At point A, a car is traveling along a curved road where the combination of tangential and normal acceleration generates an acceleration of 5m/s2 at a direction of 30 degrees with the radius. The velocity at point Ais 30 km/hr. What is the radius?

At point A, a car is traveling along a curved road where the combination of tangential and normal acceleration generates an acceleration of 5m/s2 at a direction of 30 degrees with the radius. The velocity at point Ais 30 km/hr. What is the radius?

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter1: Introduction To Statics

Section: Chapter Questions

Problem 1.19P: Plot the earths gravitational acceleration g(m/s2) against the height h (km) above the surface of...

See similar textbooks

Related questions

Q: A Given: The arm of the robot is extending at a constant rate ř = 1.5 m/s when r= 3 m, z= (4t2) m,…

A: Given Data r=3 cm R.=1.5 m/sz=4t2θ=0.5t Differentiate with respect to the time Z'=8t…

Q: Determine that the plane of the magnitude of W in the given figure so the an acceleration 200-1b…

Q: – plane 1. An object travels in "Yz experience an equation of motion given by a (t) = 8.10 프t2 i -…

A: Given data: The equation for acceleration is given as:Here t represents the time (a) So avg…

Q: At a given instant, the bottom A of the ladder has an angular acceleration of 4 ft/s2 and a velocity…

Q: Point k at end of the rod as in Fig. slides along the fixed path (x-y/30), where x and y in (mm). y…

Q: 6. Determine the trajectory equation of point P in Reference R and draw the trajectory when 0 = [0,…

Q: LQ1], The motion of a particle is "defined the position coordinates : by [x = t" - 3t+t], where…

A: Given Data⇒ Motion of particle is defined by : X=t4-3t2+t t=3 s

Q: At the instant shown, point B has a velocity of 5 to the right and accelerates at the rate of 12 m.…

Q: The acceleration of A is 3.5 m/s dovwnward and the acceleration of Cis 2.3 m/s upward. Find the…

Q: 1. A pulley has a constant angular acceleration of 3 rad per sec?. When the angular velocity is 2…

Q: The acceleration of A is 2.3 m/s? downward and the acceleration of Cis 3.2 m/s? upward. Find the…

Q: The rod AC can move frictionlessly through the sleeve B. The sleeve C travels frictionlessly along…

Q: 3. A race car enters the circular portion of a track that has a radius of 67 m. When the car enters…

A: Gien dataRadius of the track R = 67mSpeed of the race car V = 120km/hrIncreasing acceleration a =…

Q: Figure shown on the right is a crank and slider mechanis Link AB rotates on a counterclockwise…

A: Assume r=0 at t =0 Given: r˙ =4t2 θ˙ = 6 rad/s at t= 0.75 sec , find v and a dr/dt = 4t2…

Q: Two boats leave the shore at the same time and travel in the directions shown. Given that va = 5 m/s…

A: as per guideline i have to only three subpart of your question .

Q: 16 - 12 t + 4 t2 The slotted guides in the figure move according to the relations x = and y=2+15 t -…

A: There are two types of forces that are acting on a circular surface. One type of force is Radial…

Q: Specifically a dynamics problem. Question and diagram in pics below. Apparently the answers are…

A: The Instantaneous center of the ladder is shown below –

Q: The speed of the car at point A is 40 ft/s, and the acceleration a = 10 ft/s? acts in the direction…

A: Given Data a=10 ft/s2

Q: If a car is moving along a straight line road such that its position is described be the given graph…

A: Given data Time (t) = 12 sec Relationship S = t3

Q: (b) Figure Q1(b) shows a train travelling along a circular curve of a radius r= 300 m. At the…

Q: A particle which moves with curvilinear motion has coordinates in millimeters which vary with the…

Q: 2. The recreational vehicle shown in the figure below moves downward from point A by accelerating…

A: Here particle lies in x-y plane sb=40mx=30mAt point B- tangential at= (6-(0.06×30)) m/sec2=4.2…

Q: What is the direction of the normal acceleration of point A on (b) the turbine blade? Write down the…

Q: (Use absolute motion analysis) At the given instant the slider block A is moving toward the right…

Q: Q2) The bent flat bar rotates about a fixed axis through point O. The angle can be found at any…

Q: The cart has a velocity of 4 ft∕sec to the right. Find the magnitude of velocity on point "B" on the…

Q: 3. If a particle is traveling at a constant velocity V = 20 m/s around and has an acceleration of a…

A: Given data Velocity (v) = 20 m/s Acceleration (a) = 10 m/s2

Q: Six acceleration vectors are shown for the car whose velocity vector is directed forward. For each…

A: Given:- 6 acceleration vectors To Find:- Select correct description for the instantaneous motion…

Q: Figure Q1(b) shows a train travelling along a circular curve of a radius r= 300 m. At the instant…

A: Given: A train is traveling along a circular path with following details: Radius of circular path, r…

Q: 10 m/s a = 16 m/s² 300 mm 300 mm At the instant that 0= 70° rod AB is subject to a deceleration of…

A: Given data: ◆ The deceleration of link AB: a = 16 m/s2 ◆ The velocity of the link AB: v = 12 m/s ◆…

Q: (c) Find the acceleration of point B at the instant. (d) Determine the acceleration and angular…

Q: n the expression below, i, j, and k are mutually perpendicular unit vectors having directions fixed…

Q: The mechanism is used to convert the constant circular motion of rod AB into translating motion of…

A: For the given mechanism the following relation can be written.

Q: At a given instant, the gear rack on the left has a velocity of 4.5 ft/s and is accelerating at 1.8…

Q: The angular acceleration of a rotating body is defined by the relation A = - kθ. Determine a) the…

A: Given:Relation,A=-kθ

Q: Figure Q1(b) shows a train travelling along a cireular curve of a radius r= 300 m. At the instant…

A: Given:r=300 mω=0.03 rad/sα=0.0015 rad/s2

Q: For the body shown. At the instant shown, point B moves in straight line in x positive direction…

A: Given data: The velocity of point B is vB=11i cm/s. The acceleration of point B is aB=6i cm/s2. The…

Q: At a given instant the bottom A of the ladder has an acceleration aA = 3.2 ft/s2 and velocity vA =…

A: Acceleration at A = 3.2 ft/s2 Velocity at A = 6.4 ft/s

Q: The right-angle bar rotates clockwise with an angular velocity which is decreasing at the rate of 4…

A: Angular velocity is 2 rad/sec Decreasing angular acceleration is 4 rad/s^2

Q: The bent flat bar rotates about a fixed axis through point O. The angle can be found at any instant…

Q: At a given instant, a wheel is rotating with an angular velocity, m = 3 rad's and angular…

Q: speed at à cO a) the velocity of the car at point C b) the radius of curvature at point C c) the…

Q: Set up the relative acceleration equation between points A and B. The angular velocity is given. -4…

A: For solution refer below images.

Q: P16-3. Set up the relative acceleration equation between points A and B.The angular velocity is…

A: The acceleration equation between A and B is aB=aA+aB/At+aB/An Here, aAis the acceleration of point…

Q: Question: At The Instant QA = 5 Rad/S, Pulley A Is Given A Constant Angular Acceleration A = 6…

A: The angular velocity of the pulley A after 2 revolutions can be determined as,

Q: For the body shown. At the instant shown, point B moves in straight line in y positive directi with…

A: There are two types of accelerations that are acting on a circular surface. One type of acceleration…

Q: igure Q1(b) shows a train travelling along a circular curve of a radius r = 300 m. At the instant…

A: To determine the magnitude and direction of acceleration of train.

Q: (ouga.) Block A is accelerating upward at a constant rate of 2 m/s and moving downward at 5 m/s at…

A: The velocity of Block B is 20 m/s (upwards) and acceleration of Block B is 8 m/s2 (downwards).

Q: At a given instant, the slider block A has the velocity and acceleration as shown in figure. find…

A: Given Data VA=6 m/s aA=2m/s2 rB/A=3(cos45i+sin45j)=2.12i+2.12j

Question

100%

Kindly show complete solution for comparing to my answers. Thanks!

At point A, a car is traveling along a curved road where the combination of tangential and normal
acceleration generates an acceleration of 5m/s2 at a direction of 30 degrees with the radius. The
velocity at point Ais 30 km/hr. What is the radius?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The speed of the car at point A is 40 ft/s, and the acceleration a = 10 ft/s’ acts in the direction shown in the figure. WHAT IS THE TANGENTIAL COMPONENT OF THE ACCELERATION? WHAT IS THE RADIUS OF CURVATURE OF THE PATH?
Give me right solution A truck with a constant velocity of 100 mph moves along a curve line of y= 0.008x2 when the trucks horizontal coordinate reach 350m. Determine the acceleration components, its resultant, the normal and tangenial acceleration, and the radius of the curve when the truck is at x= 350m
A particle starts to move along a circular path whose centre atorigin and its radius is (1) m. The particle starts from rest from theright intersection of circle with x axis counter clockwise with anacceleration of ( o.25 m/s2) for (4 s) after that velocity remainsconstant. Find velocity and acceleration of particle after (12s). Howmany revolutions is done by particle along the circle at this time.
Please include explanation. The car has a forward acceleration of a= 4.888m/s2 without slipping its 647-millimeter diameter tires. Determine (a) the velocity v of the car when point P at the tire (corresponding to theta= 48 degree as shown) has zero horizontal component of acceleration. Also, compute for (b) the total acceleration at point P. NOTE: Use purely RMA Method for velocity and acceleration calculations.
R(t) = 2 sint i + 2 cos t j + 2t k find tangential and normal components of acceleration. find direction when t= pie/2
find an acceleration of the center of the beam (marked as a blue point) which is connecting both wheels , if it is known that linear velocity ot the wheels v=100km/h, r=0,8m and the distance drom the center of the wheel and the pont where the beam is connected (marked as red red distance)=0,4m, there is no slipping between wheels and the ground
Find the angle between the velocity and acceleration vectors at t=2s and t=5s of the moving part with respect to the position vector R= (2t3 -5t2 )i-(4t4 )j in the plane.
A car moving with constant speed from point A and sinks to point B of the hump. The radius of curvature of the road at point A is KA=120m and acceleration at A is 0.5g. Determine the car speed V if at point B acceleration is limited to 0.3g. Find the minimum radius of curvature ( Kb) of road at point B.
The y-coordinate of a particle in curvilinear motion is given by y = 4.5t3 - 5.9t, where y is in inches and t is in seconds. Also, the particle has an acceleration in the x-direction given by ax = 9.6t in./sec2. If the velocity of the particle in the x-direction is 12.9 in./sec when t = 0, calculate the magnitudes of the velocity v and acceleration a of the particle when t = 1.4 sec. Construct v and a in your solution.Answers: When t = 1.4 sec,
If a car is moving along a straight line road such that its position is described be the given graph as shown in figure. Find the acceleration at t= 12 sec. at (0
In the expression below, i, j, and k are mutually perpendicular unit vectors having directions fixed in a frame of reference. Vector vP is the velocity of point P moving in the frame; t is the time measured in seconds. Determine the acceleration aP at time t = 2 s for the velocity expression given.
Q2B=1in;BC=3in.; ω2=1rads,constant. Find the absolute linear acceleration for point C. Hint: for constant angular velocity, angular acceleration is zero. Using semi-graphical approach