric and magnetic field associated with an EM wave is E=20 V/m and H=0.25 A/m respectively. ...

A: Intrinsic impedance of the medium can be defined in the following way:

Q: s) We noded 0holgss to Solve the aitteisb end nd uR loop Umobtis to Solue the wrts ond find

A: a) Nodal Analysis:Let V1 is the node voltage at node. 

Q: Also show that the power balance is achieved.

A: In the given circuit, apply Kirchhoff’s current law at node V as follows,

Q: Find the Thevenin's equivalent of the following circuit looking through ab. 2Ω 2Ω 2 A

A: To find the Thevenin voltage across the terminals a-b.The given circuit is redrawn as shown in Figur...

Q: Airframe Electrical System Question: What type of wiring method is most often employed in the design...

A: The type of wiring mostly  employed in the design and operation of aircraft electrical and electroni...

Q: Given H(s)=s2/(s+3)(s-2)(s-4) and ROC Re(s)>4. Estimate the impulse response h(t).    I have star...

A: To find the impulse response h(t) of the given transfer function:

Q: Electrical Engineering Question

A: Given circuit is shown below –

Q: A short 3 phase transmission line, connected to a 33kV, 50 Hz generating station at the sending end ...

A: As given in the question

Q: Feedback Control of Dynamic Systems (7th edition) - Problem 7.19

A: Click to see the answer

Q: 93uF 7 L 301 3302 5 Pa ssband ain190 vj İVJ I got the exact ftsl98.0549Hz- vil is the Voltage gan Va...

A: Write the expression to find exact value of lower cutoff frequency for the given circuit as follows:

Q: .il Verizon LTE 7:41 PM ร์ 100% Done 1- In the following circuit find ve) andi,(C) given; y(1) = 240...

A: From the given circuit, the switch is connected to v1(t) at t < 0. As the supply v1(t) is connect...

Q: The circuit has been under DC conditions for a long time. How much energy is stored in each capacito...

A: Modified given circuit diagram is –

Q: i Gu Pevse use Modol or mesn 10 A 2 Thearen 2Ω 12 10

A: Let us apply supernode at nodes 1 and 2:

Q: What is the difference between Laplace transform and CT Fourier Trabsform.

A: Fourier Transform converts a time domain function into frequency domain, and it is expressed in equa...

Q: Can you show me how to solve the following question? What will be the rate of energy use of a small ...

A: To find the rate of energy consumed by the motor with the rated value of one fifth of one horsepower...

Q: Airframe Electrical System Question: Why should solid, round conductor wire be avoided in aircraft? ...

A: Solid, round conductor wire should be avoided in aircraft because, due to flight vibration and flexi...

Q: 5.16 Use loop analysis to find the power (absorbed or re- leased?) by the dependent source in Figure...

A: The loop currents are as shown in figure-

Q: Two identical conducting spheres,fixed in a place, attract each other with an electrostatic force of...

A: It is given that electrostatic force of attraction between two identical spheres is 0.108N.And dista...

Q: The minimum point of attachment of the service-drop conductors to a building must in no case be less...

A: Service drop conductor is used to supply power to the consumer. These conductors either used as over...

Q: Noise Figure (F) of an amplifier at room temperature is 0.2 dB. What will be the effective noise tem...

A: Formula of effective noise temperature is –

Q: 20. What is the purpose of the PEM in a fuel cell? a. to prevent the hydrogen protons from passing t...

A: All the kinds of fuel cells work in a similar way and basically consists of three segments, that is,...

Q: 4. Find the current I assuming ideal diod es 1.2k2 10V (+ 15%4 12V+ 3V

A: The given is redrawn as shown in Figure 1.

Q: 2.18 Given the circuit shown in Fig. P2.18, find da soivsott Bo elsaim beicluder o lu a) the value o...

A: PSPICE Simulation:Draw the circuit diagram in PSPICE as shown in Figure 1.

Q: What will be the velocity of a TEM wave travelling through free space? Show detailed calculation.

A: The velocity of Transverse Electromagnetic (TEM) wave travelling through free space is dependent on ...

Q: A  Horn antenna is radiating at a frequency of 5 GHz and is having an area of cross section of 90 cm...

A: Directive gain of a horn antenna can be expressed as

Q: Airframe Electrical System Question: Name 10 wire insulation characteristics that must be considered...

A: Ten wire insulation characteristics that must be considered when selecting the best wire insulation ...

Q: Feedback Control of Dynamic Systems (7th edition) - Problem 7.25

A:  First, find out the canonical form from the given transfer function    and after that design a cont...

Q: ____ must not be installed beneath openings through which materials may be moved, such as openings i...

A: From Article 230 of National Electric Code (NEC), the following information can be obtained: Service...

Q: Please answer q2 with details

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3.Please resubmit the question and sp...

Q: Find voltage and currents across each resistor

A: First, calculate the value of equivalent resistance.

Q: Done 2 of 6 answer. You are allowed a simple calculato Answer: A Problem: Find Io in the following c...

A: The circuit Diagram is shown on the board:At node B, the two 6Ω resistors connected are in parallel ...

Q: What will be the intrinsic impedance of free space? Show detailed steps of calculation.

A: Intrinsic impedance of free space depends on permitivity and permeability of free space. Permitivity...

Q: Use source transformation to find vo in the circuit below. (Circuit is displayed in attached picture...

A: Consider the circuit diagram given, we can transform the voltage source with series resistor into an...

Q: Please answer all questions and give me a sample answers,   1- What determines the ampacity of a wir...

A: Since we answer only first question out of all given by student, we’ll answer the first .Please resu...

Q: help

A: Given that,

Q: In an n type semiconductor at T 300 K, the electron concentration varies linearly from 1017 to 3 x 1...

A: The mathematical expression for the diffusion current density due to diffusion of electrons in a n-t...

Q: For a continuous time LTI system, the output is given as Y(s)=10(2s+3)/(s2+4s+5).  Find out the fina...

A: Using final value theorem of Laplace transform, for any function y(t), the following equation can be...

Q: table 1 resistor value R1 8kohms R2 8kohms R3 6kohms

A: To calculate the Rth, short circuit the voltage source.Now, Draw the circuit diagram,

Q: Problem 3 Using source trans formations, find (a) the voltage at A; (b) the magnitude and direction ...

A: Using source transformation, convert the voltage source to a current source as shown in the figure.

Q: In the circuit in the figure, calculate the current (value and direction), the voltage across each r...

A: When voltage sources are connected in series, they will be added algebrically.So, the equivalent vol...

Q: If a current of 500 mA charges a dielectric for 2 s, how much charge is stored in the dielectric?

A: Dielectric material is that type of substance which is poor conductor of electricity. It can be pola...

Q: Find the steady state response for i0(t) in the circuit in fig 9.29 if Vs=100sin50t mV

A: Steady state response for the current needs to be calculated using the below given data and figure:

Q: What would be the total single phase 120kVA capacity that could be used with the transformers size o...

A: Given:Rating of the single phase transformer = 1.5 kVATransformer is connected with a 120 kVA load.