B + จง R www чи Vout (+)

Q: Find the Power by the 4 k ohm's resistor.

A: In the given question we need to calculate the power absorb by 4k ohm resistor.

Q: The Mark Armor III of Tony Stark was damaged and required a little boost from the spare batteries he…

A:

Q: Please answer all subparts and in typing format please all subparts is compulsory

A: we need to write first order mathematical models for the given circuits.

Q: Three packages each of weight m = 14 kg A, B, and C are placed on a conveyor belt that is at rest.…

A: Given parametersPackages each of weight m=14kgCoefficients of friction

Q: An electric current flowing in a circuit (consisting of a battery ofV volts and a resistor of R ohms…

A: The objective of the question is to find the value of the constant 'b', derive a formula for the…

Q: A two-winding transformer rated at 9-kVA, 120/90-V, 60-HZ has a core loss of 200 W and a full-load…

A: The given data is shown below:

Q: 1. In the circuit below, find the expressions for the phasors I₁, 12 and 13. 100/0° V -j50 www 50…

A: The circuit diagram,

Q: For the circuit shown, find V1 & V2. 10Ω W 0000 10/0° + +j200 12 W V₂ 15 Ω 13 -j50

A: In this question, we need to determine the voltages V1 and V2 as shown in the circuit. We solve this…

Q: Solve the circuit by nodes (LCK) and find the function IR(s)/I(s) Please solve the system showing…

A:

Q: Part A Three capacitors, with capacitances C, 2.7 uF, C₂ = 4.7 uF, and C3=2.9 μF, are connected to a…

A: In this question, we need to determine the charge on the capacitor C2 .We know, charge on capacitor…

Q: 10 D 82 ми 5v лин + 8-2 10 T 4v find (vo) by using Super Postion

A: Given:a circuit,we need to find:the value of voltage V0 using superposition theorem.

Q: Given a = 3000, b = 3, c = 6, d = 3, e = 0.001, f = 3, g = 6, h = 1 and j = 4, in the circuit below…

A: The current Io in the given circuit and the ratio between the voltage needs to be calculated by…

Q: The equivalent circuit of a 22KVA, 11700/450 V, 60Hz, single-phase loaded transformer when referred…

A: The given data in the question are:The rated current on the secondary side is:The current given on…

Q: A magnetic core with an air gap is shown below. For a relative permeability is 3500, and the space…

A: In this question we need to find the reluctance of air gap.

Q: Problem 2: For the circuit shown in the figure find the following: a) The current (14) b) The…

A: The circuit diagram,

Q: Which one of the following statements is true: The total capacitance of several capacitors connected…

A: Given a set of statements and asked to identify the correct one.

Q: A series DC motor has a series-field winding of 25 turns per pole. Its armature resistance is 0.15…

A:

Q: + vit). ict) ict) = 0.5 sin 104 + (A) (+> to=0), C=0.1 [MF], UHH)=?

A: The current,The capacitance,

Q: plot is shownı Consider a stable system with rational transfer function H(s) whose pole-zero (a)…

A: The pole-zero diagram of a system is given by We need to determine:a) Whether the statement "the…

Q: Find the Power by the 4... resistor. 4... 12.00 6A ↑ 2 2 2000 2 12000

A:

Q: An RLC series circuit has a 2.00 Q resistor, a 130 µμH inductor, and an 82.0 uF capacitor. (a) Find…

A: The values of each element of series RLC circuit is,

Q: Find vo(t) in the circuit of Fig. 16.54 if v, (0) = 2 V and i(0) = 1A. 1F eu(t) A ΙΩ ΙΩ 1 H

A: The Laplace transform is a mathematical operation that converts a function of time into a function…

Q: If i¸ (t) -2 u(t) A in the circuit shown in Fig. 16.39, find the value of i,(t). io(1) i,(t) 1 H 202…

A: Given:a circuit,with we need to determine:the value of i0(t).

Q: Do the following addition and subtraction in 8-bit signed 2's complement. a. 19 - 15 = 10 b. 1915 10…

A: “Since you have posted a question with multiple sub parts, we will  provide the solution only to the…

Q: Find R: eq If three resistors of 2, 4, and 60 connected in series.

A: When resistors are connected in series, they form a single path for the current to flow through, one…

Q: Calculate 11, 12, and 13. The frequency is fixed at 500 Hz, and its output voltage magnitude to 5 V…

A: The circuit diagram,

Q: 1. Consider the raised-cosine pulse x(t) defined as x(t) = 0, (cos(wt)+1), -<t<; otherwise. (a) The…

A:

Q: 8. A thermostat for a central air system will control both a heating and cooling system. When a…

A: A thermostat for a central air system will control both a heating and cooling system. When a target…

Q: 5. In a three-phase circuit, if a fuse is lost and voltage is lost in phase 1, what must be true…

A: 5. In a three-phase circuit, if a fuse is lost and voltage is lost in phase 1, what must be true…

Q: 5. Assuming an operating frequency of 1 kHz, transform the following phasor expressions into a…

A:

Q: Prove that every circuit in Km,n has an even number of edges.

A: 1. Introduction:We aim to prove that every circuit (cycle) in the complete bipartite graph has an…

Q: . A systematic cyclic cod with generator Polynomial g(x) = x²+ x³+ 1 is used to protect data grouped…

A: According to the question,a) Using the encoder logic circuit, find the transmitted word for data…

Q: please answer  question 11 !!! thanks !!!

A: FINAL ANSWER:-         When the circular fringes collapsing to the centre then the mirror spacing is…

Q: Find the inverse Laplace transform of: 6s2 +8s +3 (a) F₁(s)= ss²+2s+5)

A: Given that,The objective is to find the inverse laplace transform for .

Q: 1.24 The voltage across a element varies with time as 5(t-2)² V. A current of 2 A enters the +ve…

A: In this question, we need to determine the power delivered to the element at  time t=0.8s.

Q: can you please explain how we do the d) section

A:

Q: Derive the Transfer Function of the following RC and RLC circuits: (Hint: Solve directly in the…

A: Given:a circuit,we need to derive transfer function assuming zero initial conditions.

Q: This is a practice question from the Signal and Systems course of my Electrical Engineering Program.…

A: I have solved in brief and provided the final answer. Explanation:

Q: A magnetic core with an air gap is shown below. For a relative permeability is 3500, and the space…

A:

Q: Q2) In the circuit shown in Fig.1, calculate the saturation current and the cut off voltage if…

A:

Q: Part A The two loads shown in (Figure 1) can be described as follows: Load 1 absorbs an average…

A:

Q: please show clear work

A: To solve this problem, we'll need to use semiconductor physics equations and concepts. Given the…

Q: 5002 ww ! A k=1 B jXX-1000 500 w A j25 B JXLI X22 -16 (100) -j25 www 2009 Select XL1 and XL2, so…

A:

Q: Please use MESH CURRENT Method in finding Va, I4, and Is. Give clear and proper step by step…

A: Va = 2 VI4 = -1 mAIs = 2 mAExplanation:

Q: The transistor question is included in the uploaded image:

A: By open circuit test we can  determine which transistor in ON and OFF. By KVL and KCL we can solve…

Q: In the circuit shown below, find Z for w=1000 rad/sec.

A:

Q: ₁(t) +5y1(t) - - 10[y2(t) − y₁(t)] = u₁(t) - 22(t) + 2(t) + 10[y2(t) − y₁(t)] = u₂(t)

A: Given the flowing diffrential equationdefine the state variables and derive the coefficient matrix…

Q: The characteristic table shown below contains two rows where the next state for A and B is incorrect…

A: The truth table for the XOR (exclusive OR) gate is as follows:ABoutput000011101110

Q: Using exactly seven (7) two-way MUX, implement the following function.  f(w, x, y, z) = Σm(0, 1, 3,…

A: minterms: 0, 1, 3, 7, 11, 13, 15Assigning each pair ofminterms into pairs sharing the same input…

Q: For AC circuits (with sinusoidal sources), we use the Phasor notation. Therefore, for passive…

A:

Fourier Series

Most of the incidents studied in the field of Engineering and Science as a function of time. For example, current and voltage are in the alternating current circuit. These occasional activities can be analyzed in the activity components (fundamental frequency and harmonics) through a process called Fourier analysis.