(b) Determine (i) the pressure gradient, (ii) the shear stress at the two horizontal parallel plates, and (iii) the discharge per meter width for the laminar flow of oil with a maximum velocity of 1.5 m/s between two horizontal parallel fixed plates which are 80 mm apart. Take viscosity of oil as 1.962 Ns/m2.

Q: The discharge of a fluid is 0.80 L/s in a 100 mm diameter pipe. Determine the type of flow if the…

A:

Q: B1. A crude oil of specific gravity 0.85 is flowing through a pipe of diameter 325 mm and the…

A: The head loss in a pipe is given by - hL=4flv22gd, where f is friction coefficientl is length…

Q: Determine the head loss due to a sharp-edged pipe inlet if water is flowing 27.7 ft/s.

A: Given Data V=27.7 ft/s=8.44 m/s

Q: A venturimeter is inserted in a 150 mm diameter pipe carrying an oil of sp.gr. 0.85. If the…

A: GIVEN DATA - A VENTURIMETER GIVEN D=150mm Q=80 lit/s =0.08m3/s Cd=0.97 x=0.25 WE HAVE TO CALCULATE…

Q: Castor oil flows through 100 m of 4-nominal, schedule 40 cast-iron pipe. Determine the pressure drop…

A:

Q: C. A horizontal pipe of diameter d, at pressure P1 carries water which has a constriction of…

A:

Q: Determine the pressure drop per 100-m length of horizontal new 0.30-m-diameter cast iron water pipe…

A:

Q: (a) Prove that the loss of pressure head for the viscous flow through a circular pipe is given by h.…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: The parabolic velocity profile in a fully developed laminar flow in a pipe is given by the following…

A: Given: The velocity profile in a fully developed laminar flow is given as : u(r)=-R24μdPdx1-r2R2

Q: the ratio of the shear flow developed ineach tube. Answer:

A:

Q: A piston contains a type of fluid that has a S.G of 0.9 and a dynamic viscosity of 0.02 Poise. The…

A:

Q: The ethanol solution is pumped into a vessel 25 m above the reference point through a 25 mm diameter…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: An oil of viscosity µ poise and sp. gr. is flowing through D mm diameter horizontal pipe o length L…

A: Given Data: Dynamic Viscosity μ=0.02 Poise 1 Poise =0.1N-secm2 μ=0.002N-secm2 Specific gravity s=0.8…

Q: In a pipe of 90mm diameter water is flowing with a mean velocity of 2 m/s and at a gauge pressure of…

A:

Q: nswwer with diagram and complete solution: Establish the shear stress profile, velocity profile,…

A: Given: for a non Newtonian incompressible fluid  Length of pipe = L Diameter of pipe = D at the…

Q: Carbon dioxide with a dpecifuc weight of 0.114lb/ft3 and a dynamic viscosity of 3.34 x 10^-7lb*s/ft2…

A: Given data: w=0.114 lb/ft3μ=3.34×10-7 lb.s/ft2Q=200 ft3/min=3.333 ft3/s Need to determine the value…

Q: Glycerin at 20 °C flows upward in a vertical 75-mm-diameter pipe with a centerline velocity of 1.0…

A:

Q: Water with a viscosity of p=0.031 kg/m.s and density =1000 kg/m is to be siphoned through a tube 30…

A: GIVEN :- viscocity of water : μ=0.031kg/m.sdiameter of tube : D=1.5 mmdensity of water :…

Q: In a hydroelectric power plant, water at 20°C is supplied to the turbine at a rate of 0.55 m³/s…

A: Let us assume that flow is incompressible with steady flowrate. Disregarding the minor losses…

Q: A piston contains a type of fluid that has a S.G of 0.9 and a dynamic viscosity of 0.02 Poise. The…

A: Given question belongs to subject Fluid Mechanics and can be solved using Continuity equation.…

Q: DETERMINE THE PRESSURE TO HAVE A DISTANCE: 600m CONSISTENT AND COMPATIBLE FLOW RATE Raver ELEVATION:…

A: Given: Total length of the pipe: →L=600 m Height of the water tank from the river surface: →H=100 m…

Q: A straight pipe has a daimater of 25 mm, a roughness height of 0.1 mm, and is inclined upward at and…

A: Write the properties of water at 10°C. Draw the diagram of the pipe. From the diagram,

Q: Water flows at a rate of 0.185 m3/s through a 150 m long galvanized steel pipe of diameter 200 mm.…

A:

Q: Q:- Prove that the angle of inclination of two fixed parallel plate as shown in fig, so that laminar…

A:

Q: Vater with a viscosity of p=0.029 kg/m.s and density =1000 kg/m is to be siphoned through a tube 30…

A:

Q: Determine the pressure gradient (dp/dx) along flow, the average velocity, and the discharge for an…

A: Given information Width W =1 m, B=0.01 m

Q: Determine the surface tension (N/m) in a tube with 0.2m radius and wetting angle 0° and capillary…

A: The solution of given problem is provided by considering the capillary rise in 'm' and 'mm', because…

Q: Consider the steady laminar flow of water at 25°C through the piping system shown below. (a) Derive…

A:

Q: Question3 Explain briefly what is meant by fully developed laminar flow. The velocity u at any…

A:

Q: . In a pipe of 90 mm diameter water is flowing with a mean velocity of 2 mis at a gauge pressure of…

A:

Q: Oil that has a density of 880 kg/m3 flows under a head of 30 m. The pipe that the oil flows through…

A:

Q: Determine the volume flow rate in m lhr of water through a pipe of 115 mm diameter when measured by…

A:

Q: Kerosene of relative density 0.82 and kinematic viscosity 2.3 mm2 . s−1 is to be pumped through 185…

A: As per question, relative density,ρ=0.82 kinematic viscosity, ν=2.3× 10-6 m2/s Length of pipe,…

Q: F- In a circular pipe of diameter 100 mm a fluid of viscosity (7) poise and sp. gr. 1.3 is flowing.…

A: Reynold's number is the ratio of inertia force and viscous force. It is a dimensionless number used…

Q: A horizontal pipe line 40 m long is connected to a water tank at one end and discharges freely into…

A:

Q: Water with a viscosity of u=D0.004 kg/m.s and density =1000 kg/m is to be siphoned through a tube 30…

A: Let us assume the free surface of water in tank as state 1 and the end of the siphon where water…

Q: (b) Describe, with the aid of a labelled diagram, the Pitot-static tube and ex- plain how it may be…

A:

Q: When 0.042 m3 /s of medium fuel oil flows from A to B through 1067 m of new 150-mm uncoated cast…

A: Given:Volume flow rate,Q=0.042 m3/sD=150 mmhead lost, hL=44 mPressure:pB=345 KPazA=0 mzB=18.3 m

Q: Question : SAE 30 oil at 20°C flows in the 3.5-cm-diameter pipe, which slopes at 37°. For the…

A: Let the density of SAE 30 oil be ρ=890kgm3 and g=9.81 ms2. The viscosity for given oil is μ =0.29…

Q: arrying water (p kg/m³; stokes) has of average height of 0.1 mm. If the shear stress develo ermine…

A:

Q: Q2 Oil with a density of 850 kg/m³ and kinematic viscosity of 0.00062 m²/s is being discharged by a…

A:

Q: Water flow at a 250mm diameter horizontal pipe 90m long. The friction factor is 0.023. If the…

A: Given data:

Q: Density of oil = 900kg/m3 kinematic coefficient of viscosity ν = 0.00001m2/s  fluid flows at qv = 0.…

A:

Q: to solving these problems: 1. For this siphon the elevations at A, B, C, and D are: 30 m, 32 m, 27…

A: Guage Pressure: The pressure that is measured relative to the atmosphere is known as gauge pressure.…

Q: Rainwater flows through the galvanized iron downspout shown in the figure below at a rate of 0.010…

A:

Q: 4. Oil with viscosity 2 x 10-2 Ns/m2 and density 850 kg/m³ is pumped along a straight horizontal…

A:

Q: e diameter of an open-topped tank 1.5 m high increases uniformly from 4.2 m at th se to 6 m at the…

A: As per guidelines we need to answer only first question

Q: Qs: If viscous effects neglected and the tank is large, determine the flowrate from the tank shown…

A: find the flow rate from the tank.