B7 Assuming that 30% of the rainfall runs off, the volume of runoff (acre-feet) from a storm with a 1.32in/hr average intensity for 1.75 hrs on a 160-acre watershed is_________ acre-feet. Round to 1significant figure. The time of concentration for a watershed with a 10,000 ft. flow length that has a slope of 5.00%slope isminutes.

Since you have asked multiple question, we will solve the first question for you. If you want any…

Assuming that 30% of the rainfall runs off, the volume of runoff (acre-feet) from a storm with a 1.32 acre-feet. Round to 1 in/hr average intensity for 1.75 hrs on a 160-acre watershed is significant figure.

Assuming that 30% of the rainfall runs off, the volume of runoff (acre-feet) from a storm with a 1.32 acre-feet. Round to 1 in/hr average intensity for 1.75 hrs on a 160-acre watershed is significant figure.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Solve for the reactions and draw the shear and moment diagram. (1) (3) (5) (7) (9) 10 kN-m 5m 5 m 4…

Q: A and B are two stations Whose coordinates are (585.1 E,1056.9N), (992.7 E,1426.5 N) Find Length and…

Q: gligibl Solved Examples Q.6. Show that the natural period of a light weight with central point load…

A: solution of above problem is below:

Q: 1. After the Taal Volcano erupted, two personnel from the Philippine Institute of Volcanology and…

Q: Draw the shear and moment diagrams for each member of the frame. Assume A is a pin, B and C are…

A: ∑MA=0HD×10 - 2×1022 - 8×8 - 8×4=0HD=19.6 k ←∑H=02×10-HA-HD=02×10-HA-19.6=0HA=0.4 k…

Q: Q7. Capillary A 0.4 mm diameter glass tube is inserted into water at 15 °C in a cup. If the contact…

Q: Considered is 20 deg C and a maximum temperature of 30 deg C is designed for, and the modulus of…

A: Given Maximum temperature= 30 deg C

Q: A water sample is analysed for coliform organisms by the multiple-tube fermentation method. The…

A: Given that, We have to calculate using the above table

Q: A very wide rectangular channel carries a discharge of 8 m³/s per metre width. The channel has a bed…

Q: Q-100 m³ of sludge holds a moisture content of 95%. If its moisture content changes to 90%, the…

A: Given data: Sludge volume, V1 = 100 m3 At moisture content, P1 = 95 % For moisture content, P2 = 90…

Q: Find dry density of soil

A: Introduction : The given question is related with geotechnical engineering . In this question we are…

Q: If the load has a weight of 200 lb, determine the x, y, components of reaction at the…

A: Given : Weight = 200 lb Determine x, y and z component of reaction at the ball and socket joint A…

Q: What are the advantages of masonry walls over framed (wood) walls?

A: A masonry wall is one that is constructed using elements that have historically been mortared…

Q: Determine the MPN of coliform organism per 100 ml ?

A: Given. Water sample is analysed for coliform organism by the multiple-tube fermentation method. Test…

Q: A highway designed for 80 km/h speed has a horizontal curve section with radius 250 m. If the design…

A: Given: Design speed = 80Kmph Radius =250m Lateral friction fully developed Required: Superelevation

Q: The equation of deformation is derived to be y = x³ - xL for a beam shown in the figure. YA L The…

Q: . 1. (b) A thin walled tube with an internal diameter of 35 cm and a wall thickness of 6 mm is…

Q: A trapezoidal channel with bottom width of 3m and side slope of 1V: 1.5 H carries a discharge of 8.0…

Q: Two roads AB and BC intersect at a chainage 184+65. These are intersected by a line PQ and the…

A: Given, a compound curve with 2 circular parts is shown in the figure. Chainage of B = 184 + 65 =…

Q: The curvature of the beam at the mid-span

A: ###Determination of Curvature of Beam at Mid Span ###

Q: Determine (approximately) the reactions at the base of the columns of the frame shown. Use the…

A: Area of columnsAJ,AO=0.0625 m2AK,AP=0.09 m2AL,AQ=0.093214 m2 To determine:Reactions at supports

Q: 25 kN a 100 kN 6.0 m b 4.0

Q: The internal diameter of a tube is 0.1 mm. What will be the maximum capillary rise when it is held…

Q: Draw the shear and moment of the beam shown 30 kN-m 10 kN 1.5m, 1.5 m, 1.5 m, 1.5 m ism, 1.5

Q: P.T, P.I, P.C are the basic for setting a Vertical . curve requirements True O False O

A: To find out the basic requirement for setting a vertical curves.

Q: Problem 2. Given the following traverse notes for a closed traverse, LINES AB BC CD AZIMUTH 225°…

A: Given: Lines Azimuth Distance AB 225o 1200 m BC 346o 1400 m CA - -

Q: The surface area

A: Given data, Total flow of a secondary clarifier is,Q= 9600 m3/d Concetration of solids in the flow…

Q: Hydrographic surveys deal with the mapping of heavenly bodies O large water bodies O canal system O…

A: To find out the hydrographic survey deal with which of the following.

Q: 12. Complete the benchmark-leveling field notes shown in Figure B by computing and recording the HI…

A: Objective: To completer the given leveling notes and perform the arithmetic checks. Given: Sta.…

Q: #2 d=37 cm 17 3#8=15cm² = A's -4#11 =40cm² = As fc=280 Kleur fy=4200 kg/au- bw=40cmt Determine pun…

Q: Draw the shear force and bending moment diagrams of the cantilever beam shown using METHOD OF AREAS.…

A: Solution No horizontal force, so HA = 0 Σ Fy = 0 VA + VB + VD = (12×5×12) + (12×10) VA + VB + VD =…

Q: Draw the shear force and bending moment diagrams of the cantilever beam shown using METHOD OF AREAS.…

A: Solution ΣFy = 0 VA + VB + VF + VG = (15×13) + 120 + (10 ×13) VA + VB + VF + VG = 445 kN…

Q: 3. FIND THE CY OF SOIL TO BE EXCAVATED FOR A BASEMENT EXCAVATION GIVEN AN EXCAVATION HEIGHT OF 9'0",…

Q: Q4: A. Calculate the pressure of steam at a temperature of 500°C and a density of 24 kg/m³ using

Q: Traversing Principles: Missing Data Problem 1. A close traverse shows tabulated values of latitudes…

Q: Calculate the density, specific weight, and specific volume of oxygen at and 40 kPa abs. b. If the…

Q: compute the azimuth and bearing of the remaining lines. Draw the figure

A: ###Computation of Azimuth and Bearing of the remaining lines####

Q: Determine the superelevation required

Q: 14 SHEAR 113. Find the stresses in members BC, BD, and CF for the truss shown in Fig. P-113.…

Q: The sequent depth ratio of a hydraulic jump in a rectangular horizontal channel is 10.30. The Froude…

Q: A solid shaft of 4 in. diameter is to be substituted with a hollow shaft of the same material and…

A: Given : solid shaft dia = 4 inch Hollow shaft wt per foot is half of solid shaft. Hollow shaft per…

Q: Specify the type of fabric.

A: Given:- A reverse-air baghouse is to be designed to remove fly ash The power plant exhaust gas…

Q: The table below contains the information about two embankment sections. The distance between them…

A: The given data is shown below: Distance=30 mFormation width=6m to 9m

Q: .70 quired: 1 A 20KN 1.0 3.0m B 1. The horizontal reaction at hinge B. 2. The vertical reaction at…

Q: All angles are preferred to measure clockwise because of the graduations of theodolite circle…

Q: 1. A stepped shaft is shown, the region AB is aluminum having G=28 GPa, and the region BC is steel,…

Q: Determine the moments, shear, and axial forces in the members of the frame shown using the…

Q: In each of the following problems, draw the shear and moment diagrams and identify the location and…

Q: У L

A: Given:- y=x3-xL To find:- curvature of the beam at themid-span

Q: 11. For the truss shown in Fig. P-111, calculate the stresses in members CE, L DF. The…

A: To find stress in DE,DF,CE

Question

Assuming that 30% of the rainfall runs off, the volume of runoff (acre-feet) from a storm with a 1.32
in/hr average intensity for 1.75 hrs on a 160-acre watershed is_________ acre-feet. Round to 1
significant figure.

The time of concentration for a watershed with a 10,000 ft. flow length that has a slope of 5.00%
slope is
minutes.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

The drainage area of a watershed is 50 km². The index is 0.5 cm/hour and the base flow at the outlet is 10 m³ /s. One hour unit hydrograph (unit depth = 1 cm) of the watershed is triangular in shape with a time base of 15 hours. The peak ordinate occurs at 5 hours The peak ordinate (in m³/s/cm) of the unit hydrograph is
T / F: Most streamflow in forested areas comes from overland flow. T / F: Clearcutting a forest increases evapotranspiration and decreases baseflow in streams.
A flow of 10 cfs enters a 1-mi? vertical walled reservoir. Find the time required to raise the reservoir level by 6 in.
The average flow rate (release) through Grand Coulee Dam is 110,000 ft3/s. The width of the river downstream of the dam is 100 yards. Making a reasonable estimate of the river velocity, estimate the river depth.
The precipitation observed by three gauges A B. and Care 8mm, 10mm. and 12mm for thee sub - watersheds have areas of 9.1 km2, 2.1 km2 and 11 km 2. The catchment average depth depth is equal to??
A stream having a discharge per meter width of channel of 0.93 cu.m./s has a depth after a jump of 1 meter. Determine the velocity of the water before the jump and the head lost in the jump.
A storm with a uniform depth of 1 in. falls on a 25-acre watershed. Determine the total volume of rainfall in acre-feet and cubic feet. If all of the water were collected in a storage basin having vertical walls and a floor area of 25,000 ft2, how deep of a basin would be needed?
Determine the peak runoff (Nearest whole number) from a 100-year storm for the watershed described below: Field 1: 192 acres, 2% slope, cultivated, sandy soil Field 2: 38 acres, 8% slope, pasture, tight clay soil Field 3: 40 acres, 11% slope, woodland, silt soil The drainage way is 4000 feet with a 0.1% slope.
A rectangular open channel of width 5.0 m is carrying a discharge of 100 m3/s. The Froude number of the flow is 0.80. The depth of flow in the channel is
A stream having a discharge of 280L/sec per meter width of channel has a depth after the jump of 90 cm. a. What is the velocity of water before the jump? b. What is the head lost in the jump?
Question #2 Data: q= 2200 cfs q= 62.2970 cms The watershed above the same location at Little Alamance Creek is 7.2 square miles. Given the bank full discharge from question #2, what is the rainfall depth equivalent across the watershed, in inches, for a 1 hour rainfall?
Determine the critical flow depth and the specific energy related to the critical flow depth for a volumetric flow rate of 5.0 cubic meters per second in a triangular channel with a slope coefficient of 0.5