The time rate of change of momentum in the control volume (accumulation rate of momentum in the control volume),(N). absolute value.The net out flow rate of momentum through the control surface in vertical direction (N). absolute value.22170.25the tension in the cable in (N). absolute value.12800The scale reading in (N). absolute value.22970.25 As shown in the sketch, fluid with specific gravity, S = 2 flows into a cart sitting on a scale. The stream of fluidhas an area of A = 0.126 m2, and a speed of V = 10 m/s. At the instant shown, the weight of the cart plus thefluid is 800 N. Water density = 1000 kg/m, g- 9.81 m/s. Assume steady flow. Determine:%3D%3DFluidJooScale

Given DataA=0.126m2V=10m/sW=800Nρ=1000kg/m3g=10m/s2

As shown in the sketch, fluid with specific gravity, S = 2 flows into a cart sitting on a scale. The stream of fluid has an area of A = 0.126 m2, and a speed of V 10 m/s. At the instant shown, the weight of the cart plus the fluid is 800 N. Water density = 1000 kg/m, g= 9.81 m/s. Assume steady flow. Determine: %3D

As shown in the sketch, fluid with specific gravity, S = 2 flows into a cart sitting on a scale. The stream of fluid has an area of A = 0.126 m2, and a speed of V 10 m/s. At the instant shown, the weight of the cart plus the fluid is 800 N. Water density = 1000 kg/m, g= 9.81 m/s. Assume steady flow. Determine: %3D

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Water (density 1000 kg/m3) is flowing past a long cylinder at 1 m/s. The cylinder has a diameter of 0,05 m and a length of 0,4 m. The axis of the cylinder is perpendicular to the distraction of flow. What is the force on the cylinder in N?
Carbon dioxide flows in a horizontal 100 mm wrought iron pipeline at a velocity of 3 m/s.At a point in the line a pressure gage reads 690 kPa and the temperature is 40°C. What pressureis lost as the result of friction in 30 m of this pipe? Barometric pressure is 101.3 kPa. Assumethe fluid is of constant density
Once it has been started by sufficient suction, the siphon in the Fig. will run continuously as long as reservoir fluid available. Using Bernoulli's equation with no losses, show (a) that the exit velocity V2 depends only on gravity and the distance H and (b) that the lowest vacuum pressure occurs at point 3 and depends on the distance L+H
A horizontal turbulent liquid jet of diameter D and average velocity Vj deflected at the angle by a cane mounted on a cart, this exerting a force on the vane, determine the opposing force needed to keep the plate moving at a constant velocity Vv. Neglect the viscosity and gravity forces.
Question : Water flows through a circular nozzle, exits into the air as a jet, and strikes a plate, as shown in the figure. The force required to hold the plate steady is 75 N. Assuming steady, frictionless, one-dimensional flow, estimate Part (a) the velocities at sections (1) and (2) and Part (b) the mercury manometer reading h.
Two circular water jets (d = 0.5 in.) issue steadily from this unusual nozzle. If Vj = 80.2 ft/s, what force is required at the flange to hold the nozzle in place in the x-direction. The pressure in the 4 in. pipe (D = 3.5 in) is 50 psig.
If a hole is drilled at the bottom of a full bucket of water of height. H 60 meter what is the second velocity and first if we have pressure 1 in the air is 103 kpa and pressure 2 760pa (proof the equation you used to solve it ) Kindly re-draw the diagram.
Water flows through a rectangular duct of height h = 575.5 mm and width b = 100 mm.(coming off screen) and enters a 90° elbow. At the entrance of the elbow, flow can be considereduniform with speed U = 58 m/s. At the output, a linear velocity profile must be consideredas shown in the figure, where Vmax = 2Vmin. Calculate the value of Vmin in m/s.
When gage A indicates a pressure of 100 kPa gage, then cavitation just starts to occur in the venturi meter. If D = 40 cm and d = 10 cm, what is the water discharge in the system for this condition of incipient cavitation? The atmospheric pressure is 100 kPa gage, and the water temperature is 21°C. Neglect gravitational effects.
04/13/2021 For this exercise Study and Derive the Bernoulli equation starting with the application of Newton’s second law to a fluid particle.
2.19 The two-dimensional rectangular water jet strikes a flat plate as shown. Calculate the reactive force R. What percentage of the total mass flux is diverted down the plate? Hint: For this problem, remember that you get to pick where you place your coordinate system, and more importantly, how you orient it! Also, note that rho u A has units of mass/time and is usually called mdot. Use Conservation of Mass and Conservation of Momentum to get two equations involving m1dot, m2dot, and m3dot. Eliminate m3dot and solve for m2dot in terms of m1dot. Make use of Bernoulli’s equation.
Q7. Cavitation just starts to occur in the venturi meter shown in Figure 5 when gage A indicates a pressure of 100 kPa gage. If D = 30 cm and d= 10 cm, what is the water discharge in the system for this condition of incipient cavitation? The atmospheric pressure is 100 kPa gage, and the water temperature is 25°C. Neglect gravitational effects.