Please respond asap. b) The vapour pressure, p, of a gas varies with temperature as follows:1225T/Kp (Pa)127571001125117540014003280Evaluate the enthalpy of vaporization and also the vapour pressure of gas at 1250 K.

From the given data, lnP versus 1/T curves is drawn as shown below.

b) The vapour pressure, p, of a gas varies with temperature as follows: 1125 400 1175 1400 1225 1275 T/K Р (Рa) 3280 7100 Evaluate the enthalpy of vaporization and also the vapour pressure of gas at 1250 K.

b) The vapour pressure, p, of a gas varies with temperature as follows: 1125 400 1175 1400 1225 1275 T/K Р (Рa) 3280 7100 Evaluate the enthalpy of vaporization and also the vapour pressure of gas at 1250 K.

Physical Chemistry

2nd Edition

ISBN:9781133958437

Author:Ball, David W. (david Warren), BAER, Tomas

Publisher:Ball, David W. (david Warren), BAER, Tomas

Chapter7: Equilibria In Multiple-component Systems

Section: Chapter Questions

Problem 7.57E

See similar textbooks

Related questions

Q: Čalvin mixed 1.490 g of zinc with excess hydrochloric acid. The released hydrogen gas was collected…

A: Mass of zinc = 1.490 g Temperature T = 23oC = (273.15 + 23) K = 296.15 K Total pressure = 99.99 KNm2…

Q: Describe the changes that would be observed when water vapour at 1.0 bar and 400 K is cooled at…

A: SOLUTION: Step 1: Initial condition for water vapor: P = 1 bar, T = 400 K and is cooled to 260 K of…

Q: Q.9 a) Show that| (KrP – BT)V %3D KT = Isothermal compressibility B = volume expansivity b) The…

A: The enthalpy of vaporization can be defined as that minimum amount of energy that must be supplied…

Q: 4. The number of degrees of freedom (F) which a system containing C components can have when P…

A: Phase rule is very helpful in the determination of phase and component and degree of freedom

Q: What can be said about the boiling point and strength of the intermolecular forces of a chemical…

A: The temperature at which a liquid boils or the temperature at which the vapour pressure of a…

Q: Refer to the ternary phase diagram in Fig. 5E.4. How many phases are present, and what are their…

Q: Pressure was exerted with a piston on molten naphthalene at 95 °C. The vapour pressure of…

Q: An open vessel containing (a) water, (b) benzene, (c) mercury stands in a laboratory measuring 5.0 m…

Q: Naphthalene, C10H8, melts at 80.2 °C. If the vapour pressure of the liquid is 1.3 kPa at 85.8 °C and…

Q: Ethanol, CH3CH2OH, and dimethyl ether, CH3OCH3, have the same compositional formula, i.e, C2H6O.…

A: Ethanol, CH3CH2OH has lowest vapour pressure than dimethyl ether, CH3OCH3 .

Q: A polynomial fit to measurements of the total volume of a binary mixture of A and B isv = 778.55 −…

Q: 5.1 The normal boiling temperature of benzene is 353.24 K and the vapour pressure of liquid benzene…

Q: Carbon tetrachloride (CC14) has a normal boiling point of 75.38 °C, and an enthalpy of vapourization…

Q: What is the maximum number of phases that can be in mutual equilibrium in a two-component system?

A: Equilibrium is state in which rate of forward and backward reaction is same.

Q: The vapor pressure of liquid carbon tetrachloride, CCl4, is 15, 539 Pa at 290 K and 69,518 Pa at 340…

A: For liquid-vapour boundary ; lnP2P1 = ∆HvapR1T1 - 1T2 For solid-vapour boundary ; lnP2P1 = ∆HsubR1T1…

Q: The Clausius-Clapeyron equation is derived in Section 5.5 on thelassumption that the enthalpy of…

Q: the vapour pressure of Mandalore trioxide at (18.4) °C is (1.99x10^-1) bars, and at (79.3) °C is…

Q: The normal boiling point of hexane is 69.0 °C. Estimate (i) its enthalpy of vaporization and (ii)…

A: (i)

Q: The vapour pressure of a liquid in the temperature range 200–260 K was found to fit the expression…

A: 1) Temperature range 200–260 K 2) Expression ln(p/Torr) = 16.255 − 2501.8 /(T/K)

Q: The normal boiling temperature of diethyl ether, (C2H5)20, is 307.7 K and the standard enthalpy of…

Q: The variation of the vapour pressure of methylbenzene may be written as ln(p/kPa) = A - B/T, with A…

A: Given : ln(P) = A - BT where A = 17.17 B = 4713 K T = temperature in K And P = pressure in KPa…

Q: In the following balanced reaction: 2Al(s) + 6HCl(aq) → 2AlCl3(s) + 3H2(g) 2.32 g of Al react with…

A: Answer :- V = 3.35 (L) Volume of hydrogen gas produced by the reaction of 2.32 g of aluminum metal…

Q: solid compound of molar mass 100 g mol−1 was introduced into a container and heated to 400 °C. When…

A: Given: Mass loss = 285 mg = 2.85 X 10-4 Kg (since 1…

Q: At 10°C, the vapour pressure of a liquid substance is 6.83 x 10^-2 Pa. At 30°C, the vapour pressure…

Q: Vapour pressure is defined as the partial pressure of a gas in equilibrium with liquid. What is the…

A: 1) We would use Clausius Clapeyron equation to calculate the vapour pressure at 15°C . Note :…

Q: For liquid zinc, the measured vapour pressures at 627 °C and 977 °C are given as 9.5 x 10-3 atm and…

A: The Calcius Clapeyron equation to relate vapor pressure and temperature is given by ln(P2P1) =…

Q: (a) What is the difference between the states of phase equilibrium and metastability (b) Explain…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: In a one-component system, is the condition P = 2 represented on a phase diagram by an area, a line…

A: Here, We need to find the value of P. For this we have the formula; F=C-P+2 Where F is the degree…

Q: At 10 C, the vapour pressure of a liquid substance is 6.83 x 10-2 Pa. At 30C, the vapour pressure is…

Q: The vapour pressure of a liquid is represented by the equation log (P/Torr) =(−1625/?)+8.750 where…

A: Vapour pressure of the liquid at 23OC

Q: Calculate the difference in slope of the chemical potential against pressure on either side of (a)…

A: a) To calculate the difference in slope of the chemical potential against pressure on either side of…

Q: Use the following data to sketch a P-T phase diagram of sulfur dioxide (SO2): Tc = = 0.0167 bar =…

A: Given data

Q: Acetone has a vapour pressure of 53.3 kPa at 39.5 °C and 202.6 kPa at 78.6 °C. Estimate the…

Q: The vaporization of water is one factor that contributes to the raising of baked goods. When 1.0g of…

Q: The Clausius- Clapeyron equation on the assumption that the enthalpy of vaporization is independent…

A: Given details: a, Enthalpy of vaporization of water - 40.656 kJ mol-1 at normal boiling…

Q: 6. The vapour pressure of a liquid in the temperature range 200 K to 260 K was found to fit the…

A: This can be solved using Clausius-Claperyon equation. Clausius-Claperyon equation: In(P) =…

Q: Explain the significance of the Clapeyron equation and of the Clausius-Clapeyron equation.

A: Significance of Clapeyron equation and of the Clausius-Clapeyron equation has to be given,

Concept explainers

Applications of Molecular Spectroscopy

When light sources pass through the diffraction grating then light splits into different wavelengths. The light source produces two types of patterns that are shown as destructive and non-destructive. The light source is in the form of quanta that is quantitation.

Question

Please respond asap.

b) The vapour pressure, p, of a gas varies with temperature as follows:
1225
T/K
p (Pa)
1275
7100
1125
1175
400
1400
3280
Evaluate the enthalpy of vaporization and also the vapour pressure of gas at 1250 K.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

The vapour pressure of pyridine is 50.0 kPa at 365.7 Kand the normal boi ling point is 388.4 K. W hat is the enthalpyof vaporization of pyridine?
The pure vapour pressure of benzene (C6H6) is 745 torr; the pure vapour pressure to toluene(C7H8) is 290 torr. What is the mole fraction of benzene in a benzene/toluene mixture whose total vapour pressure is 500 torr? Give answer to 3dp.
The total vapour pressure of an ideal-dilute liquid mixture of acetone and chloroform with a mole fraction of acetone of 0.0500 is 45.08 kPa at 308 K. (a) Use Raou lt's law to determine the partial vapour pressure of acetone for the mixture, given that the vapour pressure of pure acetone is 46.26 kPa at 308 K. (b) Hence calculate the partial vapour pressure of chloroform for the mixture . (c) Determine the Henry's law constant of chloroform at this temperature.(d) The Henry's law constant is lower than the vapour pressureof pure chloroform at 308 K. What does this imply about the nature of the interactions between acetone and chloroform in the liquid mixture?
The vapour pressure of pyridine is 50.0 kPa at 365.7 K and the normal boiling point is 388.4 K. What is the enthalpy of vaporization of pyridine?
Consider a pure liquid in equilibrium with its vapor at constant temperature. a) write an expression relating the chemical potential of the liquid, u(l), and vapor, u(g). b) express u(g) in terms of the vapor pressure of the pure liquid, P.
The vapour pressure of mercury at 20 °c is 160 mPa; what is its vapour pressure at 40 °c given that its enthalpy of vaporization is 59.30 kJ mol-1?
Pressure was exerted with a piston on molten naphthalene at 95 °C. The vapour pressure of naphthalene when the applied pressure is 1.0 bar is 2.0 kPa. What is its vapour pressure when the pressure on the liquid is 15 MPa? The mass density of naphthalene at this temperature is 1.16 g cm−3.
What mass of H2 gas can be collected over water from a 250-mL flask at a temperature of 25ºC and a pressure of 105.325 kPa? (The vapour pressure of H2O at these conditions is 3.169 kPa.)
For a benzene (C6H6) toluene (C6H5CH3) mixture, at 120 °C, the following values are obtained for the total vapour pressures of the given mixtures:
Two substances A and B are known to form ideal liquid solutions. A vapour mixture containing50% (mol) A and 50% (mol) B is at 311 K and 101.3 kPa. This mixture is compressedisothermally until condensation occurs. At what pressure does condensation occur and what isthe composition of the liquid that forms? The vapour pressures of A and B are 142 kPa and 122kPa respectively.
The average of the enthalpy of vaporization of propanone, C3H6O, over the temperature range 280 to 340 K is 30.2 kJ mol-1. The vapour pressure is 30.600 kPa at 298.15 K.Estimate the normal boiling temperature of propanone.
The vapour pressure of dichloromethane at 24.1 °C is 53.3 kPa and its enthalpy of vaporization is 28.7 kJ mol−1. Estimate the temperature at which its vapour pressure is 70.0 kPa.