Answered: At 50Hz operation a single phase…

At 50Hz operation a single phase transformer has eddy current loss of 100 W, Its eddy current loss at 60Hz operation will be

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter4: Symbols

Section: Chapter Questions

Problem 7SQ: The symbol shown is a(n) a. iron core transformer. b. auto transformer. c. current transformer. d....

See similar textbooks

Related questions

Q: The direction of the field pattern in going and outgoing produced by a current flowing through a…

A: Single conductor Transmission line is a method of transmitting electrical power or signals using…

Q: 4.10 A buck regulator has an input voltage of 12 V and the required output voltage is 5 V. What is…

Q: Impedances z₂ and z3 in parallel are in series with an impedance z₁ across a 100V,50Hz AC supply. Z₁…

A: For the above given question we need to calculate the value of current, power and XC at resonance.

Q: a=2 A 4-pole, 25 kw, 250V, wave-wound shunt generator has 361 armature turns, If the brush leads by…

Q: Problem 6. The resistance of 1.5 km of wire of cross-sectional area 0.17 mm² is 150 22. Determine…

A: Given: Resistance, R=150 Ω Length, l = 1.5 km = 1500 m Cross sectional area, A=0.17 mm2=0.17×10-6 m2

Q: B- choose the correct answer: 1. He had clearly.... a) abandoned b) absolved 2. The manager had lost…

A: 1. He had clearly abounded all pretenses of trying to success, Therefore, option (a) is correct. 2.…

Q: Compare between lead compensator design and lag compensator design?

A: Compensator and controllers are used to alter the performance of control system Controllers are…

Q: Find the Thevenin's and Norton's equivalent circuit 30 Ω Μ | j10 Ω 120/45° V 60 Ω j5 Ω wwww -ob

A: Calculation of Thevenin's and Norton's equivalent circuit. To get thevenin's equivalent circuit we…

Q: A BC chopper is used in regenerative braking mode of a dc series motor. The dc supply is 600 V the…

A: Given a DC chopper is used in regenerative breaking mode of a DC series motor with, Supply voltage,…

Q: Example 5.3 Calculate the cut-off or "breakpoint" frequency (fe) for a simple passive high pass…

Q: Balanced 3 Phase Supply CC PC S B A NB N The 3-phase load consumes a totál power of 42 kW at 0.4…

Q: sisting of a coil of inductance 0.1 H and resistance 8ohms and a capacitor of 120uF nected to a…

Q: C t V sine R2 Let R1 = 4 ohm, R2 = 2 ohm, reactance of the capacitor -j3 ohm and reactance of the…

A: In this question , we will find voltage across Inductor and current through capacitor....

Q: Q3) For the circuit shown below, calculate: VPIS 1- Current I. 2- Resistance voltage VR. 3- VDI- 4-…

A: In the given figure, the diode D1 & D2 are forward biased but diode D3 reverse biased. The…

Q: 1. Calculate the power gain in decibels for each of the following cases. a. Po 100 W, P₁ = 5 W.

A: Given, Output power, Po=100 W Input power, Pi=5 W

Q: In a full wave bridge rectifier, the input sine wave is 40sin100nt. What will be the average output…

A: given in a full wave bridge rectifier , the input sine wave is 40 sin 100πt .here we have to find…

Q: A) We have an amplifier that amplifies a 1 kHz signal from a detector. The load for this amplifier…

A: Let know that first order RC Low pass filter is given by Hf=11+ffL2 Given that f=500kHz, Hf=0.1

Q: Problem 2 Find VR (t) for all time t. 4 V 202 HI st=0 t=0 2 H + VR 222 Ω

A: In this question, We need to determine the voltage across the resistance R as shown the circuit.…

Q: +CC W1 +PC 6V 3A 15V + PC- +CC W2 Wattmeter W1 reads 75 W Wattmeter W2 reads 60 Determine the total…

A: Two wattmeter method is used to find balanced or unbalanced three phase three wire circuits Three…

Q: b) Find the capacitance of a parallel plate capacitor if the area of each plate is 0.1 m² and the…

A: area of each plate is 0.1 m2 and distance between the plates is 2 mm and dielectric is oil with a…

Q: /102 resistance in parallel with 50l F Capacitance the Current through the capacitance is: (c(+) = 2…

A: Given,Resistance, R=10 ΩCapacitance, C=50 μFThe current through capacitance is,ict=2 sin100t+1.5…

Q: In the below given figure, two capacitances are in series with a 18V source. The capacitance of the…

A: When two capacitance connected in series then charge flowing through capacitor remain same but…

Q: Find the output waveshape in the following figure. Consider, silicon diode barrier potential 0.7V…

A: In this question, We need to draw the output voltage waveform. Assume forward bias voltage of si…

Q: Find VR (t) for all time t. 4 V 202 F t= t=0 2 H + VR202

A: For the above given question we need to calculate the value of resistor voltage for all time t.…

Q: For a robust composite, the interfacial strength between the continuous and discontinuous phase must…

Q: B/ Find the (BCD) for the decimal number (71536) when the code is :- 1- code (9,- 4, 3, -2) 2- code…

A: Given here a decimal number and asked to find its representation in BCD code when different codes…

Q: Problem 2 Find V (t) for all time t. 4 V GAD 202 W 41 t=0 t=0 A 7 2 H + VR202 I

A: In this question we need to find a voltage VR(t) for all time

Q: A 600 kVA single phase transformer with 0.012 pu resistance and 0.06 pu reactance is connected in…

A: Given that , there are two transformer of 600 kVA and 300 KVA We will refer the concept of parallel…

Q: Q4. In a CE germanium transistor amplifier circuit shown in (fig. 5). Determine the 0.985. operating…

A: For the above given common emitter amplifier circuit we need to calculate all the DC parameters and…

Q: Q2:- A platinum resistance thermometer has a resistance of 120 at 25°C. Determine its resistance at…

A: the materials which have the positive temperature coefficient value, the resistance value increases…

Q: = For (s) 10(s² +15 s+49) s(S²+5+5) Find LG(jw) for w = [0.1 1 10 ].

A: In this question, We need to determine the angle of the given system at different different…

Q: The switch in Figure 3 is being closed for a very long time and it is opened at t = 0. Determine: -…

A: The given circuit diagram is shown below:

Q: Hexadecimal Subtraction: B9AC‬16 - D8BE‬16

A: Hexadecimal subtraction is calculated as

Q: A 40 - Ω resistor is connected in series to a parallel combination of a 60 - Ω resistor and a 30 - Ω…

Q: Q1) For the circuit shown in fig.(*), the supply voltage is v(t) = 50 + 40 sin(wt) + 30 sin(3wt-30)…

A: In this question we need to find a power factor of the given circuit.

Q: This is the answer plz write white page

Q: V₁4-120 V₁2120 2₁ Z₁ Ic Three-phase source Feeder lines Balanced load In the above circuit diagram,…

Q: combinations of identical resistors. Rank in order, from largest to smallest, the equivalent…

Q: h(n) = (0.2)n-1 u(n) and x(n)= (0.4)"+1 u(n) Find: 1. Output response y(n) using linear convolution.…

Q: Q1- the primary voltage of transformer is 6600 V and the turn ratio equal 10.6. If the primary and…

Q: Q/ using Thevenin's theorem, find the current passing in the resistance 3 ohm ? 652 20V 452 2 A IA…

A: Steps to find Thevenin circuit To find the thevenin resistance, find the resistance across target…

Q: the 2 2 resistor if: v(t) = 50+ 40 sin(wt) + 30 sin(3wt - 30) + 25 sin(5m

A: The Given equation is vt=50+40 sinωt+30 sin3ωt-30+25 sin5ωt+30Voltit=30+20 sinωt+15 sin2ωt-20+10…

Q: Based on the circuit, where v(t) is the input, and v.(t) is the output. Answer the ff. R oooo v(t)…

Q: Q1) For the circuit shown in fig.(*), the supply current is i=10+ 4sin500t + 2sin1500t A Find the is…

Q: CONSIDERING THE RECTIFIER WITH CAPACITIVE FILTER BELOW AND V1 = 120V, 60 HZ WITH RELATION…

A: Rectifier shown is a single phase mid point type input voltage =V1=120 V, frequency f =60 Hz…

Q: A₂ - The Switch in the circuit shown in sig, has been in position (a) for a long time. At t == the…

Q: Example 5.3 A BPF is to be constructed using RC components that will only allow a of frequencies to…

A: In this question we will find values of the capacitors required for band pass filter....

Q: Problem 2 Find VR (t) for all time t. 4 V ΖΩ F: t=0 I t=0 7. 2 H ww VR202

A: In the above given question they have mentioned a second order system which consists of inductor,…

Q: Find V₂ (t) for all time t. 4 V ΖΩ ww √₁²=0 t=0 7 2 H + VR3202

A: Given:

Q: Use the mesh-current method to find the steady- state expression for v, in the circuit seen in Fig.…

Question

i need the answer quickly

At 50Hz operation a single phase transformer has eddy current loss of 100 W, Its eddy current
loss at 60Hz operation will be

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

All values of a transformer are proportional to its __________________ ___________________.
What is the purpose of the transformer in Figure 6.25?
For an ideal transformer, the efficiency is (a) 0 (b) 100 (c) 50
For an ideal 2-winding transformer, an impedance Z2 connected across winding 2 (secondary) is referred to winding 1 (primary) by multiplying Z2 by (a) The turns ratio (N1/N2) (b) The square of the turns ratio (N1/N2)2 (c) The cubed turns ratio (N1/N2)3
Match the following: (i) Hysteresis loss (a) Can be redud by constructing the core with laminated sheets of alloy steel (ii) Eddy current loss (b) Can be reduced by the use of special high grades of alloy stl as core material.
For a short-circuit test on a 2-winding transformer, with one winding shorted, can you apply the rated voltage on the other winding? (a) Yes (b) No
The symbol shown is a(n) a. iron core transformer. b. auto transformer. c. current transformer. d. air core transformer.
With the American Standard notation, in either a Y-or-Y transformer, positive- sequen quantities on the high-voltage side shall lead their corresponding quantities on the low-voltage side by 30. (a) True (b) False
Rework Problem 3.14 if the transformer is delivering rated load at rated secondary voltage and at (a) unity power factor, (b) 0.8 power factor leading. Compare the results with those of Problem 3.14. -
Two transformers rated at 100 kVA each are connected in an open-delta connection. What is the total output power that can be supplied by this bank?
The ratings of a three-phase three-winding transformer are Primary(1): Y connected 66kV,15MVA Secondary (2): Y connected, 13.2kV,10MVA Tertiary (3): A connected, 2.3kV,5MVA Neglecting winding resistances and exciting current, the per-unit leakage reactances are X12=0.08 on a 15-MVA,66-kV base X13=0.10 on a 15-MVA,66-kV base X23=0.09 on a 10-MVA,13.2-kV base (a) Determine the per-unit reactances X1,X2,X3 of the equivalent circuit on a 15-MVA,66-kV base at the primary terminals. (b) Purely resistive loads of 7.5 MW at 13.2 kV and 5 MW at 2.3kV are connected to the secondary and tertiary sides of the transformer, respectively. Draw the per- unit impedance diagram, showing the per-unit impedances on a 15-MVA,66-kV base at the primary terminals.
Using the transformer ratings as base quantities. work Problem 3.14 in per-unit.