b) Find the capacitance of a parallel plate capacitor if the area of each plate is0.1 m² and the distance between the plates is 2 mm. The dielectric is oil(Co=8.854 x 10-12 F/m)with a relative permittivity of 5.

Given data: A=0.1 m2d=2 mm= 0.002mk=5

b) Find the capacitance of a parallel plate capacitor if the area of each plate 0.1 m² and the distance between the plates is 2 mm. The dielectric is oil (Co=8.854 x 10-12 F/m) with a relative permittivity of 5.

b) Find the capacitance of a parallel plate capacitor if the area of each plate 0.1 m² and the distance between the plates is 2 mm. The dielectric is oil (Co=8.854 x 10-12 F/m) with a relative permittivity of 5.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 5PP: Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 -...

See similar textbooks

Related questions

Q: 6.11. In the two-bus system shown in Figure 6.24, bus 1 is a slack bus with V₁ = 1.020° pu. A load…

A: Solution- Bus 1 => slack busBus 2 => PQ buswe have 2 unknown V and phase angle at Bus 2,∂P2∂δ2…

Q: A dc series motor drives a load a 30rev/s and takes a current of 10A when the supply voltage is…

Q: A Watt (W) is defined as one Joule (J) of energy per second (s): 1 W = 1 J/s. It is also possible to…

A: Given, An electric car has 75 kWh battery. The car consumes on average 230 Wh/mile .

Q: Briefly explain about a) Primary transmission b) Secondary transmission c) Primary distribution d)…

A: Given: The two stages of transmission The two stages of distribution

Q: 5. For the system shown in figure. State the given system type also find steady state position error…

A: A system is carrying a feedback when the output from it's own circuit is passed to the input of the…

Q: Multiply the binary numbers 01001111 (multiplicand) and 00000101 (multiplier) by using the direct…

A: Since there are 3 different questions, in the following section, only the first question will be…

Q: R(s) + where G(s)-- 5+1 s²+45+5 the poies of the closed loop system are OA.1 and 4 B. None DC 2 and…

A: Given, A negative unity feedback system, Gs=s+1s2+4s+5

Q: 15 The unit of current is: (a) coulomb (c) volt (b) ampere (d) joule

Q: Two impedances Z1 = 10Ð45° and Z2 = 12Ð30° are in series across a voltage source. The total reactive…

Q: The full-scale deflecting torque of a 20 A moving-iron ammeter is 6 x 10-5 N-m. What is the rate of…

A: Given a moving iron ammeter having, Deflecting torque, τd=6×10-5 N.m Current, I = 20 A Rate of…

Q: In this network, the current source value is Is = 30 mA, while the resistances are R₁ = 100 2 and R₂…

A: Given, The network is Is=30 mAR1=100 ΩR2=550 Ω

Q: A resistance of 100 2 in series with a 20 µF capacitor is connected in parallel with a 0.3 henry…

Q: 8. Reduce the parallel subsystem below into its equivalent transfer function C(s) / R(s). X₁(s) =…

A: In this question we will find equivalent transfer function...

Q: Explain all the types of distance protection relays?

Q: Find the total energy stored in the circuit of Figure below 6Ω ww 4₁ = 2mH 301 42- <= 4 mH C₁ = 20…

A: We need to find out the energy stored for given circuit

Q: α (DC) for a transistor

A: BJT (bipolar junction transistor) A transistor having a three terminal made up of semiconductor…

Q: e) Calculate the noise margin for a logic gate with the following logic levels: VIL = 1.1 V, VIH =…

A: Bartleby has policy to solve only one question and its first 3 subparts. So reupload the question.

Q: A series motor has an armature resistance of 0.2 ohms and a series field resistance of 0.3 ohms. It…

Q: In the circuit below, what is the current through R1? R1 R2 10ohm Sohm RL V1 100ohm SV tole 0 11 12A

A: We need to find out the current for given circuit

Q: 5- Compare between the power transmitted in the (DSB-SC) and (DSB) if modulation index m-1.

A: Introduction - DSB is a shorthand for Double SideBand. DSB-SC is a shorthand for Double SideBand…

Q: In an ac transistor amplifier, the circuit includes capacitors as well as resistors. What is the…

A: We need to explain the role of capacitor in bjt amplifier

Q: a) The n-channel JFET and the D-MOSFET have very similar I-V output characteristics. Which of these…

A: a. n-channel JFET can be operated in enhancement mode. If JFET has a small doped channel that is…

Q: design a controlled single phase rectifier

A: Controlled single phase rectifier.

Q: a) The n-channel JFET and the D-MOSFET have very similar I-V output characteristics. Which of these…

A: 3. a. n channel JFET is an enhancement mode. Unlike MOSFET, JFET has a pre-made channel that can…

Q: What is the flux produced when a 2.5 A current flows through 500 turns coil wound in nonmagnetic…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 2. a. Find 11, 12, and Vs b. Find Va, Vb and Vc a 11 12v C + 1 ww 2002 ww 1502 Vs b 12 + 1 2 A www…

Q: 3. Explain where “sources” of error exist in this experiment. How could these sources of error be…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: S-2 The transfer function of a system G(s) = find the zero-input response, " s²-s-2 assume all…

A: Brief description: In the above given question we need to calculate the value of zero input response…

Q: What is the current in the 12- 2 resistor when a potential difference of 100 V is applied to the…

A: We need to find out the voltage across 12 ohms resistor for given circuit

Q: Q2:- a synchronous generator is 25 MVA, 11kV, it is star- connected with the neutral point solidly…

A: Given:X1=X2=0.2puX0=0.08puConsider power base is 25 MVA and voltage base is 11 KVVoltage PU = 1…

Q: Show that the group dispersion parameter, d'ßldo², for a given mode in a parallel-plate or…

A: We know,The first derivative equation is given by,dωdβ=cn1-ωcω2 -----AWhere,ω=Frequencyωc=Cutoff…

Q: A 8-stage impulse voltage generator is connected to a test object of load capacitance of 5000pF with…

A: Give information about an impulse voltage generator is, Number of stages N=8. Wave tail time…

Q: As depicted in Figure 9.1, a 3-phase A connected generator feeds a A connected load. The generator…

Q: Sketch the figure and explain in detail about the HVDC circuit breakers

A: Given: The objective is to give an explanation about the HVDC circuit breaker with the figure

Q: Find the impedance at w = 1 Mrad/sec of: a) a 2 kΩ resistor in parallel with a 1 mH inductor; b) the…

Q: the single-phase ac voltage controller has a 240 V rms 50 Hz source. The load resistance is 20002…

Q: Explain how poles and zeros are important in a feedback control system and t differences between…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Sketch v, for the network and determine the dc voltage available. 100 V Si Ge 4.7 ΚΩ 2.2 ΚΩ –100 V |…

A: The circuit diagram is shown below,

Q: The starting torque of a 25-hp 720-rpm synchronous motor is 150 per cent of its rated torque.…

Q: a) An MOS capacitor has a p-type silicon semiconductor substrate doped with an impurity…

A: It is given that: A MOS capacitor has a p-type silicon semiconductor substrate doped with an…

Q: LAPLACE AND INVERSE LAPLACE TRANSFORM. 1. L {t² sin 3t}

Q: A Watt (W) is defined as one Joule (J) of energy per second (s): 1 W = 1 J/s. It is also possible to…

A: Given, The battery rating of an electric car is, E = 75 kWh = 75000 Wh The car consumes on average…

Q: Two 220-V, 1-phase electrical furnaces take loads of 350 kW and 500 kW respectively at a power…

A: The transformer combination is shown below. K=2201100=150

Q: 30. The waveforms in Figure 6-81 are observed on the inputs of a 74HC151 8-input multiplexer. Sketch…

A: When enable(bar) input is low then the multiplexer works. If enable(bar) input is high then the…

Q: a) In a Bipolar Transistor define the quantity B or hFE- How is the device structure of the npn…

A: Transistor:- It is a semiconductor device that have three terminals. Its main function is switching…

Q: Determine the values of i2, 14, V2, V3, and V6 in Fig.(2). 6V 12 A 2VD the 3 A Fig(2)

A: In this question we need to find unknown voltage and current shown in the given circuit.

Q: Figure 9.2 R2 b 4. Referring to Figure 9.2, if the generator phase voltage is 230 volts and the load…

A: To solve this question we analysis the given system on per phase basis

Q: Consider the transmission line circuit shown in the accompanying figure. Compute the incident power,…

A: Transmission line is transfer the electricity from one place to another place. it is a long…

Q: 1. Find V1 and the power absorbed in the resistor 12 ohms by using thevenin theorems. 74.0 16.4 Ո…

Q: Q2/ Determine whether the following signals are energy signals, power signals or neither? (1)…

A: In this question, We need to determine the whether the given signals are energy or power signal?

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

b) Find the capacitance of a parallel plate capacitor if the area of each plate is
0.1 m² and the distance between the plates is 2 mm. The dielectric is oil
(Co=8.854 x 10-12 F/m)
with a relative permittivity of 5.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
4. In what form is the energy of a capacitor stored?
Assume that the current flow through the resistor, IR, is 15 A; the current flow through the inductor, IL is 36 A; and the circuit has an apparent power of 10,803 VA. The frequency of the AC voltage is 60 Hz. ET ER EL IT IR15A IL36A Z R XL VA10,803 P VARSL PF L
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
If Teflon material is placed between a parallel plate capacitor with each plate of 4 cm², what will be the maximum amount of charge accumulated on the capacitor?(Take K=2.1, Emax= 60x10^6 V/m.)
Determine value of capacitance of a spherical capacitor whose inner and outer radius are 2m and 4m respectively. Air medium.
#1Two metallic plates separated by 6.9 cm. If a plastic material is inserted between the plates of the capacitor completely filling the space, the capacitance becomes 4 times the original. Determine the dielectric constant of the plastic material.
A parallel-plate capacitor whose plates have area of 30 cm2 and 5 mm apart contains a medium with relative permittivity 3. What is the capacitance of the capacitor? Lütfen birini seçin: a. 18.75 pF b. 20.34 nF c. 15.93 p F d. 20.34 pF e. 15.93 nF
Design a spherical shell to give a capacitance of 40 pF. You can use an insulator having a dielectric constant around 3.5. The radius of out shell of the sphere may not exceed 40 cm Course: Electromagnetic Field Theory
Two conducting spherical shells have radii a= 2 cm (inner), and b= 5 cm (external). The interior is a perfect dielectric for which εR = 10. The value of capacitance between the two plates equals to
a) Compute the capacitance of a parallel-plate capacitor with plates 10 cm by 20 cm and separation of 5 mm if the dielectric are (i) an air dielectric, (ii) a ceramic dielectric with permittivity of 7500
Calculate the equivalent capacitance and accumulated charge on each capacitor and the total