b- At downstream section and when this nozzle is unchocking, as the cross sectional or decrease; a- At upstream section, as the cross sectional area decrease, the pressure area increase, the gas velocity will.... and gas temperature will c- A normal shock wave occurs at downstream section. As the back pressure increase ... the cross sectional area of this shock wave will and exit pressure will .....

b- At downstream section and when this nozzle is unchocking, as the cross sectional or decrease; a- At upstream section, as the cross sectional area decrease, the pressure area increase, the gas velocity will.... and gas temperature will c- A normal shock wave occurs at downstream section. As the back pressure increase ... the cross sectional area of this shock wave will and exit pressure will .....

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Air enters a converging- diverging nozzle at a pressure of 830 kPa abs and a temperature of 32°C. Neglecting the entrance velocity and assuming a frictionless process, find the Mach number at the cross-section where the pressure is 240 kPa abs.( for air: k = 1.4 R=287J/kgK)
A converging–diverging nozzle with a 4:1 exit-area ratioand p0 = 500 kPa operates in an underexpanded condition as in Fig. The receiver pressureis pa = 10 kPa, which is less than the exit pressure sothat expansion waves form outside the exit. For the givenconditions, what will the Mach number Ma2 and the angleϕ of the edge of the jet be? Assume k = 1.4 as usual.
If there are no shock waves and the pressure at one ductsection in Fig. is 55.5 kPa, what is the velocity atthat section?(a) 166 m/s, (b) 232 m/s, (c) 554 m/s, (d ) 706 m/s,(e) 774 m/s
The reservoir pressure and temperature for a convergent-divergent nozzleare 5 atm and 520◦R, respectively. The flow is expanded isentropically tosupersonic speed at the nozzle exit. If the exit-to-throat area ratio is 2.193,calculate the following properties at the exit: Me, pe, Te, ρe, ue, p0,e, T0,e.
A convergent-divergent nozzle with an exit-to-throat area ratio of 1.616has exit and reservoir pressures equal to 0.947 and 1.0 atm, respectively.Assuming isentropic flow through the nozzle, calculate the Mach numberand pressure at the throat.
Air flows isentropically in a converging-divergingnozzle with a throat area of 3 cm2. At section 1, the pressureis 101 kPa, the temperature is 300 K, and the velocityis 868 m/s. (a) Is the nozzle choked? Determine(b) A1 and (c) the mass flow. Suppose, without changingstagnation conditions or A1, the (flexible) throat isreduced to 2 cm2. Assuming shock-free flow, will therebe any change in the gas properties at section 1? If so,compute new p1, V1, and T1 and explain.
Air, from a reservoir at 350 K and 500 kPa, fl ows througha converging–diverging nozzle. The throat area is 3 cm2. Anormal shock appears, for which the downstream Machnumber is 0.6405. (a) What is the area where the shockappears? Calculate (b) the pressure and (c) the temperaturedownstream of the shock.
The converging-diverging nozzle of the engine of a new supersonic unmanned aerial vehicle (UAV) has an exit area of 50 cm^2 . At the design operating condition, the mass flow rate of exhaust gases (? ≈ 1.4, molecular weight = 26 g/mol) is 1.75 kg/s. The exhaust gases enter the nozzle with stagnation pressure and temperature equal to Po = 300 kPa and To = 500 K, respectively a) What is the optimal cruising altitude for the operation of the nozzle of this UAV? (b) What is the lowest altitude at which the plane can fly such that the flow inside the diverging part of the nozzle is kept supersonic? Note: - Assume that the stagnation conditions of the flow of exhaust gases entering the nozzle are kept constant with varying altitude
Air flows steadily from a tank through the pipe inFig. . There is a converging nozzle on the end. Ifthe mass flow is 3 kg/s and the nozzle is choked, estimate(a) the Mach number at section 1 and (b) the pressureinside the tank.
Air flows through a converging–diverging nozzle betweentwo large reservoirs, as shown in Fig. A mercurymanometer between the throat and the downstream reservoirreads h = 15 cm. Estimate the downstream reservoirpressure. Is there a normal shock in the flow? If so, does itstand in the exit plane or farther upstream?
Air flows into a converging duct, and a normal shock stands at the exit of the duct. Downstream of the shock, the Mach number is 0.54. If p2/p1 = 2, compute the Mach number at the entrance of the duct and the area ratio A1/A2.
The stagnation pressure after the normal shock wave in a diverging nozzle (pi= 170 kPa, Mi= 2.4, Ax ⁄ Ai = 2.0)