(b) A horizontal pipe has a sudden expansion from diameter 8 cm to diameter 16 cm as shown in Figure Q2(b). The velocity and pressure of the water in the inlet of sudden expansion is 10 m/s and 410 kPa respectively. Based on Table 2 and setting given to you, determine the pressure at the outlet of the sudden expansion. D = 8 cm Water D = 16 cm %3D 10 m/s 410 kPa Figure Q2(b) Table 2 : Setting of Question Setting Temp Density Dynamic Viscosity (Pa.s) 0.001518 |(kg/m³) 5 999.97 (°C) 1 10 999.70 0.001306 3 15 999.10 0.001138 4 20 998.21 0.001002 5 25 997.05 0.000890 30 995.65 0.000797 35 994.04 0.000719

(b) A horizontal pipe has a sudden expansion from diameter 8 cm to diameter 16 cm as shown in Figure Q2(b). The velocity and pressure of the water in the inlet of sudden expansion is 10 m/s and 410 kPa respectively. Based on Table 2 and setting given to you, determine the pressure at the outlet of the sudden expansion. D = 8 cm Water D = 16 cm %3D 10 m/s 410 kPa Figure Q2(b) Table 2 : Setting of Question Setting Temp Density Dynamic Viscosity (Pa.s) 0.001518 |(kg/m³) 5 999.97 (°C) 1 10 999.70 0.001306 3 15 999.10 0.001138 4 20 998.21 0.001002 5 25 997.05 0.000890 30 995.65 0.000797 35 994.04 0.000719

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Two chambers, Chamber 1 and Chamber 2 where pressure at chamber 1 p1=70 kPa, at chamber 2 the pressure p2 = 5kPa. There is an orifice between the two chambers with diameter of 6 cm, Cc= 1.00, Cv=0.95 and the head of the liquid(s=2.50) over the orifice is 1.80 m. Find the actual flow rate through the orifice. Include the free body diagram if needed. a.45 L/s b.15 L/s c.35 L/s d.25 L/s
Two chambers, Chamber 1 and Chamber 2 where pressure at chamber 1 p1=70 kPa, at chamber 2 the pressure p2 = 5kPa. There is an orifice between the two chambers with diameter of 6 cm, Cc= 1.00, Cv=0.95 and the head of the liquid(s=2.50) over the orifice is 1.80 m. Find the actual flow rate through the orifice.include your free body diagram.a.35 L/s b.25 L/s c.15 L/s d.45 L/s
A jet of water with velocity 35 m/s strikes a series of radial curved vane mounted on a wheel which is rotating at 200 rpm. The jet makes an angle 30° with the tangent to the wheel at inlet, and leaves the wheel with a velocity 5 m/s at angle of 140° to the tangent to the wheel at the outlet. The outer and inner radii of the wheel are 70 cm and 35 cm, respectively. Determine the work done per unit weight of water, in Newton-Meter per Newton.
A pipe has a diameter of 16 cm at section 1 and 10 cm at section 2. The pressure at section 1 is 200 kPa and section 2 is 6.0 m higher than section 1.When oil of density 800 kg/m3 flows at a rate of 0.03 m3/s, find the pressure at section 2. Select one: 148 kPa 153 kPa 161 kPa 158 kPa
A horizontal pipe has a sudden expansion from diameter 8 cm to diameter 16 cm as shown in Figure Q2(b). The velocity and pressure of the water in the inlet of sudden expansion is 10 m/s and 410 kPa respectively. Based on Table 2 and setting given to you, determine the pressure at the outlet of the sudden expansion.
A pump is 2.2 m above the water level in the sump and has a pressure of –20 cm of mercury at the suction side. The suction pipe is of 20 cm diameter and the delivery pipe is short 25 cm diameter pipe ending in a nozzle of 8 cm diameter. If the nozzle is directed vertically upwards at an elevation of 4.2 m above the water sump level, determine the elevation in meters, above the water sump level, to which the jet would reach. Neglect all losses. a.24.04 b.0.10 c.20.31 d.0.52
A fan running at 1480 rpm takes in 6 m^3/min of air at inlet conditions of P_1=950 mbar and T_1=15^0 C. If the fan impeller dimeter is 40 cm and the table tip air angle 20^0, determine the total pressure developed by the fan and the impeller width at exit. Take the radial velocity at the exit as 0.2 times the impeller tip speed. State the assumptions used.
2.4) A pipe discharges 142 lps of water into a reservoir at a point 1.85 m below the water surface. At point A the diameter is 25.4 cm and the center of the pipe is 1.25 m above the water surface. At the discharge end the pipe is 30.5 cm. If the head loss from A to the reservoir is 0.7 m, determine the pressure in A.
A Liquid fluid with a density of 1,750 kg/m3 from an elevated 2m open reservoir (P1=0 bars) flows before the pump at 7.5 m/s. The liquid fluid is pumped at an unknown final velocity to a 75 meter elevated tank with a pressure reading of 7.75 Bars. assuming Friction losses is 757.75J and the actual WORK of the pump is 1,933,400J. Calculate the power in HP if the pump's efficiency is just 75% and for every 1,000 kg of fluid per hour.
Here, air (105 kPa) at 37 degrees celcius is flowing upward in a 6cm diamater inclined duct, at a rate of 90 L/s. In this case the density of air is 1.1 kg/m3. The diameter of the duct reduces to 4cm through a reducer and a pressure charge occurs. This pressure change is measured by a water manometer. The elevation difference between the points where the two arms of the manometer are attached is 0.2 meters. What is the differential height between the fluid levels in the two manometer arms?
Water flows from a pressurized tank (in figure below), through a 10.0 cm diameter pipe, exits from a 5.0 cm diameter nozzle, and rises 5.0 m above the nozzle. Determine the pressure in the tank if the flow is steady, frictionless, and incompressible.
In a Francis turbine, the pressure gage in the turbine casing reads 394 kpa. The elevation above the tailrace to the center of spiral casing is 6 m. Velocity of water entering the turbine is 9 m/s. Determine the total velocity head.