Assume you are working on sinusoidal ac supply voltage which is in the form of 150 sin 220 t. So apply this voltage find out following parameters. Analyze the rms value of voltage. Options. A) 106.05 volt B) 150 volt C) 135 volt D) 130.5 volt

Assume you are working on sinusoidal ac supply voltage which is in the form of 150 sin 220 t. So apply this voltage find out following parameters. Analyze the rms value of voltage. Options. A) 106.05 volt B) 150 volt C) 135 volt D) 130.5 volt

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.15P: Let a voltage source v(t)=4cos(t+60) be connected to an impedance Z=230. (a) Given the operating...

See similar textbooks

Related questions

Q: Determine the RMS magnitude of Current I.

Q: RMS value of sinusoidal voltage is given by Vrms= 5 V, Calculate the value of peak voltage Vm? a.…

A: In the question The RMS value of sinusoidal voltage is given by Vrms= 5 V, Calculate the value of…

Q: An AC generator causes 50 Hz current in a circuit containing a 290 Ω resistor, 4.89 µF capacitor,…

Q: An industrial heater has a nameplate that reads: 200 V, 60 Hz, 12 kVA, o.788 pf lagging Determine…

A: Disclaimer: Since you have asked multiple questions, we will solve the first question for you. If…

Q: An AC source operating at 60 Hz with a maximum voltage of 170 V is fed to a series combination of…

A: Find the value of capacitive reactance.

Q: Example: Find the rms value for the current waveform shown below: 2 1 1 3 4 t(sec)

A: First we will find out the current equation then we will find out RMS value by RMS formula.

Q: RMS value of sinusoidal voltage is given by Vrms= 5 V, Calculate the value of peak voltage Vm? a.…

A: For a sinusoidal voltage of peak value Vm and RMS value Vrms , Relation between peak value Vm and…

Q: +espa

Q: Q1. Referring to the Figure Q1, answer the following questions: VI V1(wt) 40 V V(ot) 20 V Vm1 Vm 10…

Q: voltage given by v(t) = 311 cos (311 pi t) V is applied to a 50-ohm resistance. (a.) Sketch v(t) to…

Q: wo electric devices A and B are connected in parallel, and the rms current in A is 15 amp. If the…

A: It is given that: IL=23.3 AIA=15 A

Q: Two electric devices A and B are connected in parallel, and the rms current in A is 15 amp. If the…

A: In this question, Two electric devices A and B are connected in parallel, The rms current in A = 15…

Q: Volts 12 t (sec) Find the RMS value of the voltage waveform, Find the average power if 8 2 resistor,…

Q: 1. Determine the RMS values of voltage and current, and the total power absorbed by the circuit…

A: In this question, two signals are given in harmonic form. We need to determine the rms value of…

Q: In the circuit in the figure, there is a load consisting of the series connection of the resistor R0…

A: Given circuit shown with Voltage source Amplitute =1502 vPhase angle θs=0°Time period T=200π μsR=300…

Q: Vpk wt 2n

Q: 69 9V ZL Sinusoidal voltage of RMS value 9 Volt is applied. Resistance value R = 12 ohm. Determine…

A: In this question we need to find a value of load impedance for maximum power transfer to load and…

Q: An alternating current is represented by the equation: i(t) = 150sin 628t Calculate; 1.The…

A: Given : Equation for an alternating current , i = 150sin (628 t) .....( 1 )

Q: c) ead /y 1. Peak to peak ripple is defined as a) The difference between average de voltage and peak…

A: 1. Peak to Peak ripple is defined as The difference between maximum ac and average dc voltages. So…

Q: a-Find the RMS values of the load voltage and the load current b-Calculate and draw the voltage…

Q: d. Write the equation for the power as a function of time. e. You measure the rms current (with a…

A: The given graph is power waveform. What is power equation, voltage equation, current equation.…

Q: Determine the instantaneous equation for the voltage waveform shown in figure, if Vp=200 Volts, Time…

Q: A three-phase 4-pole, 144 slots with 10 conductors per slot, star connected alternator it runs at a…

A: In this question, We need to Calculate the RMS value of the induced emf per phase and the line…

Q: Determine the instantaneous equation for the voltage waveform shown in figure, if Vp=200 Volts, Time…

A: In this question, we have to find out instantaneous equation for voltage wave...

Q: Five infinite-impedance voltmeters are calibrated to read rms values. The voltmeters read V1=30…

A: The circuit diagram is shown below: The different given voltages across the circuit are as follows:…

Q: An AC circuit is shown in the diagram. The source of emf has a peak voltage of 9.00 V and a…

Q: An industrial load connected to a 440 V, 60 Hz line takes 50 A. The current lags the voltage by 30…

A: Given:- Voltage (V)=440 V Frequency (f)=60 Hz Current (A)=50 A Current lags the voltage by 30…

Q: Two electric devices A and B are connected in parallel, and the rms current in A is 15 amp. If the…

Q: Q1. Referring to the Figure Q1, answer the following questions: V1(ot) 40 V v(ot) 20 V- Vm1 10 A…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost other…

Q: Consider the AC voltage shown below. vz (t) = 2 * cos (50nt + Specify the period of the voltage in…

Q: 3. When an electrician refers to a voltage as being 1200 V ac, it is understood that he means the…

Q: Find the RMS value of the waveform depicted below. Given A = 9, a = 2, b = 8, and T = 13 %D

Q: a) What is the frequency in Hertz and rad/s of the voltage waveform shown on Figure Q1? (b)…

A: Any time domain signal can be sinusoidal, DC signal or any curve signal. Sinusoidal signals are…

Q: In the circuit in the figure, there is a load consisting of the series connection of the resistor R0…

Q: Find the rms of the below voltage waveform 2.

A: RMS of AC is that value which when passes through a resistor of known value for a particular…

Q: 1. Derive the formula for the RMS value for the following a) tespe 文 RSITY SAIN

A: The solution is given below

Q: Find the RMS and average value of the offset sinewave shown in Fig.2 i(t) 4 TT

A: In practical scenario, the alternating voltage is generated which is of sinusoidal nature and is…

Q: Let voltage across a load be v(t) = 20 + 40 cos(100t) volt and current through the load by i(t) =…

Q: Q33-Q37 refer to the table below: The line currents in a balanced 60 Hz, 4-wire system has the…

A: Note :- As per guidelines we are supposed to answer only 3 sub-parts. So please post separately rest…

Q: Consider the following waveform. Volts 5 AA 12 t (sec) -5 Find the RMS value of the voltage…

A: RHS of common signals

Q: 60 hz voltage of 220 volts from a convenience outlet is impressed on a capacitance of 800 pF.…

A: Given capacitor of capacitance 800 pF is connected across 220 volts rms source. capacitive reactance…

Q: Problems 1. Find the rms values of different harmonic components and total emf per phase for an…

A: RMS value of harmonics and emf is calculated as shown below

Q: Example: Find the rms value for the current waveform shown below: 1 1 3 4 6 t(sec)

A: RMS Value of a signal: It's that steady state equivalent of a time varying signal which would…

Q: In the circuit in the figure, there is a load consisting of the series connection of the resistor R0…

Q: A three phase alternator has generated EMF per phase at 230 V with 10 percent third harmonic and 6 %…

Q: IV) For the voltage waveform shown below. If the voltage is in volts and the time is in…

A: The solution is given below

Q: The equation of alternating voltage is given by ν = 325.22 ???314?. Find (i) RMS value (ii)…

A: The solution is given below

Q: Solve for 20 V rms supply. Thank you.

A: Given, The circuit is Vrms=20 V

Q: An alternator is supplying 300 kW at a power factor of 0.6 lagging. If the power factor is raised to…

A: An alternator Active power P =300 kW a power factor of 0.6 lagging. If the power factor is raised…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 3 phase 10 pole 600 rpm delta connected alternator has 12 slots/pole with 8 conductors per slot. The windings are short chorded by 2 slots. The flux per pole contains a fundamental of 100 mwb, the third harmonic having an amplitude of 33% and fifth harmonic of 20% of the fundamental. Determine the rms value of the phase ,line voltages and Circulating Current Please answer in typing format please
1. Determine the RMS values of voltage and current, and the total power absorbed by the circuit element
An AC generator having an internal resistance of 2 k*(omega) is connected to an LCR circuit in series as shown in the figure. If the generator supplies an electromotive force, E = 282 sen (100*pi*t) volt, calculate:a) the impedance of the circuitb) the rms value of the current in the circuitc) the voltage drop across L, C and R
A load of 10,000 kVA, 80% pf lagging is connected to a 13,200 volts line. How much capacitive reactive power is needed to correct the power factor to 0.97 lagging?
For single phase ac voltage controller, R=15ohm, f=50Hz and Vrms=230V and α=0,82 rad. Calculate the rms load voltage (V). In this question, take 2 digits after the comma and take pi = 3,14; enter your answer into the system in terms of the desired unit only as a number.solve the question by using the rules of power electronics
One phase of a 3-phase alternator consist of 12 coils in series. Each coil has an rms voltage of 10Vinduced in it and the coils are arranged in slots so that there is a successive phase displacement of10 electrical degrees between the emf in each coil an the next. Find by calculation the rms value ofthe total phase voltage developed by the winding. If the alternator has six pole and is driven at 100rpm.
What is the rms value of the applied voltage?? Choose the correct answer.
: An AC source operating at 60 Hz with a maximum voltage of 170 V is fed to a series combination of1.2kΩ resistor and 2.5μF capacitor connected in a timer circuit. How can you evaluate the maximumcurrent in the circuit? Can you estimate the rms value potential difference across each circuit element?Compare the power factor of this timer circuit with a circuit contain only ohmic resistance. Justify youranswer?
calculate the rms value in v of this signal shown below:
15. A residential AC power line voltage is 230 V. What are the average and peak-to-peak voltages? a. 207.0727 and 414.1454 b. 207.0727 and 650.5385 c. 230 and 260 d. 325.2691 and 207.0727
Your company has been chosen to supply a 50 Hz alternator to a European utility. The stator is wye connected with each phase winding having 36 turns of wire. The rotor is supplying 0.127 Wb of flux in the center of pole face. What is the rms value of the output voltage if measured line to line
A supply voltage v given by v = (240 sin 314t + 40 sin 942t + 30 sin 1570t) volts is applied to a circuit comprising a resistance of 12 ohmconnected in series with a coil of inductance 9.55 mH. Determine (a) an expression to represent the instantaneous value of the current, (b) the rms voltage, (c) the rms current, (d) the power dissipated, and (e) the overall power factor.