Assume that a thin-walled cylindrical container with a radius of 65 mm and a length of 1 m should used to transport gas under pressure. Internal pressure is 10.13 MPa and external pressure is 0.2026 MPa. Calculate the required thickness and cost in US dollars for each of the alloys in the table below. Use a safety factor of 3.5.

Assume that a thin-walled cylindrical container with a radius of 65 mm and a length of 1 m should used to transport gas under pressure. Internal pressure is 10.13 MPa and external pressure is 0.2026 MPa. Calculate the required thickness and cost in US dollars for each of the alloys in the table below. Use a safety factor of 3.5.

Welding: Principles and Applications (MindTap Course List)

8th Edition

ISBN:9781305494695

Author:Larry Jeffus

Publisher:Larry Jeffus

Chapter26: Welding Metallurgy

Section: Chapter Questions

Problem 26R

See similar textbooks

Similar questions

Q1a) A sample of an aluminum alloy has a tensile strength of 275 MPa, What will be the maximum force that can be withstood by a rod of that alloy with a cross-sectional area of 2.09 cm2?
in a tabular format compare composition and heat treatment for different cast irons and steels
Bainite phase and pearlite phase have different mechanical properties due to its structure differences. Discuss the hardness and tensile strength of these 2 phases using isothermal transformation temperature diagram.
For a 1095 steel alloy, what would the percent of each phase be at 730°C and 725°C?
In a eutectoid steel the following microstructures are required for different application. Suggest cooling rate and sequences to achieve them. a) 50% Pearlite and 50% Bainite b) 50% Bainite and 50% Martensite c)100% fine Pearlite d) 100% Martensite e) 50% Peralite and 50% Martensite
As the tempering temperature of a heat treated steel increases the associated values of Brinnell hardness also increase, while the values of tensile strength and yield strength decrease. True or false
What are they and what is their application in the production of the following steels: TTT diagrams. Isotherm Transformation TTT diagrams. Steel Concentration Eutectoid
Determine the yield strength sy and the ultimate strength su of the A36 steel either from Materials Science class book/notes, or by researching over the internet.
Make use of drawings of segments of the Fe-Cr phase diagram to illustrate the reason for theexistence of ferritic, martensitic and austenitic stainless steels by also noting the influence ofspecific alloying elements where applicable.
in a tabular format compare microstructure,for different cast irons and steel
10.11/ A 1.5-kg specimen of a 90 wt% Pb-10 wt% Sn alloy is heated to 250°C (480°F), at which temperature it is entirely an a-phase solid solution . The alloy is to be melted to the extent that 50% of the speci- men is liquid, the remainder being the a phase. This may be accomplished either by heating the alloy or changing its composi- tion while holding the temperature con- stant. (a) To what temperature must the speci- men be heated? (b) How much tin must be added to the 1.5-kg specimen at 250°C to achieve this state?
In a tabular format, compare (a) Composition and heat treatment, (b) microstructure, for different cast irons and steels.