At a certain elevation, the pilot of a balloon has a mass of 122.5 lb and a weight of 119 lbf. What is the local acceleration of gravity, in ft/s2, at that elevation? If the balloon drifts to another elevation where g = 32.05 ft/s², what is her weight, in lbf, and mass, in lb? What is the local acceleration of gravity, in ft/s²2, at that elevation? g= 31.25 If the balloon drifts to another elevation where g = 32.05 ft/s², what is her weight, in lbf, and mass, in lb? Fgrav = i m= i ft/s² 122.027 lbf lb

At a certain elevation, the pilot of a balloon has a mass of 122.5 lb and a weight of 119 lbf. What is the local acceleration of gravity, in ft/s2, at that elevation? If the balloon drifts to another elevation where g = 32.05 ft/s², what is her weight, in lbf, and mass, in lb? What is the local acceleration of gravity, in ft/s²2, at that elevation? g= 31.25 If the balloon drifts to another elevation where g = 32.05 ft/s², what is her weight, in lbf, and mass, in lb? Fgrav = i m= i ft/s² 122.027 lbf lb

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A gas with a density of 1.0 lb/ft3 weighs 4.0 lbf on the Moon, where the acceleration of gravity is 5.47 ft/s2.Determine its weight, in lbf, and volume, in ft3, on Mars, where g = 12.86 ft/s2.
1. The unit velocity head is a. ft-lbf/lbm b. ft-lb/sec c. ft-lbm/ft^3 d. ft-lbf/sec 2. Bernoulli’s equation describes a. kinetic energy balance in laminar flow b. mechanical energy balance in boundary layer c. mechanical energy balance in potential glow d. mechanical energy in turbulent flow 3. The continuity equation a. relates work and energy b. is only applicable to liquid c. relates masa flow rate along a stream tube d. stipulates that newtons second law of motion must be satisfied at every point in the fluid
NASA would like a rocket to accelerate upward at a rate of 125 ft/s2. The mass of the rocket is 35,000 lbm. Determine the upward thrust force, in lbf, that the rocket engine must produce
Given the lifting table shown below, The diameter of the plunger DP 20 cm. The ram diameter DR 60 cm , The efficiency is 100 %, The stroke of the plunger is 30 cm. The ram has to raise a load F2 = 20 kN. Find: a) The force F1 exerted on the plunger b) the number of strokes needed to raise the load given above by a distance of 10 cm . c) the volume of oil pumped if the load moves by 30 cm (using plunger force given in a ) d) What will be the new diameter of the ram piston if the new load force is 16 times the force exerted in the plunger the diameter of the plunger is kept to 20cm. (please check the picture carefully).
If the mass of an object is 10 lbm, what is its weight, in lbf, at a location where g = 32.0 ft/s2 ?
The force generated by a spring is given by F = kx, where k is the spring constant and x is the deflection of the spring. The spring of Fig. P1–99 has a spring constant of 8 kN/cm. The pressures are P1 = 5000 kPa, P2 = 10,000 kPa, and P3 = 1000 kPa. If the piston diameters are D1 = 8 cm and D2 = 3 cm, how far will the spring be deflected?
The following are extensive properties: mass, volume, pressure volume, energy, mass energy, mass, temperature mass, density, volume
A vertical piston-cylinder assembly contains 0.5 kg of water. Initially, the piston is resting against the stops when the water pressure and temperature are 1.00 bar and 100°C, respectively. The piston has a mass of 50 kg and face area of 0.01 m2; local atmospheric pressure is 1.01 bar; local gravitational acceleration is 9.81 m/s2 (5) What water pressure would be required to lift the piston from the stops? (3) Thinking about water as the system, is the system best described as open, closed, or isolated? Why? (3) Are changes in kinetic and potential energy negligible for the system in this case? Why? (5) How much heat transfer must occur to the water in order to begin to lift the piston from the stops? (2) Once the piston is lifted from the stops, will the water pressure change? Why? (5) Assuming that the water's pressure remains constant, find the work for the volume to double in kJ. Carefully indicate the direction (i.e., what is the work that you reported being done on or…
Question #1 a) The absolute pressure inside a tank is 0.13bar, and the surrounding atmospheric pressure is 98 kPa. A Bourdon gage is mounted in the tank wall to measure the pressure, in kPa? Is this a vacuum or gage reading? b) (967)kJ of heat is transferred from the system to the surroundings when a closed system of mass (28)kg undergoes a process. During the process, 200kJ work is done on the system. If the initial specific internal energy of the system is 300 kJ/kg, Describe the process and determine the final specific internal energy, in kJ/kg? Neglect changes in kinetic and potential energy.
Given the lifting table shown below , The diameter of the plunger DP 8 cm.The ram diameter DR 48 cm , The efficiency is 100 %, The stroke of the plunger is 18 cm. The ram has to raise a load F2 = 2 kN. Find : a) the force F1 exerted on the plunger b) the number of strokes needed to raise the load given above by a distance of 10 cm c) the volume of oil pumped if the load moves by 20 cm ( using plunger force in a ) d) What will be the new diameter of the ram piston if the new load force is 16 times the force exerted in the plunger the diameter of the plunger is kept to 8cm .
An air compressor piston displacement is 6,308 cm^3/min when operates at 964 rpm and volumetric efficiency of 75 %. Determine the capacity of air compressor in cm^3 per min.
The pressure from water mains located at street level may be insufficient for delivering water to the upper floors of tall buildings. In such a case, water may be pumped up to a tank that feeds water to the building by gravity. For an open storage tank atop a 300-ft-tall building, determine the pressure, in lbf/in² , at the bottom of the tank when filled to a depth of 20 ft. The density of water is 62.2 lb/ft³, g = 32.0 ft/s2 , and the local atmospheric pressure is 14.7 lbf/in²