As a diligent physics student, you carry out physics experiments at every opportunity. At this opportunity, you carry a 1.33 m long rod as you jog at 3.25 m/s, holding the rod perpendicular to your direction of motion. What is the magnitude B of the magnetic field that is perpendicular to both the rod and your direction of motion and that induces an EMF of 0.283 mV across the rod? Express the answer in milliteslas. B = mT

As a diligent physics student, you carry out physics experiments at every opportunity. At this opportunity, you carry a 1.33 m long rod as you jog at 3.25 m/s, holding the rod perpendicular to your direction of motion. What is the magnitude B of the magnetic field that is perpendicular to both the rod and your direction of motion and that induces an EMF of 0.283 mV across the rod? Express the answer in milliteslas. B = mT

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter24: Magnetic Fields

Section: Chapter Questions

Problem 83A

See similar textbooks

Similar questions

Unreasonable results Frustrated by the small Hall voltage obtained in blood flow measurements, a medical physicist decides to increase the applied magnetic field strength to get a 0.500-V output for blood moving at 30.0 cm/s in a 1.50-cm-diameter vessel. (a) What magnetic field strength is needed? (b) What is unreasonable about this result? (C) Which premise is responsible?
A parallel-plate capacitor with plate separation d is connected to a source of emf that places a time-dependent voltage V(t) across its circular plates of radius r0and area (a) Write an expression for the time rate of change of energy inside the capacitor in terms of V(t) and dV(t)/ dt. (b) Assuming that V(t) is increasing with time, identify the directions of the elecuic field lines inside the capacitor and of the magnetic field lines at the edge of the region between the plates, and then the direction of the Poynting vector S at this location. (c) Obtain expressions for the time dependence of E(t), for B(t) from the displacement current, and for the magnitude of the Poynting vector at the edge of the region between the plates. (d) From S , obtain an expression In terms of ‘(t) and dV(t)/dt for the rate at which electromagnetic field energy the region between the plates. (e) Compare the results of pails (a) and (d) and explain the relationship between them.
A thin conducting bar (60.0 cm long) aligned in the positive y direction is moving with velocity v=(1.25m/s)i in a region with a spatially uniform 0.400-T magnetic field directed at an angle of 36.0 above the xy plane. a. What is the magnitude of the emf induced along the length of the moving bar? b. Which end of the bar is positively charged?
A toroid has a major radius R and a minor radius r and is tightly wound with N turns of wire on a hollow cardboard torus. Figure P31.6 shows half of this toroid, allowing us to see its cross section. If R r, the magnetic field in the region enclosed by the wire is essentially the same as the magnetic field of a solenoid that has been bent into a large circle of radius R. Modeling the field as the uniform field of a long solenoid, show that the inductance of such a toroid is approximately L=120N2r2R Figure P31.6
A uniform magnetic field B=5.44104iT passes through a closed surface with a slanted top as shown in Figure P31.59. a. Given the dimensions and orientation of the closed surface shown, what is the magnetic flux through the slanted top of the surface? b. What is the net magnetic flux through the entire closed surface?
Can you use a mass spectrometer to measure the mass of a proton? Can you use a mass spectrometer to measure the mass of a neutron?
A particle moving downward at a speed of 6.0106 m/s enters a uniform magnetic field that is horizontal and directed from east to west. (a) If the particle is deflected initially to the north in a circular arc, is its charge positive or negative? (b) If B = 0.25 T and the charge-to-mass ratio (q/m) of the particle is 40107 C/kg. what is ±e radius at the path? (c) What is the speed of the particle after c has moved in the field for 1.0105s ? for 2.0s?
A velocity selector consists of electric and magnetic fields described by the expressions E = E k and B = B ĵ, with B = 10.0 mT. Find the value of E (in kV/m) such that a 840 eV electron moving in the negative x-direction is undeflected. kV/m (b) What If? For the value of E found in part (a), what would the kinetic energy of a proton have to be (in MeV) for it to move undeflected in the negative x-direction? MeV A cyclotron designed to accelerate protons has a magnetic field of magnitude 0.640 T over a region of radius 1.80 m. (a) What is the cyclotron frequency? rad/s (b) What is the maximum speed acquired by the protons? m/s